01-175
Display
field Display on
VAG 1551 scan
tool Malfunction cause
Malfunction repair
2 Greater than
+14(HS)
and/or
greater than +
10(AT)
Idle Air Control (IAC) valve -N71- faulty
Electrical consumers on
Steering wheel at end stop
Driving mode selected (automatic transmission)
Intake manifold pump plugged in automatic transmission
EGR vacuum regulator solenoid valve -N18- open- Check DTC memory
page 01
-13
and/or display
group 018
- Switch electrical
consumers off
- Center steering wheel
- Move selector lever to P or
N
- Repair cause
- Check DTC memory
and/or display group 017,
display field 3
2 Less than -16
(HS)
and/or
less than -20
(AT)
Idle Air Control (IAC) valve -N71- faulty
Large air leak, manifold area, throttle stop not OK
Air leak on second stage of throttle - Check DTC memory
page 01
-13
and/or display
group 018
- Repair cause
3 Outside
tolerance range Only on vehicles with automatic transmission:
Display field 2 outside tolerance
If display field 2 is within tolerance, move selector lever to D Display field 2
- Check transmission
Pa
ge 245 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1
01-231
Display group 040 (Heating current of oxygen sensors in front of and behind three way catalytic converter) Display
shows Display specified value
Designation/diagnosis
Basic setting
40
1 2 3 4 At cold start, greater than 3 A after approx. 40 sec: 0.7 -
1.0 A 1 = Heating current, bank 1, heated oxygen
sensor 1
2 = Heating current, bank 2, heated oxygen
sensor 1
At cold start, greater than 3 A after approx. 80 sec: 1.2 -
1.4 A 3 = Heating current, bank 1, heated oxygen
sensor 2
4 = Heating current, bank 2, heated oxygen
sensor 2 Notes:
The current values specified apply only at when battery positive voltage (B+) is 12-14 volts display group 001, display
field 4. The heating of the heated oxygen sensors in front of the three way catalytic converter is switched on with the fuel pump
relay, i.e. immediately at engine start.
The heating of the heated oxygen sensors behind the three way catalytic converter is not switched on immediately at
engine start, but only when the calculated exhaust gas temperature in the three way catalytic converter exceeds 308 C
(586 F) display group 044, display field 2. In order to reach an exhaust gas temperature of 308 C (586 F) in the three
way catalytic converter after a cold start, the car must be driven about 20 sec. with an increased engine speed of 2500
RPM.
Pa
ge 325 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1
01-243
Display group 045
Notes:
Display group 045 is only assigned on vehicles with tank diagnosis.
Vehicles with EVAP system/tank diagnosis can be recognized by Diagnostic Pump for Fuel System -V144-.
Display shows
Display/specified value
Designation
Basic setting 45
1 2 3 4 -------- --------------------------------------
-------- --------------------------------------
-------- --------------------------------------
-------- --------------------------------------
Pa
ge 339 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1
