more, replace instrument cluster.
NO BUS BIAS
NOTE: For connector terminal identification and wiring diagrams,
see BODY CONTROL COMPUTER - INTRODUCTION article. Perform
VERIFICATION TEST VER-1 after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module
connector.
1) Disconnect scan tool. Turn ignition on. Using an external
voltmeter, measure voltage between ground and DLC terminal No. 3
(Violet/Brown wire). If voltage is not 1.8-2.3 volts, go to step 3).
If voltage is 1.8-2.3 volts, go to next step.
2) Measure voltage between ground and DLC terminal No. 11
(White/Black wire). If voltage is not 1.8-2.3 volts, go to next step.
If voltage is 1.8-2.3 volts, replace scan tool cable or scan tool.
3) Connect jumper wire between ground and DLC connector
terminal No. 11 (White/Black wire). Turn ignition off. Remove
instrument cluster. Using external ohmmeter, measure resistance
between ground and instrument cluster connector C1 terminal No. 9
(White/Black wire). If resistance is less than 5 ohms, go to next
step. If resistance is 5 ohms or more, repair open White/Black wire.
4) Disconnect jumper wire. Measure resistance between ground
and instrument cluster connector C1 terminal No. 9 (White/Black wire).\
If resistance is less than 1000 ohms, repair White/Black wire for
short to ground. If resistance is 1000 ohms or more, go to next step.
5) Connect jumper wire between ground and DLC connector
terminal No. 3 (White/Black wire). Measure resistance between ground
and instrument cluster connector C1 terminal No. 10 (Violet/Brown
wire). If resistance is less than 5 ohms, go to next step. If
resistance is 5 ohms or more, repair open Violet/Brown wire.
6) Disconnect jumper wire. Measure resistance between ground
and instrument cluster connector C1 terminal No. 10 (Violet/Brown
wire). If resistance is less than 1000 ohms, repair Violet/Brown wire
for short to ground. If resistance is 1000 ohms or more, go to next
step.
7) Turn ignition on. Using external voltmeter, measure
voltage between ground and instrument cluster connector C1 terminal
No. 2 (Dark Blue/White wire). If voltage is 9.5 volts or less, repair
open Dark Blue/White wire. If voltage is more than 9.5 volts, go to
next step.
8) Turn ignition off. Using external ohmmeter, measure
resistance between ground and instrument cluster connector C1 terminal
No. 4 (Black/Light Green wire). If resistance is 5 ohms or less, go to\
next step. If resistance is more than 5 ohms, repair open Black/Light
Green wire.
9) Measure resistance between ground and instrument cluster
connector C1 terminal No. 5 (Black/Orange wire). If resistance is 5
ohms or less, replace instrument cluster. If resistance is more than 5
ohms, repair open Black/Orange wire.
NO RESPONSE AIR BAG CONTROL MODULE
NOTE: For connector terminal identification and wiring diagrams,
see BODY CONTROL COMPUTER - INTRODUCTION article. Perform
VERIFICATION TEST VER-1 after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module
connector.
1) Remove and inspect fuse No. 19 from junction block.
