1998 TOYOTA 4RUNNER child seat

4RUNNER (1998)
A convertible seat is used in for-
ward- facing and rear- facing posi-
tion depending on the child's age
and size. When installing, follow the
manufacturer 's instructions about
the applicable child's age and size
as well as direction for installing of
a child restraint system.
CAUTION
Do not put a rear- facing child re-
straint system on the rear seat if
it interferes with the lock mecha-
nism of the front seats. This can
cause severe injury to the child
and front passenger in case of
sudden braking or a co llision.

4RUNNER (1998)
1. Run the center lap belt through or
around the convertible seat follow-
ing the instructions provided by its
manufacturer and insert the tab
into the buckle taking care not to
twist the lap belt.
CAUTION
After inserting the tab, make
sure the tab and buckle are
locked and that the lap belt is
not twisted.
Do not insert coins, clips, etc.
in the buckle as this may pre-
vent you from properly latching
the tab and buckle.
If the seat belt does not
function normally, it cannot
protect your child from injury.
Contact your Toyota dealer
immediately. Do not use the
seat until the seat belt is fixed.

4RUNNER (1998)
CAUTION
Push and pull the child restraint
system in different directions to
be sure it is secure. Follow all
the installation instructions pro-
vided by its manufacturer.
3. To remove the convertible seat,
press the buckle- release button. ÐInstallation with 3- point
type seat belt

4RUNNER (1998)
CAUTION
Never put a rear- facing child
restraint system in the front
seat because the force of the
rapid inflation of the passenger
airbag can cause death or seri-
ous injury to the child.
Do not put a rear- facing child
restraint system in the rear seat
if it interferes with the lock
mechanism of the front seats.
This can cause severe injury to
the child and front passenger in
case of sudden braking or a
collision.

4RUNNER (1998)
1. Run the lap and shoulder belt
through or around the infant seat
following the instructions provided
by its manufacturer and insert the
tab into the buckle taking care not
to twist the belt. Keep the lap por-
tion of the belt tight.
CAUTION
After inserting the tab, make
sure the tab and buckle are
locked and that the lap and
shoulder portions of the belt
are not twisted.
Do not insert coins, clips, etc.
in the buckle as this may pre-
vent you from properly latching
the tab and buckle.
If the seat belt does not
function normally, it cannot
protect your child from injury.
Contact your Toyota dealer
immediately. Do not use the
seat until the seat belt is fixed.

4RUNNER (1998)
CAUTION
Make sure the seat belt is secure-
ly locked. Also make sure the
child restraint system is secure
by pushing and pulling it in dif-
ferent directions. Follow all the
installation instructions provided
by its manufacturer.
4. To remove the infant seat, press
the buckle- release button and allow
the belt to retract completely. The
belt will move freely again and be
ready to work for an adult or older
child passenger.

4RUNNER (1998)
(B) CONVERTIBLE SEAT INSTALLA-
TION
A convertible seat is used in for-
ward- facing and rear- facing posi-
tion depending on the child's age
and size. When installing, follow the
manufacturer 's instructions about
the applicable child's age and size
as well as directions for installing
a child restraint system.

4RUNNER (1998)
CAUTION
Never put a rear- facing child
restraint system in the front
seat because the force of the
rapid inflation of the passenger
airbag can cause death or seri-
ous injury to the child.