1999 AUDI A4 AWM Engine Sealing Flanfes And Flywheel Drive Plate Workshop Manual

13-63

Installing
Installation is carried out in the reverse order or
removal; note the following:

- Replace bolts.

Tightening torque

Component

Nm
Dual-mass
flywheel 22.5 mm
1) 60 + 90
2)

on crankshaft
43 mm
1)
60 + 180

3)


1) Bolt length
2) 90 corresponds to a quarter turn

3)180 =
1/2 turn
Pa
ge 17 of 20 Sealin
g flan
ges and fl
ywheel/drive
plate, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.2

13-64

Drive plate

Special tools and equipment

Removing
Counter hold VW 558 Hex bolt M8 x 45 and two M10 hex nutsCaliper gauge or depth measure

- Secure counter hold tool VW 558 to drive plate with hex bolt M8 x 45 -
Item 2-. Place two M10 hex nuts between counter-hold tool and drive
plate.
- Mark position of drive plate relative to engine.
- Unbolt drive plate.
Pa
ge 18 of 20 Sealin
g flan
ges and fl
ywheel/drive
plate, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.2

13-65

Installing

- Place drive plate in position with shim -2- and washer -1-. Lug -arrow-
must face towards torque converter.
- Insert at least 3 old securing bolts and tighten to 30 Nm.

- Measure distance -a- at three points and calculate average value.
Specified value: 18.9 to 20.5 mm
Pa
ge 19 of 20 Sealin
g flan
ges and fl
ywheel/drive
plate, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.2

13-66
If nominal value is exceeded:

If specified value is attained:
Tightening torque 1) 90 corresponds to a quarter turn - Remove drive plate again and fit without shim -2-. Retighten bolts to 30
Nm.
- Measure distance again.
- Install new bolts and tighten.Component

Nm
Drive plate to crankshaft
60 + 90
1)

Pa
ge 20 of 20 Sealin
g flan
ges and fl
ywheel/drive
plate, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.2