46-40
Note:
On all-wheel-drive vehicles, the parking brake
cable adjusting components are located in front
of the lower rear control arms.
On front-wheel-drive vehicles they are located
in the tunnel on the underside of the vehicle.
- Remove locking component -D-.
- Counter hold hex -E- using 13 mm open end wrench and turn adjusting
nut -C- in to stop.
- Slide cable adjuster together (arrow -B-).
- Back off adjusting nut until slot for locking component is visible.
- Install locking component.
- Pull both cable sleeve adjusters apart evenly until cables are
tensioned.
While doing this, the lever must not lift off at the brake caliper.
- Remove screwdriver from compensator and apply parking brake firmly
3 times.
Pa
ge 5 of 6 Parkin
g brake lever, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.5
