1998 NISSAN PATROL brake

2. Remove shift shaft oil seal.
+Be careful not to damage inner shift lever.
3. Install shift shaft oil seal.
+Before installing, apply multi-purpose grease to seal lip.
4. Install transfer control lever.
REAR OIL SEAL
1. Remove rear propeller shaft. Refer to PD section (``Removal
and Installation'', ``PROPELLER SHAFT'').
2. Remove brake drum.
3. Remove companion ¯ange nut.
4. Remove rear companion ¯ange.
5. Remove center brake assembly.
6. Remove rear oil seal.
7. Install rear oil seal.
+Before installing, apply multi-purpose grease to seal lip.
8. Reinstall any part removed.
SMT097B
SMT096B
SMT323B
SMT324B
SMT325B
ON-VEHICLE SERVICE
Replacing Oil Seal (Cont'd)
TF-6

1. Remove nut of front companion ¯ange.
2. Remove center brake components.
a. Remove rear companion ¯ange nut.
b. Remove brake drum.
c. Remove rear companion ¯ange.
d. Remove center brake components.
3. Remove rear case.
+Be careful not to damage the mating surface.
4. Remove front companion ¯ange.
SMT101B
SMT258D
SMT103B
SMT104B
SMT105B
DISASSEMBLY
TF-13

h. Install snap ring to 2-4 shift rod.
i. Install speedometer drive gear and oil gutter.
j. Apply gear oil to each part in center case.
9. Apply sealant to mating surface. Set center case assembly onto
front case, then tighten bolts.
10. Install front and rear companion ¯anges and center brake com-
ponents.
SMT107B
SMT106B
SMT171B
ASSEMBLY
TF-32