1998 VOLVO S90 clock

1998 Volvo S90
Replacing tail light bulbs (sedan
models)


All tail lamp bulbs are replaced from inside of
trunk. To avoid confusion, replace the bulbs one
at a time.
l Switch off the lights and ignition.
l Outboard lights: Unscrew screw A and turn
down the cover panel.
l Trunk lid: Lift the catch and fold down the
cover panel.
l Remove the bulb holder.
l Remove bulb by pressing and turning 1/4
turn counterclockwise.
l Insert a new bulb and fit the bulb holder in
the tail light cluster. One of the plugs on the
bulb holder is slightly wider than the other two.
l Turn the bulb holder clockwise to secure it.
Check that the bulb lights and refit the cover. Bulbs / Power CP(W) / Socket / US Bulb No
1,4 Tail light / 4(5) / BA 15s / 67
2 Rear turn signal / (21) / BAU 15s / –
3 Brake light / 32 / (21) / BA 15s / 1156
5 Back-up light / 32 (21) / BA 15s / 1156
6 Rear foglamp* 32 (21) / BA 15s / 1156

*Left (driver's) side only
Replacing bulbs, Sedans pg. 84
Light / Power CP(W) / Socket / US Bulb
No.
1 Fog light* / 32(21) / BA 15s / 1156
2 Back-up lights / 32(21) / BA 15 s / 1156
3 Turn signals / (21) / BAU 15 s / -
4 Brake light and tail light / 32/3(21/5) /
BAZ 15 d / 1157
*One light only, on driver's side

21 W 21 W 21/5 W
BA 15 s BAU 15 s BAY 15 d
Replacing tail light bulbs
(wagon models)

l Turn off the lights.
l Remove the cover with a screw driver.
l Rotate the bulb holder about 1/4" (0.6
cm) counterclockwise and remove the
holder from the tail light cluster.
l Gently press the bulb into the holder,
then rotate the bulb counterclockwise in
order to release it.
l Install a new bulb in the holder and
replace the bulb holder in the tail light
cluster. One of the guide lugs on the bulb holder
is slightly wider than the other two and,
thus, this lug fits into the widest recess
only.
l Turn the bulb holder clockwise
l Check that the bulb lights
l Re-install cluster cover

Two types of bulbs are in use
The guide lugs on the twin-pole bulb are
at different heights, and it is only possible
to fit these bulbs in one way. Try at first to
turn the bulb gently. Do not use force. If
this does not work, take out the bulb and
turn it half a turn and try again.
Replacing bulbs (cont.) pg. 85
file:///K|/ownersdocs/1998/1998_SV90/98S90_081.htm (3 of 6)12/30/2006 \
1:52:45 PM

1998 Volvo S90
Trunk light (sedan models)
Courtesy light (wagon models)


Depress the catch with a screwdriver and
remove the light assembly. Lift it out to
remove. Replace the bulb.
Bulb - Power - Socket
Trunk light - 10 W - SV 8.5

License plate light (sedan
models)


Turn off the lights. Remove both
screws and insert the screwdriver and
turn it carefully (see illustration) until
the glass comes loose. Replace the bulb
and reinstall the glass.
Bulb - Power - Socket
License plate light - 5W - W2.1x9.5d
License plate light (wagon
models)


Remove the screws with a screwdriver.
Remove lamp housing. Depress the bulb and
rotate it counterclockwise. Remove the bulb.
Install a new bulb and re-install lamp housing.

Bulb - Power - Socket
License plate light - 4 W - BA9s
WARNING! When using a screwdriver to pry plastic components, take care to avoid \
scratching or breakage. Use eye protection
whenever possible.
Replacing bulbs (cont.) pg. 86

Removing cover (sedans)
Removing cover (wagons) Depress catches
file:///K|/ownersdocs/1998/1998_SV90/98S90_081.htm (4 of 6)12/30/2006 \
1:52:45 PM

1998 Volvo S90

Location ** Amperage
1 Heated rear window 25
2 Central locking 20
3 Brake light, Light switch 15
4 Ignition switch, SRS 10
5 Spare
6 Windshield wiper/washer, Headlight wiper, horn relay 25
7 Climate unit 20
8 Power pass. seat, Power side-view mirrors, Tailgate wiper/washer (wag\
ons)
Instrument lighting, Ambient temp. sensor 15
9 Audio system 15
10 Cigarette lighter/accessory socket 15
11 Transmission mode selector, Gear selector light 5
12 ABS 5
13 Clock, Interior/glove compartment lighting, Door open warning lights,\

Cargo space lighting, Vanity mirror 10
14 Horn 10

Location ** Amperage
15 Power antenna, Headlight flasher, Trailer 20
16 Accessories 20
17 Hazard warning flasher, Direction indicator, Alarm hazard indication \
20
18 Audio/amplifier, CD changer 15
file:///K|/ownersdocs/1998/1998_SV90/98S90_089.htm (5 of 9)12/30/2006 \
1:52:46 PM

1998 Volvo S90
A- On/off switch

Push the button to switch on the
radio. Press the button to turn
the radio off.

B- Volume control

Turn the button clockwise to
increase the volume. The
volume control is electronic and
has no end stop.

C- Waveband selector

The desired waveband is set by
pressing one of the waveband
selector bands. The frequency
and waveband is shown on the
display.

NOTE: There are two FM
wavebands and one AM
waveband. This makes it
possible to store 2 x 6 FM
stations and 6 AM stations in
memory. D- Setting frequency
selection

The radio can be used in most
parts of the world by changing
the frequency selection
intervals as follows:
Depress and hold preset button
5 and turn the radio ON. "USA"
will flash on the display. Each
time button 5 is pressed, the
frequency selection will change
from "USA" to "AUS", etc.
When the correct country name
is displayed, wait 5 seconds and
the radio will be ready for use.
E- Manual tuning

Press the left side tune button to
tune to lower frequencies and the
right side to tune to higher
frequencies. The tuned
frequency is displayed.

ST will be displayed to indicate
stereo FM reception.
Radio SC-813 (cont.) pg. 135
file:///K|/ownersdocs/1998/1998_SV90/98S90_131.htm (4 of 6)12/30/2006 \
1:52:52 PM

1998 Volvo S90
Radio SC-813 (cont.) pg. 137
A- Fader control

Adjust front/rear speaker
balance by sliding the control
up or down.
(Up to direct more sound to the
front speakers, down to direct
more sound to the rear speakers.
The "detent" indicates
"equalized" front/rear balance
position.

B- Pause function

Press the "volume" knob to
temporarily mute the sound.
"PAUSE" is displayed. C- Balance control

Pull out the "volume" knob and
adjust the left/right balance by
turning the knob counter-
clockwise or clockwise.

D- Scan

Press this button to listen to
each station for five seconds.
Press it again to stop scanning.
E- Active sound control
(ASC)

The ASC function automatically
adjusts the volume level of the
audio system according to
driving speed.
To deactivate ASC depress the
"ASC" button.
To activate ASC, depress the
"ASC" button until "ASC" is
displayed.




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_131.htm (6 of 6)12/30/2006 \
1:52:52 PM

1998 Volvo S90
Enter the code again once this
time has elapsed.
Radio SC-816 pg. 147
A- On/off switch

Push the button to switch on the
radio. Press the button to turn
the radio off.

B- Volume control

Turn the button clockwise to
increase the volume. The
volume control is electronic and
has no end stop.

C- Waveband selector

The desired waveband is set by
pressing one of the waveband
selector bands. The frequency
and waveband is shown on the
display.

NOTE: There are two FM
wavebands and one AM D- Setting frequency
selection

The radio can be used in most
parts of the world by changing
the frequency selection
intervals as follows:
Depress and hold preset button
5 and turn the radio ON. "USA"
will flash on the display. Each
time button 5 is pressed, the
frequency selection will change
from "USA" to "AUS", etc.
When the correct country name
is displayed, wait 5 seconds and
the radio will be ready for use. E- Manual tuning

Press the left side tune button to
tune to lower frequencies and the
right side to tune to higher
frequencies. The tuned
frequency is displayed.

ST will be displayed to indicate
stereo FM reception.
file:///K|/ownersdocs/1998/1998_SV90/98S90_145.htm (3 of 6)12/30/2006 \
1:52:53 PM

1998 Volvo S90
A- Fader control

Adjust front/rear speaker
balance by sliding the control
up or down.
(Up to direct more sound to the
front speakers, down to direct
more sound to the rear speakers.
The "detent" indicates
"equalized" front/rear balance
position.

B- Pause function

Press the "volume" knob to
temporarily mute the sound.
"PAUSE" is displayed. C- Balance control

Pull out the "volume" knob and
adjust the left/right balance by
turning the knob counter-
clockwise or clockwise.

D- Scan

Press this button to listen to
each station for five seconds.
Press it again to stop scanning.
E- Active sound control
(ASC)

The ASC function automatically
adjusts the volume level of the
audio system according to
driving speed.
To deactivate ASC depress the
"CD" button until "ASC" is no
longer displayed.
To activate ASC, depress the
"CD" button until "ASC" is
displayed (approx. 2 seconds).




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_145.htm (6 of 6)12/30/2006 \
1:52:53 PM