1999 AUDI A4 oil pressure

15-53

- Loosen camshaft sprocket (counter hold with
3036).

- Remove camshaft sprocket.

- To guide oil seal extractor, thread securing bolt for camshaft sprocket -
arrow- into camshaft as far as it will go by hand.
- Adjust inner part of oil seal extractor 2085 two turns (approx. 3 mm)
from outer part and lock in position with knurled screw.

- Lubricate threaded head of oil seal extractor 2085, place it in position
and, exerting firm pressure, screw it into oil seal as far as possible.
- Loosen knurled screw and turn inner part of extractor against camshaft
until oil seal has been extracted.
- Clamp flats of oil seal extractor in vice. Remove oil seal with pliers.
Pa
ge 17 of 58 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.2

15-54

Installing

Note:
Do not oil sealing lip of oil seal.

- Place guide sleeve T10071/1 onto crankshaft journal.
- Push sealing ring via guide sleeve onto shaft journal.
- Remove guide sleeve.

- Press in sealing ring with pressure sleeve T10071/3 and bolt T10071/4.
Pa
ge 18 of 58 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.2

15-59


- Insert camshaft sprocket bolt 2085/1 by hand into camshaft as far as it
will go.
- Adjust inner part of oil seal extractor 2085 two turns (approx. 3 mm)
from outer part and lock in position with knurled screw.

- Lubricate threaded head of oil seal extractor 2085, place it in position
and, exerting firm pressure, screw it into oil seal as far as possible.
- Loosen knurled screw and turn inner part of extractor against camshaft
until oil seal has been extracted.
Pa
ge 23 of 58 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.2

15-61

Installing sealing ring with spring:

Note:
Do not oil sealing lip of oil seal.

All models: - Place guide sleeve 3241/2 onto camshaft journal.
- Slide oil seal over guide sleeve.

Tightening torques - Press in sealing ring with pressure sleeve 3241/1 as far as it will go. To
do this use bolt 3241/3.
- Install camshaft position sensor Page 15
-46
.
- Install toothed belt guard (upper section).
- Install lock carrier Page 13
-1 .
Component

Nm
Camshaft position sensor rotor to camshaft 25
Pa
ge 25 of 58 Valve
gear, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.2