1998 NISSAN GT-R battery location

POWER WINDOW SYSTEM
System Description
When the ignition switch is turned OFF, timer function allows
the driver door power window to operate for up to approxi-
mately
15 minutes. Opening (door switch ON) and closing
(door switch OFF) the driver door or entering the ignition switch
OFF to ON signal will reset the timer.
If the driver door window is obstructed when it is going up, the
window moves down approximately
150 mm.
OPERATING CONDITIONS
The driver door window is between fully-open position and
almost fully-closed position (with the limit switch
ON).
a Automatic operation when the ignition switch is turned ON
a Automatic or manual operation when the ignition switch is
turned to any position other than ON (with the timer active)
Precautions
When the driver door window is between fully-open position
and almost fully-closed position with the limit switch
ON,
removing or installing the battery or the power window main
switch will deactivate the auto
UP mode and the timer function.
If the step above has been taken, operate the power window
switch to close the driver door glass fully. This activates the
auto
UP mode and the timer function.
Component Parts Location
) Dash panel, driver side Driver door
power window motor (limit switch and encoder built-in)
(amplifier built-in) OCC3269D

IGNITION KEY-OPERATED ILLUMINATION SYSTEM
Behind combination meter Component Parts Location
Meter control unit
Circuit Diagram
7, . .
& Driver door lock detection switch
T
2 1 r Passenger door SW Rear RH door SW 326
' a
Rear LH door SW
3 - -
Room lamp
IGN SW illumination
TK24 (Brown) TK20 (Brown) TK20 (White) EL-2 178D I 1 J
Meter Control Unit Input/Output Signal
Terminal No.
Specifications I I
Specification
Approx.
OV
Approx. 12V
Approx. OV
Approx. 5V
Approx. 12V
Approx. OV
Approx. 12V
Approx. 12V
Approx. OV
Approx. 12V
Approx. OV
Approx. OV
Approx. 12V
Approx. OV'
Approx. 12V
Measuring condition
Signal name Ignition
Operation or condition
switch
Driver door switch ON (Open)
OFF Driver door switch
signal OFF (Closed)
Driver door lock
sig-
Door is unlocked. (Switch ON)
nal OFF
Door is locked. (Switch OFF)
Battery OFF
-
Open a door. (ON)
Door switch signal
OFF
Close all the doors. (OFF)
Ignition power supply ON
-
Key-in detection Remove
the ignition key.
switch signal OFF
Insert the ignition key.
Ground ON
-
OFF Room lamp switch:
Insert the ignition key. Each door switch
Room lamp, ignition Neutral position ON
(Open)
OFF (Closed)
switch illumination
Remove the ignition key from the
signal
- lamp switch: Close all the doors. key cylinder.
Neutral position
Turn the ignition switch ON.

REAR DEFOGGER AND HEATER MIRROR
Component
Parts Location
-- Behind combination meter
Circuit Diagram
Heater
10 A g28 81 1
Meter CIU
Rear defogger relay AIC auto ampl~f~er
. 0
z i 8 Rear defogger SW a (AC controller built-m)
mirror
u
Rear defogger TK20 (Brown) TK20 (White)
EL-2181 D
Meter Control Unit InputlOutput Signal
S~ecif ications
': It changes to approximately 12V when 15 minutes or 30 minutes pass after the ignition switch is turned ON.
Terminal No.
9
17
29
55
63
NOTE: Refer to "Auto Amplifier InputlOutput Signal Specifications".
Signal name
Battery
Rear defogger switch
signal
Ignition power supply
Ground
Rear defogger relay
control signal Specification
Approx.
12V
Approx. OV
Approx. 5V
Approx. 12V
Approx. OV
Approx. OV*
Approx. 12V
Measuring condition .
Ignition switch OFF
OFF ON
ON
ON Operation
-
Rear
defogger switch ON (with switch
pressed)
OFF (regardless of
connection of AIC auto
amplifier)
-
-
Rear defogger switch ON OFF