39-77
Drive flange/driveshaft radial
deviation, measuring and
identifying
Special tools and equipment
VW38 universal measurement bracket
2024A engine sling
Dial indicator
Bolt M10 x 85
Notes:
Radial deviation must always be measured,
when the torque tube is removed. Apply a new
color marking and remove the old one.
If a new driveshaft is installed and the color
marking on the drive flange of the final drive is
no longer visible, the location of the largest
radial deviation must be determined and
identified with a color marking.
This color marking is then matched with the
color marking on the driveshaft Page 39
-74
.
Pa
ge 1 of 8 Drive flan
ge/driveshaft radial deviation, measurin
g and identif
ying
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.9
39-83
Installation is the reverse of removal, note the
following:
- Align exhaust system free of stress.
Repair Manual, Engine Mechanical, Repair
Group 26
Tightening torques
Component
Tightening
torque
Center bearing to body 23 Nm (17 ft
lb)
Front cross-member below
exhaust system to body
25 Nm (18 ft
lb)
Nuts on exhaust pipe clamp 40 Nm (30 ft
lb)
Pa
ge 8 of 8 Drive flan
ge/driveshaft radial deviation, measurin
g and identif
ying
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.9
