34-39
Cover with Torsen differential,
removing and installing
Transmission installed
Special tools and equipment
3337 ring spanner 7-piece set (only for vehicles
with 6-cylinder engine)
VAG1306 drip tray
Removing
4-cylinder engine
- Remove rear section of exhaust system
(rearward of exhaust pipe clamp).
Repair Manual, Engine Mechanical, Repair
Group 26
6-cylinder engine
- Remove Heated Oxygen Sensor (HO2S) from
right exhaust pipe using 3337 ring spanner 7-
piece set, and move clear to side.
- Remove heat shield above right drive axle.
Pa
ge 1 of 4 Cover with Torsen differential, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.4
34-42
Installing
Install in reverse order of removal, note the
following:
- Clean sealing surfaces and coat with AMV 188
000 02.
Repair Manual, Engine Mechanical, Repair Group 26
Tightening torque - Make sure dowel sleeves for Torsen differential cover -A- are installed
in transmission cover -B- (arrows).
- Install compression spring -C- over drive pinion onto hollow shaft
- Install driveshaft Page 39
-71
.
- Check oil level in transmission and top up if necessary Page 34
-38
.
- Align exhaust system free of stress.Component
Tightening
torque
Cover with Torsen differential to transmission 25 Nm (18 ft lb)
Driveshaft to transmission 55 Nm (41 ft lb)
Heat shield for driveshaft to Torsen differential
cover 25 Nm (18 ft lb)
Pa
ge 4 of 4 Cover with Torsen differential, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.4
