1998 MITSUBISHI MONTERO lock

[x] Cancel search: lock

Page 1349 of 1501

MITSUBISHI MONTERO 1998  Service Manual Rear Differential Lock Circuit
         WARNING SYSTEMS

Page 1355 of 1501

MITSUBISHI MONTERO 1998  Service Manual and remove. Disconnect all external solenoid and switch connections.
         3) On Montero 4WD, remove catalytic converter and front
exhaust pipe. On all models, disconnect speedometer cable and cont

Page 1356 of 1501

MITSUBISHI MONTERO 1998  Service Manual Torque Converter-To-Drive Plate Bolt  .......................  30 (41)\
Transmission-To-Engine Block Bolt  ..........................  55 (74)\
���������\
���������\
�������

Page 1359 of 1501

MITSUBISHI MONTERO 1998  Service Manual removed to drain fluid. Remove oil filter/screen if necessary.
         2) If oil filter/screen is replaced, tighten bolts to
specification. See TORQUE SPECIFICATIONS . Clean oil pan, replace
gasket,

Page 1360 of 1501

MITSUBISHI MONTERO 1998  Service Manual it contacts lock nut. See Fig. 1.
         4) Install outer section of kickdown service adjustment
assembly on lock nut. Rotate outer section to left and inner section
to right to contact lock nut wit

Page 1362 of 1501

MITSUBISHI MONTERO 1998  Service Manual Fig. 4:  Adjusting Shift Lever Sleeve (Eclipse & Galant)
Courtesy of Mitsubishi Motor Sales of America.
         NEUTRAL SAFETY SWITCH
          All Models
         Neutral safety switch is adjusted a

Page 1374 of 1501

MITSUBISHI MONTERO 1998  Service Manual Fires With Key     Flywheel runout contributes
released. Engine    to the intermittent nature
Fires and Cranks
Normally
���������\
���������\
���������\
���������\

Page 1375 of 1501

MITSUBISHI MONTERO 1998  Service Manual          problem symptoms.  For model-specific Trouble Shooting,
         refer to DIAGNOSTIC, or TESTING articles available in the
         section(s) you are accessing.
BASIC HEATER SYSTEM TROUBLE S