1999 AUDI TT ATW Engine Motronic Fuel Injection Syst

Page 41 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-37
       If pressure drops again:  
     
-  Check wire connections, O-rings at fuel 
distributor and fuel injectors for proper seal. 
     
-  Check whether pressure gauge is properly 
sealed.

Page 42 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-38
 
  
Fuel injectors, checking
 
Special tools and equipment  
 
VAG1526A
 VAG1527B
 VAG1594A
 VAG1598/31
Pa
ge 42 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:

Page 43 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-39
      
Checking internal resistance  
    
-  Remove engine cover (arrows).
-  Disconnect harness connector at the fuel injector to be tested.
    
If specified value is not obtained:  
If speci

Page 44 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-40
      
Checking voltage supply  
     
Test requirements: 
     
Fuse for fuel injectors OK 
     
       Electrical Wiring Diagrams, Troubleshooting & 
Component Locations   
     
Fuel Pump (F

Page 45 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst  Electrical Wiring Diagrams, Troubleshooting & Component Locations    -  Check wire connection between terminal 1 and fuse for injector valves 
for open circuit: 
Pa
ge 45 of 81 Motronic fuel in
jecti

Page 46 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-41
      
-  Repair open circuit if necessary.
      If LED lights up:  
     
-  Activation of fuel injectors, checking
     
Checking activation  
     
Test requirement: 
     
Internal resistan

Page 47 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-42
       If LED does not blink:  
     
-  Connect VAG1598/31 test box at wiring harness 
to Engine Control Module (ECM), do not connect 
ECM  Page 24
-19
 . 
    
If wire connection is OK:  -  Ch

Page 48 of 81

AUDI TT 1999 8N / 1.G ATW Engine Motronic Fuel Injection Syst 24-43
 
  
Fuel rail with fuel injectors, disassembling 
and assembling
 
1 - 
Fuel injector insert, 3 Nm 
Use fluid securing material D 000 600 A2 
to insert. 
2 - 
O-ring Removing and installing   P