Page 174 of 233

’98 AVALON (USA/CANADA)−U
174
—Loosening wheel nuts
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before rais-
ing the vehicle.
The nuts turn counterclockwise to loosen.
To get maximum leverage, fit the wrench
to the nut so that the handle is on the
right side, as shown above. Grab the
wrench near the end of the handle and
pull up on the handle. Be careful that the
wrench does not slip off the nut.
Do not remove the nuts yet—just unscrew
them about one− half turn.
—Positioning the jack
5. Position the jack at the correct jack
point as shown.
Make sure the jack is positioned on a
level and solid place.
—Raising your vehicle
6. After making sure that no one is in the vehicle, raise it high enough so
that the spare tire can be installed.
Remember you will need more ground
clearance when putting on the spare tire
than when removing the flat tire.
To raise the vehicle, insert the jack handle
into the jack (it is a loose fit) and turn it
clockwise. As the jack touches the vehicle
and begins to lift, double −check that it is
properly positioned.
ProCarManuals.com
Page 176 of 233
’98 AVALON (USA/CANADA)−U
176
—Reinstalling wheel nuts
8. Reinstall all the wheel nuts finger
tight.
Reinstall the wheel nuts (tapered end in-
ward) and tighten them as much as you
can by hand. Press back on the tire back
and see if you can tighten them more.
—Lowering your vehicle
9. Lower the vehicle completely and tighten the wheel nuts.
Turn the jack handle counterclockwise to
lower the vehicle.
Use only the wheel nut wrench and turn
it clockwise to tighten the nuts. Do not
use other tools or any additional leverage
other than your hands, such as a hammer,
pipe or your foot. Make sure the wrench
is securely engaged over the nut.
Tighten each nut a little at a time in the
order shown. Repeat the process until all
the nuts are tight.
CAUTION
When lowering the vehicle, make sure
all portions of your body and all oth-
er persons around will not be injured
as the vehicle is lowered to the
ground.
ProCarManuals.com
Page 203 of 233

’98 AVALON (USA/CANADA)−U
203
If the level is low, add SAE J1703 or
FMVSS No. 116 DOT 3 brake fluid to
the brake reservoir.
Remove and replace the reservoir cover
by hand. Fill the brake fluid to the dotted
line. This brings the fluid to the correct
level when you put the cover back on.
Use only newly opened brake fluid. Once
opened, brake fluid absorbs moisture from
the air, and excess moisture can cause a
dangerous loss of braking.
CAUTION
Take care when filling the reservoir
because brake fluid can harm your
eyes and damage painted surfaces. If
fluid gets in your eyes, flush your
eyes with clean water.
NOTICE
If you spill the fluid, be sure to wash
it off with water to prevent it from
damaging the parts or paint.
Checking power steering fluid
If hot O.K.
If cold O.K.
CloseOpen
If hot add
If cold add
Check the fluid level through the reser-
voir. If necessary, add automatic trans-
mission fluid DEXRON −II or −III.
If the vehicle has been driven around 80
km/h (50 mph) for 20 minutes (a little
more in frigid temperatures), the fluid is
hot (60 C—80 C or 140 F—175 F). You
may also check the level when the fluid
is cold (about room temperature,
10 C—30 C or 50 F—85 F) if the engine
has not been run for about five hours. Clean all dirt from outside of the reservoir
tank and look at the fluid level. If the fluid
is cold, the level should be in the ”COLD”
range. Similarly, if it is hot, the fluid level
should be in the ”HOT” range. If the level
is at the low side of either range, add
automatic transmission fluid DEXRON
−II
or −III to bring the level within the range.
To remove the filler cap, turn it counter-
clockwise and lift up. To reinstall it, turn
it clockwise. After replacing the filler cap,
visually check the steering box case, vane
pump and hose connections for leaks or
damage.
CAUTION
The reservoir tank may be hot so be
careful not to burn yourself.
NOTICE
Avoid overfilling, or the power steer-
ing could be damaged.
ProCarManuals.com
Page 216 of 233
’98 AVALON (USA/CANADA)−U
216
Removing cover clips
Installing cover clips
2. Turn the cover counterclockwise and
remove it.3. Disconnect the cords.
ProCarManuals.com
Page 217 of 233
’98 AVALON (USA/CANADA)−U
217
4. Release the bulb retaining spring
and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install the bulb, align the cutouts of the
bulb with the protrusions of the mounting
hole.
5. Connect the cords and install thecover by turning it clockwise.
Install the engine under cover securely.
Use a Phillips −head screwdriver.
—Parking and front turn
signal lights
ProCarManuals.com
Page 227 of 233

’98 AVALON (USA/CANADA)−U
227
Tires
Tire size:
P205/65R15 92H
Tire pressure, kPa (kPa (kgf/cm
2 or bar,
psi): Front 220 (2.2, 32)
Rear 220 (2.2, 32)
Wheel size: 15 x 6JJ
Wheel nut torque, N m (kgfm, ft lbf):
103 (10.5, 76)
Fuses
Engine compartment (U.S.A)
Fuses (type A)
1. SPARE 7.5 A: Spare fuse
2. EFI 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, air c onditioning system, electri-
cal idle −up system, electronically con-
trolled automatic transmission system
3. HORN 10 A: Horn
4. OBD. TRAC 7.5 A: On−board diagnosis
system
5. OBD 7.5 A: On−board diagnosis sys-
tem
Engine compartment (Canada)
6. HAZ 10 A: Turn signal lights, emergen-
cy flasher
7. DOME 7.5 A: Interior light, personal
light, vanity mirror light, door courtesy
light, ignition switch light, trunk light,
power door lock control, locking with
wireless remote control system, theft
deterrent system, automatic light con-
trol system, daytime running light sys-
tem, service reminder indicators and
warning buzzer, clock
8. HEAD (LH) 15 A: Left−hand headlight
9. HEAD (RH) 15 A: Right−hand headlight
ProCarManuals.com
Page 229 of 233

’98 AVALON (USA/CANADA)−U
229
Instrument panel
30. GAUGE 7.5 A: Gauge and meter,
buck −up lights, interior lights, charging
system, electronically controlled auto-
matic transmission system, cruise con-
trol system, power door lock system,
service reminder indicators and warning
buzzer, automatic light control system,
daytime running light system
31. TAIL 15 A: Parking lights, license plate
lights, tail lights, front side marker
lights
Passenger’s side kick panel
32. STOP 15 A: Stop lights, cruise control
system, high m ounted stoplight, anti/
lock brake system, shift lock system,
multiport fuel injection system/sequen-
tial multiport fuel injection system
33. PANEL 5 A: Gauge and meter, car
audio system, cigarette lighter, glove-
box light, clock, electronically controlled
automatic transmission system, air
conditioning system, service reminder
indicators, turn signal lights, emergency
flasher, headlight cleaner, seat heater
34. MIRROR HEATER 10 A: Mirror heaters35. CIG/RADIO 15 A:
Cigarette lighter, in-
terior lights, clock, SRS airbag system,
seat belt pretensioners, shift lock sys-
tem, electronically controlled automatic
transmission system, air conditioning
system, ignition system, theft deterrent
system, outside rear view mirror control
system, car audio system, service re-
minder indicators
36. HEATER 10 A: Air conditioning system,
rear window defogger, starter system
37. STARTER 5 A: Starter system
38. A.C 10 A: Air conditioning system
Fuses (type B)
39. MAIN 40 A: ”HEAD (LH)”, ”HEAD HI
(LH)”, ”HEAD (RH)” and ”HEAD HI
(RH)” fuses
40. RDI 30 A: Electric cooling fans
41. CDS 30 A: Electric cooling fans
42. DOOR 30 A: Power door lock system,
power seat
43. RR DEF 40 A: Rear window defogger
44. POWER 30A: Power window, electric
moon roof
ProCarManuals.com