1998 Lexus LS400 transmission

IN CASE OF AN EMERGENCY
196
CAUTION
When making the connections, to avoid serious injury, do not
lean over the battery or accidentally let the jumper cables or
clamps touch anything except the correct battery terminals or
the ground.
5. Start your engine in the normal way. After starting, run it at about
2000 rpm for several minutes with the accelerator pedal lightly
depressed.
6. Carefully disconnect the cables in the exact reverse order: the
negative cable and then the positive cable.
7. Carefully dispose of the battery cover cloths which may now
contain sulfuric acid.
8. If removed, replace all the battery vent plugs.
If the cause of your battery discharging is not apparent (for example,
lights left on), you should have it checked.
IF YOUR VEHICLE OVERHEATS
If your engine coolant temperature gauge indicates overheating,
if you experience a loss of power, or if you hear a loud knocking
or pinging noise, the engine has probably overheated.
When the engine overheats
Pull safely off the road, stop the vehicle and turn on your emergency
flashers. Put the transmission in ”P” and apply the parking brake.
A: If steam is coming from your engine:
Turn off the engine. Leave the hood closed until there is no sign of
steam or coolant. Your engine could have been seriously damaged
already. Call your Lexus dealer for assistance.
CAUTION
To help avoid personal injury, keep the hood closed until there
is no steam. Escaping steam or coolant is sign of very high
pressure.

IN CASE OF AN EMERGENCY
197 B: If no steam is coming from your engine:
Leave the engine running and turn off the air conditioning. Check
the following.
Is the cooling fan operating?
Is the coolant in the acceptable range?
Is the engine drive belt O.K.?
CAUTION
When the engine is running, keep hands and clothing away
from the moving fan and engine drive belt.
Do not attempt to remove the radiator cap when the engine
and radiator are hot. Serious injury could result from
scalding hot fluid and steam blown out under pressure.
If the cooling fan is not operating or the coolant is not in the
acceptable range, turn off the engine and call your Lexus dealer.
If both conditions are O.K., after the engine coolant temperature has
cooled to normal, continue driving your vehicle.
If the engine coolant temperature does not cool down, or your
vehicle overheats again, have it checked as soon as possible by your
Lexus dealer.
IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line. Move
cautiously off the road to a safe place well away from the traffic.
Avoid stopping on the center divider of a highway. Park on a level
spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission in ”P”.
4. Have everyone get out of the vehicle on the side away from
traffic.
5. Read the following instructions thoroughly.
NOTICE
For vehicles equipped with the height control switch, be sure to
turn the ignition switch off before jacking. If this is not done, the
vehicle height adjustment function will operate, which may
cause body damage.
CAUTION
When jacking, be sure to observe the following to reduce the
possibility of personal injury:
Follow jacking instructions.
Do not start or run the engine while your vehicle is
supported by the jack.

IN CASE OF AN EMERGENCY
198Stop the vehicle on a level firm ground, firmly set the
parking brake and put the transmission in ”P”. Block the
wheel diagonally opposite to the one being changed if
necessary.
Make sure to set the jack properly in the jack point. Raising
the vehicle with jack improperly positioned will damage
the vehicle or may allow the vehicle to fall off the jack and
cause personal injury.
Never get under the vehicle when the vehicle is supported
by the jack alone.
Use the jack only for lifting your vehicle during wheel
changing.
Do not raise the vehicle with someone in the vehicle.
When raising the vehicle, do not put an object on or under
the jack.
Raise the vehicle only high enough to remove and change
the tire.
NOTICE
Do not continue driving with a deflated tire. Driving even a short
distance can damage a tire beyond repair.
40L003-1
1
Tool box 2
Jack 3
Spare tire 4
Jack handle
1. Get the tool, jack and spare tire.
To prepare yourself for an emergency, you should familiarize
yourself with the use of the jack and each tool, and their storage
locations.

IN CASE OF AN EMERGENCY
205
IF YOUR VEHICLE NEEDS TO BE
TOWED
If towing is necessary, we recommend you to have it done by your
Lexus dealer or a commercial tow truck service. In consultation
with them, have your vehicle towed using either (a) or (b).
(a) Towing with a wheel lift type truck
(b) Using a flat bed truck
(c) Never tow with a sling type truck
Only when you cannot receive a towing service from a Lexus
dealer or commercial tow truck service, tow your vehicle
carefully in accordance with the instructions given in ”(d)
Emergency towing” on page 208.
Proper equipment will help ensure that your vehicle is not damaged
while being towed. Commercial operators are generally aware of the
state/provincial and local laws pertaining to towing.
Your vehicle can be damaged if it is towed incorrectly. Although
most operators know the correct procedure, it is possible to make a
mistake. To avoid damage to your vehicle, make sure the following
few precautions are observed. If necessary, show this page to the tow
truck driver.
TOWING PRECAUTIONS:
Use a safety chain system for all towing, and abide by the
state/provincial and local laws. The wheels and axle on the ground
must be in good condition. If they are damaged, use a towing dolly.
(a) Towing with a wheel lift type truck
From front
40L021
Use a towing dolly under the rear wheels.
NOTICE
Never tow a vehicle with an automatic transmission from the
front with rear wheels on the ground, as this may cause serious
damage to the transmission.

IN CASE OF AN EMERGENCY
209
CAUTION
Use extreme caution when towing the vehicle. Avoid sudden
starts or erratic driving maneuvers which would place
excessive stress on the emergency towing eyelet and towing
cable or chain. The eyelet and towing cable or chain may
break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in towing
vehicles. Securely fasten the cable or chain to the towing eyelet
provided.
Before towing, release the parking brake and put the transmission in
”N”. The ignition key must be in ”ACC” (engine off) or ”ON”
(engine running).
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work so steering and braking will be much
harder than usual.
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION
SELECTOR LEVER
40L025-3
If you cannot shift the selector lever, use the shift lock override
button as follows:
1
Turn the ignition key to ”LOCK” or ”ACC”. Make sure the
parking brake is applied. Pry up the cover with a flatbladed
screwdriver or equivalent.

MAINTENANCE
216Parking brake
Check that the pedal has the proper travel and that, on a safe incline,
your vehicle is held securely with only the parking brake applied.
Automatic transmission ”Park” mechanism
On a safe incline, check that your vehicle is held securely with the
selector lever in ”P” position and all brakes released.
Engine compartment
Items listed below should be checked from time to time, e.g. each
time when refueling.
Washer fluid
Make sure there is sufficient fluid in the tank. See page 261 for
additional information.
Engine coolant level
Make sure the coolant level is between the Upper and Lower lines
on the seethrough reservoir when the engine is cold. See page 233
for additional information.
Battery
Your Lexus has a maintenance free battery. You do not have to add
distilled water. For longer life of the battery, however, see page 253
for additional information.
Brake fluid level
Make sure the brake fluid level is correct. See page 239 for
additional information.Engine oil level
Check the level on the dipstick with the engine turned off and the
vehicle parked on a level spot. See page 230 for additional
information.
Power steering fluid level
Check the level on the dipstick. The level should be in the ”HOT”
or ”COLD” range depending on the fluid temperature. See page 240
for additional information.
Exhaust system
Look for cracks, holes and loose supports. If you notice any change
in the sound of the exhaust or smell exhaust fumes, have the cause
located and corrected immediately. (See engine exhaust cautions in
Section 31.)

INTRODUCTION
222Remember that battery and ignition cables carry high
currents or voltages. Be careful of accidentally causing a
short circuit.
Before closing the engine hood, check to see that you have not
forgotten any tools, rags, etc.
Do not drive with the air cleaner removed, or excessive engine
wear could result. Also backfiring could cause a fire in the
engine compartment.
Do not overfill automatic transmission fluid, or the
transmission could be damaged.
Be careful not to scratch the glass surface with the wiper
frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform
doityourself maintenance. Remember all Lexus parts are
designed in metric sizes, so your tools must be metric.
Checking the engine oil level
Parts (if level is low):
Use API grade SH, ”EnergyConserving II” or SJ,
”EnergyConserving” multigrade engine oil or ILSAC
multigrade engine oil. For recommended oil viscosity, see page
232.
Tools:
Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
Ethyleneglycol coolant
Demineralized or distilled water
Tools:
Funnel (only for adding coolant)

INTRODUCTION
223
Checking brake fluid
Parts (if level is low):
FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:
Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):
Automatic transmission fluid DEXRON
II or III
Tools:
Rag or paper towel
Funnel (only for adding fluid)
Checking battery condition
Nonmaintenance batteries
Tools:
Warm water
Baking soda
Grease
Conventional wrench (for terminal clamp bolts)
Maintenance type batteries
Parts (if level is low):
Distilled waterTools:
Warm water
Baking soda
Grease
Conventional wrench (for terminal clamp bolts)
Coin (for vent plugs)
Funnel (only for adding distilled water)
Checking and replacing the blade type fuses
Parts (if replacement is necessary):
Fuse with same amperage rating as original
Checking the cartridge type fuses
Parts (if replacement is necessary):
Genuine Lexus fuse or equivalent with same amperage rating as
original
Adding washer fluid
Parts:
Water
Washer fluid containing antifreeze (for winter use)
Tools:
Funnel