INTRODUCTION
222Remember that battery and ignition cables carry high
currents or voltages. Be careful of accidentally causing a
short circuit.
Before closing the engine hood, check to see that you have not
forgotten any tools, rags, etc.
Do not drive with the air cleaner removed, or excessive engine
wear could result. Also backfiring could cause a fire in the
engine compartment.
Do not overfill automatic transmission fluid, or the
transmission could be damaged.
Be careful not to scratch the glass surface with the wiper
frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform
do it yourself maintenance. Remember all Lexus parts are
designed in metric sizes, so your tools must be metric.
Checking the engine oil level
Parts (if level is low):
Use API grade SH, ”Energy Conserving II” or SJ,
”Energy Conserving” multigrade engine oil or ILSAC
multigrade engine oil. For recommended oil viscosity, see page
232.
Tools:
Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
Ethylene glycol coolant
Demineralized or distilled water
Tools:
Funnel (only for adding coolant)
ENGINE
231
62L002-1
1
Add oil 2
O.K. 3
Too full
4. Pull the dipstick out and look at the oil level on the end. If it is
between the full line (
5
) and the low line ( 4
), it is O.K.
62L003-3
If the oil level is below or only slightly above the low line, add
engine oil of the same type as already in the engine.Remove the oil filler cap and add engine oil a little at a time, checking
the dipstick. The approximate quantity of oil needed to fill between
the low line and the full line on the dipstick is indicated below for
reference.
When the level reaches within the correct range, return the filler cap
and turn the cap clockwise until you hear a click.
Oil quantity. L (qt., lmp. qt.) 1.5 (1.6, 1.3)
NOTICE
Avoid overfilling, or the engine could be damaged. Check the oil
level on the dipstick once again after adding the oil.