1998 OLDSMOBILE SILHOUETTE door lock

Five seconds after the last door is closed, all the doors
will lock. You can lock the doors immediately by using
the power door lock switch or the remote lock
control transmitter.
If the ignition is in RUN or ACCESSORY, this feature
will not lock the doors.
To turn the Last Door Closed Locking feature off or on,
see “Locks and Lighting Choices” in the Index.
Sliding Door Delayed Locking
If the sliding door is open when you use your power
door locks to lock the vehicle, the sliding door is not
locked. Normally the Last Door Closed Locking feature
will be used to lock the sliding door after it has
been closed.
When the ignition is on
or if the Last Door Closed
Locking feature has been overridden or programmed to
be off, the Sliding Door Delayed Locking feature will
lock your sliding door for you. Three seconds after the
sliding door is closed, all the doors will lock. If you
have the dual sliding doors, all doors will lock three
seconds after both sliding doors are closed.
Lockout Deterrent
The Lockout Deterrent feature makes it difficult for you
to lock your keys in your vehicle. If the driver’s door is
open while the keys are
in the ignition, you will not be
able to use your power door lock to lock the vehicle.
If you don’t leave the keys in the ignition or if you use
the manual door lock, you could still lock your keys in
your vehicle. Always remember to take your keys
with you.
To turn this feature
off or on, see “Locks and Lighting
Choices” in the Index.
Leaving Your Vehicle
If you are leaving the vehicle, take your keys, open your
door and set the locks from the inside. Then get out and
close the door.
2-7
ProCarManuals.com

Remote Lock Control (Option)
If your vehicle has this option, you can lock and unlock
your doors and the liftgate from about
3 feet (1 m) up to
30 feet (9 m) away using the remote lock control
transmitter supplied with your vehicle.
Your remote lock control system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada. This
device complies with Part
15 of the FCC Rules.
Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with RSS-2
10 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation
of
the device.
Changes or modifications to this system by other than an
authorized service facility could void authorization to use this equipment.
This system has a range
of about 3 feet (1 m) up to
30 feet (9 m). At times you may notice a decrease in
range. This is normal for any remote keyless entry
system. If the transmitter does not work or if you have
to stand closer to your vehicle for the transmitter to
work, try this:
Check to determine if battery replacement or
synchronization is necessary. See the instructions
that follow.
2-8
ProCarManuals.com

Check the distance. You may be too far from your
vehicle. You may need to stand closer during rainy
or snowy weather.
Check the location. Other vehicles or objects may be
blocking the signal. Take a few steps to the left or
right, hold the transmitter higher, and try again.
If you’re still having trouble, see your retailer or a
qualified technician for service.
Operation
Remote Driver’s Door and All Door Unlock
When you press UNLOCK on the remote lock control
transmitter, only the driver’s door will unlock.
If you
press UNLOCK again within five seconds, all the doors
and the liftgate will unlock.
If you would like all the
doors to unlock the first time you press
UNLOCK, see
“Locks and Lighting Choices”
in the Index.
If your vehicle is equipped with the Content
Theft-Deterrent system, the UNLOCK button on the
remote lock control transmitter will disarm the system
(see “Content Theft-Deterrent” in the Index for
more details).
Remote All Door Lock
To lock all doors, press LOCK on the remote lock
control transmitter (see “Power Door Locks” in the
Index for more details
on the power door lock features).
If your vehicle is equipped with the Content
Theft-Deterrent system, the LOCK button may arm the
system (see “Content Theft-Deterrent” in the Index for
more details).
Remote Lock Confirmation
When you use the remote lock control transmitter to
lock your vehicle, your parking lamps will flash briefly
to let you know the command has been received.
If you
press the LOCK button again, within five seconds, the
horn will sound briefly and the parking lamps will flash
to let you know the vehicle is already locked.
If you would like to change the way the parking lamps
and horn operate with Remote Lock Confirmation, see
“Locks and Lighting Choices” in the Index.
2-9
ProCarManuals.com

Remote Unlock Confirmation
When you use your remote lock control transmitter to
unlock your vehicle or to operate the power sliding door
(if equipped), your parking lamps will flash briefly to let
you know the command was received.
If you would like to change the way the parking lamps
operate with Remote Unlock Confirmation, see “Locks
and Lighting Choices”
in the Index.
Remote Alarm
When you press the horn button on the remote lock
control transmitter, your vehicle’s parking lamps will
flash and the horn will sound. This will allow you to
attract attention, if needed.
Remote Power Sliding Door Operation (Option)
If you have the optional
power sliding door (see “Power Sliding Door” later
in this section), your remote
transmitter will have a
button that has a van
symbol on it. Press it
to open or close the
sliding door.
If the sliding door
is locked, first unlock all doors (see
“Remote Driver’s Door and All Door Unlock” earlier in
this section), then press the van symbol to open the
sliding door. Press the van symbol again to close the
sliding door.
You can operate the power sliding door with the remote
transmitter only when the power sliding door override switch on the overhead console is disabled.
2-10
ProCarManuals.com

Sliding Door
To open the sliding door from outside the vehicle, pull
the handle out and then pull the door toward the rear. If
you slide the door all the way back, the door will rest in
a detent position.
The door must overcome this detent
when closing.
To move the door forward, you must first pull the door
past the open detent position.
If your vehicle is facing downward on a steep
grade
(15 percent or more), the door may not
stay open and could slam shut, possibly injuring
someone.
To make sure the door does not slam
shut, be sure to hold it open until everyone is
clear of the door, and only then allow
it to
slowly close.
Does your vehicle have a sliding door on the driver’s side?
If it does, this door is designed to open only a little if the
fuel door is open.
If this ever happens, don’t try to force
the sliding door. Just close the driver’s side sliding door.\
Then when the
fuel filler door is closed, the driver’s side
sliding door can be opened normally.
Sliding Door Lock
Lock the sliding door from inside the vehicle by moving
the manual locking lever down. Unlock it by moving the
lever up.
With power door locks, the sliding door lock has a delay
feature. See “Power Door Locks” or “Locks and
Lighting Choices” in the Index.
2-14
ProCarManuals.com

Power Sliding Door (Option)
With this option, you can open and close the sliding
door with the switches inside your vehicle.
If you have
the optional remote lock control system,
you can also
operate the power sliding door with your remote
transmitter. See “Remote Lock Control” in the Index.
/1 CAUTION: rn
Leaving young children or pets unattended in
your vehicle can be dangerous. They could
operate the power sliding door.
A child or others
could be injured.
Do not leave children or pets
unattended in your vehicle.
-7
3
:I
I To operate the power sliding
door, the power sliding door
override switch must be
disabled. This switch is
located in the overhead
console switchbank.
I
Pushing the bottom of the button will disable the power
sliding door; it will not operate when either of the power
door switches or the power sliding door button on the
remote transmitter is pressed.
The power sliding door override switch will also stop
the door immediately, while the door is opening or
closing, when the override feature is enabled.
2-15
ProCarManuals.com

NOTICE:
When your vehicle goes through an automatic
car wash, be sure the power sliding door override
feature is enabled.
If it isn’t, the power sliding
door
may open accidentally.
7
C
C
C
The sliding door must be unlocked for it to operate. The
key does not have to be in the ignition. To help avoid
accidental operation of the sliding door, disable the
power sliding door by pushing the power sliding door
override switch.
When the key is in the ignition in RUN, the power
sliding door will only open if the transaxle
is in
PARK (P). The transaxle does not have to be in
PARK (P) to close the door.
If the override feature is not enabled and the power
sliding door is open or in the process of closing when
you shift out of PARK (P), a buzzer will sound. This is a
warning that the sliding door is not completely closed.
To open or close the sliding door, press and release one
of the two power door switches.
One
is mounted on the wall, just in front of the
passenger’s side sliding door. The other switch
is located
in the overhead console switchbank.
If you shift the transaxle out of PARK (P) and
accelerate before the power sliding door latches
closed, the door may reverse to the open position.
A child or others could fall out of the vehicle and
be injured. Always make sure the power sliding
door
is closed and latched before you drive away.
2-16
ProCarManuals.com

Resetting the Power Sliding Door
The power sliding door may operate incorrectly or not at
all because of the following conditions:
A low voltage or dead battery,
Disconnecting the battery or
If the IGN 1, B/U LAMP, RADIO or PWR
SEATPSD fuse is removed or blown.
See “Fuse Panel” in the Index for more information
about your fuse panel.
If any of these conditions occur, the power sliding door
will need to be reset.
To do this, follow the directions
listed here. It will be easier if you read through them
once before beginning this procedure.
1. Check to be sure the power sliding door is unlocked
2. Turn the ignition switch to OFF.
and securely closed.
3. Enable the power sliding door override feature.
4. Remove the RADIO fuse from the underhood fuse
and relay center. Leave it out for
30 seconds.
5. Reinstall the fuse and wait 10 seconds.
6. Disable the power sliding door override feature.
7. Push either of the power door buttons to open the
power sliding door.
8. Wait five seconds and close the door by pushing
9. Wait five seconds and repeat Steps 7 and 8.
either power door button.
If the door does not rest in the fully open position after
repeating Step
7, repeat Steps 7 and 8 again. If the
door still does not operate correctly, see your retailer
for service.
Sliding Door Security Lock
Your vehicle is equipped with a sliding door security
lock that helps prevent young children or other
passengers from opening the sliding door by using the
inside door handle. This lock is on both doors if your
vehicle has the dual sliding doors.
If you have the optional power sliding door, you can
override the security lock by pressing either power door
switch when the power sliding door override feature is
disabled. See “Power Sliding Door” earlier in
the section.
2-19
ProCarManuals.com