1998 VOLVO V90 ignition

1998 Volvo S90
Headlights and parking lights

All lights off *

Parking lights on **

Headlights and parking lights are on if
starting (ignition) switch is in position I or II. If
the headlight switch is in position
all lights
will go out when starting switch is switched off.
With the headlight switch in position
the
parking lights will stay on (headlights off) with
the daytime running light switch (A) in position
.
The high beams can only be switched on if the
headlight switch is in position
.
Switch from high to low beams, and vice versa,
by moving the turn signal switch lever on the left
side of the steering column towards the steering
wheel.
*Models equipped with daytime running lights:
The low beams, tail lights, parking lights and
license plate lights will come on automatically
when the ignition is switched on.
Automatic daytime running lights
NOTE: The daytime running light function may
only be disabled (turned off) in the U.S. -
Canadian law mandates the use of daytime
running lights.
Screw A in the illustration (available on U.S.
models only) is used to control the automatic
daytime running lights when the headlight switch
is in position 0. To adjust, press in the screw with
a small screwdriver and turn to one of the
following positions:
Automatic daytime
running lights
Automatic daytime
running lights
** The daytime running
lights will also function when
the headlight switch is in


Turn signals

1 Lane change position: In maneuvers such as
lane changing, the driver can flash the turn signals
by moving the turn signal lever to the first stop
and holding it there. The lever will return to the
neutral position when released.
2 Signal lever engaged for normal turns
3 High beam/low beam switch (headlights on)
Move the lever towards the steering wheel and
release it.
Headlight flasher (headlights off)
Move the lever towards the steering wheel.
The headlight high beam will be on until the lever
is released.

NOTE:Defective turn signal bulbs will cause turn
signal indicator and remaining signal lights to
flash more rapidly than normal.
file:///K|/ownersdocs/1998/1998_SV90/98S90_017.htm (4 of 7)12/30/2006 \
1:52:36 PM

1998 Volvo S90
position and switch A is in this position.
All lights off (daytime running light function
disabled)
Winshield wipers/washers, Ignition switch pg. 21


Windshield wipers/washers

1 Intermittent wiper.
With switch in this position, the wipers will
sweep approximately every seventh second.
2 "Single sweep" position.
Switch returns automatically when released
3 Wipers, low speed.
4 Wipers, high speed
5 Windshield wiper/washer, headlight
wiper/washer (certain models)
The wiper will make 2-3 complete sweeps
across the windshield and headlights after
lever is released.
Starting
(ignition)
switch/
steering
wheel lock

The steering
wheel lock
might be under
tension when
the car is
parked. Turn
the steering
wheel slightly
to free the ignition key.
In order to reduce car
theft, make sure the
steering wheel lock is
engaged before leaving
the car.
Achime will sound if the
starting key is left in the
ignition lock and the
front door on the driver's
side is opened. 0 Locked position:
remove the key to lock the
steering wheel.

WARNING:
Never turn the key to
position 0 while driving or
when the car is being
towed.

I Intermediate position:
Certain accessories/radio,
etc. on, daytime running
lights off.

II Drive position:
Key position when engine is
running.

III Starting position:
Release the key when the
engine start.
The key returns
automatically to the Drive
position.
*The gear selector must be
in the (P)ark position before
the key can be removed
from the ignition switch.
Fog lights, Instruments illumination, Steering wheel adjustment, Power antenna
pg. 22
file:///K|/ownersdocs/1998/1998_SV90/98S90_017.htm (5 of 7)12/30/2006 \
1:52:36 PM

1998 Volvo S90
control system:
set switch (B) to OFF,
depress the brake pedal or
move the gear selector to
position N. Switching off the
starting (ignition) switch will
automatically disengage the
cruise control system.
WARNING! The cruise
control should not be used
in heavy traffic or when
driving on wet or slippery
roads. Do not use or
resume cruise control in
reverse gear. When the
ignition is switched off,
any information stored in
the cruise control memory
will be erased.

Cruise control

The cruise control switches are
located on the turn signal switch
lever.
To engage and set desired
speed:
1. Set switch (B) to ON.
2. Accelerate to desired cruise
speed.

NOTE:The cruise control cannot
be engaged at speeds below 22
mph (35 km).

3. Press the + or - area of the SET
button (A) to set the desired
speed. Braking
This will automatically disengage
the cruise control. Previously
selected cruise control speed is
retained in the memory and by
momentarily setting the switch to
RESUME position, that speed will
be re-engaged.

If the cruise control is already
engaged, the cruising speed can be
increased or decreased by
depressing the SET button (A)
towards either + or -. One short
press on the button corresponds to
a speed change of approx. 1 mph
(1.6 km/h). When the button is
released, the vehicle will maintain
the current speed.

If actual speed falls below 70% of
set speed or if the wheels spin or
file:///K|/ownersdocs/1998/1998_SV90/98S90_023.htm (3 of 7)12/30/2006 \
1:52:37 PM

1998 Volvo S90

*When the function selector is in the
mode, the air conditioning
system is ON and recirculation is OFF, regardless
of button position. The light surrounding the "Snowflake" button will be\

OFF and the light surrounding the recirculation button will be OFF.

NOTE: If your windows begin to fog or mist, check that the
recirculation function is not engaged.
Heating, ventilation and air conditioning (cont.) pg. 27
Automatic setting

The ECC system will automatically
maintain a comfortable in-car
temperature regardless of the outdoor
temperature.


Select the desired temperature

The blower will run at its maximum
speed in either the max cooling or max
Operating Tips

Recirculation: When the
outside air is contaminated
with exhaust gases, smoke
etc. (as when driving
through a tunnel) or to cool
the car quickly, push the
recirculation button. In this
position, no air is drawn into
the passenger compartment
from outside. However, do
not leave the system in this
mode for more than 10-15
minutes, since the air inside
the car will become stale
and the windows may fog.
Recirculation (and the
indicator light) will also
come on when the interior of
the car is hot and a low
temperature is selected with
the temperature dial. This
helps speed cooling of the
passenger compartment. It
will switch off automatically
after several minutes.

Difficult weather
conditions

When driving in very humid ECC system fault
indication

If the light in the air
conditioning push button
begins to flash when the
ignition is switched on, a
simple fault is indicated.
The system will compensate
by substituting a standard
value stored in the memory.
System performance loss
will be slight.
If the light continues to flash
more than 20 seconds, a
more serious fault is
indicated. While the system
will again attempt to
substitute a standard value,
some reduction in system
performance will become
apparent. Contact your
authorized Volvo retailer for
service.

file:///K|/ownersdocs/1998/1998_SV90/98S90_023.htm (6 of 7)12/30/2006 \
1:52:37 PM

1998 Volvo S90
the above illustration.
The starting (ignition) switches must be ON
(position II) for the electrically operated windows
to function. The window is lowered if the rear part
of the switch is pressed and raised if the front part
of the switch is pressed.
NOTE: Driver's window only (AUTO): The
window can be opened completely by pressing the
rear part of the switch lightly and releasing it
immediately. The window can be stopped by
pressing the button again. If the button is held
down, the window will be lowered until the button
is released.
WARNING!Remove the starting (ignition)
key when children are left unattended in the
vehicle.
Make sure that children's hands are clear
before raising the windows. is positioned 90° in relation to the other switches.
ON The rear door windows can be raised or
lowered with the respective door switch as well as
the switch on the driver's door.
OFF The rear door windows cannot be raised or
lowered with the respective door switch but
instead only with the corresponding switch on the
driver's door.

NOTE: The power window motors have an
overload protecting circuit breaker which is
activated when an object blocks a window.
Should this occur, remove the object and wait 20
seconds for the circuit breaker to reset. The power
windows should then function.
Parking brake, Cigarette lighter, Ashtrays pg. 30


Parking brake (hand brake)

The lever is situated between
the front seats. The brake is
applied to the rear wheels.


Cigarette lighter/ashtrays

To operate, depress the knob
fully. When the knob
automatically releases, the
cigarette lighter is ready for use.
The starting (ignition) switch
must be switched on (to position
I or II) for the cigarette lighter
to function.

"OBD II"

A connector for on-board
diagnostics ("OBD II") is located
to the right of the parking brake.
This connector is intended for
use by authorized service
technicians only.
file:///K|/ownersdocs/1998/1998_SV90/98S90_028.htm (2 of 3)12/30/2006 \
1:52:38 PM

1998 Volvo S90


Master key
This key operates all locks



Service key
Front doors, starting (ignition)
switch/steering wheel lock Number tag

The key number codes are
stamped on a separate tag supplied
with the keys. This tag should be
separated from the key ring and
kept in a safe place. In the event
the original keys are lost,
duplicates may be ordered from
your Volvo retailer.
Doors and locks

Your car is equipped with a central
locking system.
The key used on either of the front
doors will lock/unlock all doors and
trunk/tailgate.
Turn the key once in the driver's
door to unlock that door only.
Turn the key in the same direction
again (within 10 seconds) to unlock
all doors, trunk/tailgate.
One turn with the key towards
locking in either of the front doors
locks all doors, trunk/tailgate.
Use the switch on the instrument
panel (with the doors closed) to
lock/unlock the car from the inside.

Check the action of the buttons on
the other doors to verify their
correct function (lock/unlock). The
driver's door can be locked only by
using the key when outside the
vehicle.
On vehicles equipped with the
optional remote control locking
system, refer to the following
page.

WARNING!
The doors should not be locked
while driving. In case of an
accident, this may hinder rapid
access to the occupants of the
vehicle. (Also see information
on "child safety locks").
Remote keyless entry system pg. 33
file:///K|/ownersdocs/1998/1998_SV90/98S90_031.htm (2 of 6)12/30/2006 \
1:52:39 PM

1998 Volvo S90
Electrically operated front seats

The front seats are electrically operated.
Using the switches on the sides of the seats
you can adjust:
-the height of the seat (rear)
-the height of the seat (front)
-the forward-backward movement
-the backrest tilt

NOTE:The electrically operated front
seats have an overload protector which
engages if an object blocks either of the
seats. If this happens remove the object
and wait 20 seconds. The overload
protector should then have cooled down
and the power seats should function
normally. Passenger's seat (option)



The STOP button (passenger
seat only) overrides the other
controls. To stop movement
of the seat, press and release
the STOP button. Press the
button again to reactivate the
seat controls.
A Seat front (raise/lower)
B Forward -rearward
C Seat rear (raise/lower)
D Backrest tilt
WARNING! Do not
adjust the seat while
driving. The seat should
be adjusted so that the
brake pedal can be
depressed fully. In
addition, position the seat
as far rearward as comfort
and control allow. The
seat rails on the floor must
not be obstructed in any
way when the seat is
moved.

Driver's seat



Movement of the driver's seat
can be STOPPED at any time
by pressing any button on the
seat's control panel.

WARNING!The driver's
seat is operable with the
ignition OFF.
Therefore, children should
never be left unattended in
the car.



Programming the memory

Three seat positions can be
programmed. To program a
seat position:
1. Adjust the seat to the
desired position.
2. Depress the MEM button.
3. Press button 1 to program
the current position of the
seat.
Buttons 2 and 3 can be
programmed in the same way
for two additional seat
positions. To move the seat to
a programmed position,
depress button 1, 2 or 3 until
the seat stops. If the button is
released before the seat has
the reached the programmed
position, it will stop as a
safety precaution.
Rear-/side-view mirrors, Vanity mirrors pg. 35
file:///K|/ownersdocs/1998/1998_SV90/98S90_031.htm (4 of 6)12/30/2006 \
1:52:39 PM

1998 Volvo S90


Interior light

1 Lights always on.
2 Lights always off.
3 Light is on when either of the
front or the rear doors are opened.

Atime-delay device keeps the
interior illuminated for approx. 30
seconds after closing the driver's
door. This facilitates finding the
starting (ignition) switch, etc., at
night.


Rear reading lights

Rear seat passengers can turn the
rear reading lights on or off by
using the adjacent switches. A ON
B OFF

To avoid battery drain

The interior light and the warning
lights in the rear of the doors come
on when a door is opened.
To avoid battery drain when the
doors are opened for prolonged
periods, these lights can be
switched off by pushing in and
turning the door light switches
slightly clockwise. When the door
is closed the switch will return to
its normal position.




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_031.htm (6 of 6)12/30/2006 \
1:52:39 PM