1998 TOYOTA 4RUNNER transmission

4RUNNER (1998)
Instrument panel overview 1. Side vent
2. Tilt steering lock release le-ver
3. Instrument cluster
4. Center vents
5. Personal lights
6. Electric moon roof switch
7. Glovebox
8. Power door lock switch
9. Power window switches
10. Automatic transmission se- lector lever or manual trans-
mission gear shift lever
11. Parking brake lever
12. Driving pattern selector but- ton
13. Power back window switch
14. Front drive control lever
15. Lower vent
16. Hood lock release lever
17. Fuel filler door o pener
18. Power rear view mirror con- trol switch (with power win-
dows)

4RUNNER (1998)
Indicator symbols on the instrument panel
Automatic transmission fluid temperatu
light*
1
SRS airbag warning light *
1
Unengaged ºParkº warning light *
1
Anti-lock brake system warning light *
1
Seat belt reminder light
*
1
Open door warning light *
1
(type A)
(type B)
Low oil pressure warning light *
1

Low fuel level warning light *
1
Brake system warning light
*
1
Discharge warning light *
1
Malfunction indicator lamp *
1
Low windshield washer fluid level warn
Headlight high beam indicator light
Overdrive- off indicator light
Turn signal indicator lights

4RUNNER (1998)
*
1
: For details, see ºService reminder indicators and warning
buzzersº in Chapter 1-5.
* 2
: If this light flashes, see ºCruise controlº in Chapter 1-6.
Cruise control indicator light *
2
Driving pattern
(ºPOWERº
mode)
indicator
light
Four- wheel drive indicator light
Rear differential lock indicator light
Automatic transmission indicator light

4RUNNER (1998)
(k) Key Reminder Buzzer
This buzzer reminds you to remove
the key when you open the driver's
door with the ignition key in the ºACCº
or ºLOCKº position.
(l) Unengaged ºParkº Warning
Light
( vehicles with automatic
transmission)
This light warns that the transmission
ºParkº mechanism is not engaged. If
the front drive control lever is in the
ºNº position while the selector lever is
in the ºPº position, the transmission
will disengage and the wheels will not
lock.
CAUTION
To restore the park function, shift
the front drive control lever out
of ºNº, or the vehicle can move.
(m) Automatic Transmission Fluid Temperature Warning Light
This light warns that the automatic
transmission fluid temperature is too
high.
If this light comes on while you are
driving, slow down and pull off the
road. Stop the vehicle at a safe place
and put the selector lever in ºPº. With
the engine idling, wait until the light
goes off. If the light goes off, you
may start the vehicle again. If the
light does not go off, call a Toyota
dealer or qualified repair shop for as-
sistance.
NOTICE
Continued driving with the warn- ing light on may damage the auto-matic transmission.
(n) Low windshield Washer Fluid Level Warning Light (Canada)
The light warns that the windshield
washer fluid level is too low. Add
washer fluid at your earliest opportuni-
ty. (For instructions, see ºAdding
washer fluidº in Chapter 7- 3.) CHECKING SERVICE REMINDER
INDICATORS
1. Apply the parking brake.
2. Open one of the side doors or the back door.
The open door warning light should
come on.
3. Close the door. The open door warning light should
go off.
4. Turn the ignition key to ºACCº. The SRS airbag warning light
should come on. It goes off after
about 6 seconds.
5. Turn the ignition key to ºONº, but do not start the engine.
All the service reminder indicators
except the open door warning light
and SRS airbag warning light
should come on. The ºABSº warn-
ing light goes off after about 3 se-
conds.

4RUNNER (1998)
Part 1
OPERATION OF
INSTRUMENTS
AND CONTROLSÐ
Chapter 1- 6
Ignition switch,
Transmission
and Parking brake
Ignition switch with steering
lock
Automatic transmission
Manual transmission
Four- wheel drive system
Rear differential look system

P ar k ing br ak e
Cruise control
Clutch start cancel switch
Ignition switch with steering lock

4RUNNER (1998)
ºSTARTºÐStarter motor on. The key
will return to the ºONº position
when released.
For starting tips, see Part 3.
ºONºÐEngine on and all accesso-
ries on.
This is the normal driving position.
ºACCºÐAccessories such as the ra-
dio operate, but the engine is off.
If you leave the key in the ºACCº or
ºLOCKº position and open the driver's
door, a buzzer will remind you to re-
move the key.
ºLOCKºÐEngine is off and the
steering wheel is locked. The key
can be removed only at this posi-
tion. Vehicles with manual transmissionÐ
You must push in the key to turn the
key from ºACCº to the ºLOCKº posi-
tion.
Vehicles with automatic transmissionÐ
You must shift the selector lever into
the ºPº position before turning the key
from ºACCº to the ºLOCKº position.
When starting the engine, the key
may seem stuck at the ºLOCKº posi-
tion. To free it, first be sure the key
is pushed all the way in, and then
rock the steering wheel slightly while
turning the key gently.CAUTION
For manual transmission:
Never remove the key when the
vehicle is moving, as this will
lock the steering wheel and result
in loss of steering control.
NOTICE
Do not leave the key in the ºONº
position if the engine is not run-ning. The battery will dischargeand the ignition could be dam-
aged.

4RUNNER (1998)
Lock release button
To prevent misshifting Parking, engine starting and key removal position Reverse position Neutral position Position for engine braking
With the brake pedal depressed, shift while holding the lock release button in. (The ignition switch must be in ºONºposition.) Shift while holding the lock release button in. Shifting normally Normal driving position Position for stronger engine braking than that in º2º posi- tion
Overdrive switch
For selecting either a three-speed or four-speed transmission
ºONº position(Shifting into overdrive pos-sible) ºOFFº position (Shifting into overdrive notpossible)ºO/D OFFº indicator light shows the over- drive switch is inOFF position
Driving pattern selector button For selecting a driving pattern suited to existing driving conditions
ºNORMº (Normal)mode for general driving conditioning ºPWRº (Power) mode for power- ful acceleration
ºPWRº mode indicator light on the instrument panel shows the driving pattern selector button isin the ºPWRº mode
Vehicles with cruise control ' When the cruise control is being used, even if you downshift the trans mission by turning
off the overdrive switch, engine braking will not be applied because the cruise control is not cancelled. For ways to
decrease the vehicle speed, see ºCruise controlº in this chapter. Automatic transmission
Two- wheel drive models

4RUNNER (1998)
Your automatic transmission has a
shift lock system to minimize the pos-
sibility of incorrect operation. This
means you can only shift out of ºPº
position when the brake pedal is de-
pressed (with the ignition switch in
ºONº position and the lock release
button depressed).
(a) Normal driving 1. Start the engine as instructed in ºHow to start the engineº in Part 3.
The transmission must be in ºPº or
ºNº.
2. With your foot holding down the brake pedal, shift the selector lever
to ºDº.
In ºDº position, the automatic trans-
mission system will select the most
suitable gear for running conditions
such as normal cruising, hill climbing,
hard towing, etc.
Always turn the overdrive switch on
for better fuel economy and quieter
driving. If the engine coolant tempera-
ture is low, the transmission will not
shift into the overdrive gear even with
the overdrive switch on.
CAUTION
Never put your foot on the accel-
erator pedal while shifting.
3. Release the parking brake and brake pedal. Depress the accelera-
tor pedal slowly for smooth start-
ing.
(b) Using engine braking
To use engine braking, you can down-
shift the transmission as follows: Turn off the overdrive switch. The
ºO/D OFFº indicator light will come
on and the transmission will down-
shift to the third gear.
Shift into the º2º position. The
transmission will downshift to the
second gear when the vehicle
speed drops down to or lower than
the following speed, and more pow-
erful engine braking will be ob-
tained.
3RZ- FE engine.....112 km/h (69
mph)
5VZ- FE engine.....119 km/h (73
mph)
Shift into the ºLº position. The
transmission will downshift to the
first gear When the vehicle speed
drops down to or lower than the
following speed, and maximum en-
gine braking will be applied.
3RZ- FE engine.....54 km/h (33
mph)