1998 MITSUBISHI LANCER EVOLUTION IV differential

REAR SUSPENSION – Rear Suspension Assembly34-5
REMOVAL SERVICE POINTS
ABRAKE CALIPER ASSEMBLY REMOVAL
Remove the brake caliper assembly and secure it with a
wire.
BPROPELLER SHAFT DISCONNECTION
(1) Make an alignment mark on the differential carrier
companion flange and propeller shaft flange yoke.
(2) Remove the mounting bolts and nuts of the differential
carrier and propeller shaft.
CCROSSMEMBER MOUNTING BOLT REMOVAL
Support the differential case with a garage jack or transmission
jack and then remove the crossmember mounting bolt.
INSTALLATION SERVICE POINTS
ACROSSMEMBER MOUNTING BOLT
INSTALLATION
Tighten the mounting bolts in the numerical order shown.
NOTE
To ensure both good installation accuracy and ease of
installation, the crossmember mounting holes have different
diameters between front and rear. This is the reason for
specifying the tightening sequence of the mounting bolts.
BPROPELLER SHAFT CONNECTION
Align the alignment mark on the differential carrier with that
of the propeller shaft at installation.
Caution
Oil or grease on the threads of the mounting bolt or nut
can allow the bolt or nut to come loose. Be sure to
degrease the threads before installation.
Bolt size (thread dia. × length mm)
1 to 3: Flange bolt (with washer) 12 × 70
4: Flange bolt (with washer) 12 × 152
5: Bolt (with spring washer + washer) 12 × 105 Front of vehicle
13
3
44
2
55

BODY –
Body Dimension
42-10
6911
indicates that the dimension and the measurement point are the same as those for EVOLUTION-IV.
Unit: mm
13
12
22122
20
65
1,199
103
812
842920
31211 6
275
1,068
No.Standard measurement pointHole _ Size
shape mmNo.Standard measurement pointHole _ Size
shape mm
11Center of strut insulator
– 11 065Trailing arm mounting position–
12Center of suspension crossmember mounting hole
– 1569Center of rear shock absorber mounting hole
– 68
13Center of suspension crossmember mounting hole
– 1670Control link mounting position–
20Differential mounting bolt end–71Center of upper link mounting hole
– 14
21Center of suspension crossmember mounting hole
– 1472Center of upper link mounting hole
– 14
22Center of suspension crossmember mounting holeLeft:
– 13.5
Right:– 12.2 × 14

BODY –
Body Dimension
42-14
2, 13
65
2012
indicates that the dimension and the measurement point are the same as those for EVOLUTION-IV.
132
2122
21, 22
No.Standard measurement pointHole _ Size
shape mmNo.Standard measurement pointHole _ Size
shape mm
2Center of suspension crossmember mounting holeLeft:
– 14
Right:
– 1621Center of suspension crossmember mounting hole
– 14
12Center of suspension crossmember mounting hole
– 1522Center of suspension crossmember mounting holeLeft:
– 13.5
Right:– 12.2 × 14
13Center of suspension crossmember mounting hole
– 1665Trailing arm mounting position–
20Differential mounting bolt end–70Control link mounting position–