13-33
Connecting rod and connecting rod
bearings, checking clearance
Notes:
Replace the connecting rods only as a set.
Do not interchange connecting rod bearings.
Checking radial clearance
CAUTION!
DO NOT turn the crankshaft or allow it to rotate while measuring with
Plastigage in place. - Mark connecting rod bearing caps with light center punch marks before
removing.
- Remove connecting rod bearing caps. Clean bearing shells and
journals.
-
Place Plastigage over entire width of bearing journal or bearing cap.- Install connecting rod bearing cap and tighten to 20 Nm (15 ft lb).- Remove connecting rod bearing cap again.
-
Compare width of Plastigage with calibrated scale.
Pa
ge 32 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
