1998 Lexus LS400 brake

IN CASE OF AN EMERGENCY
193
IF YOUR ENGINE STALLS WHILE
DRIVING
If your engine stalls while driving . . . .
1. Reduce your speed gradually, keeping a straight line. Move
cautiously off the road to a safe place.
2. Turn on your emergency flashers.
3. Try starting the engine again.
If the engine will not start, see ”If your vehicle will not start”.
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work, so steering and braking will be much
harder than usual.
IF YOUR VEHICLE WILL NOT
START
(a) Simple checks
Before making these checks, make sure you have followed the
correct starting procedure instructions in ”How to start the engine”
on page 159 and that you have sufficient fuel. Since your vehicle is
equipped with the engine immobiliser system, also check whether
the other keys will start the engine. If they work, your key may be
broken. Have the key checked at your Lexus dealer. If none of your
keys work, the system is possibly broken. Call your Lexus dealer.
See ”Keys” on page 8.If the engine is not turning over or is turning over too slowly
1. Check that the battery terminals are tight and clean.
2. If the battery terminals are O.K., switch on the interior light.
3. If the light is out, dim or goes out when the starter is cranked, the
battery is discharged. You may try jump starting. See ”(c) Jump
starting” for further instruction.
If the light is O.K., but the engine still will not start, it needs
adjustment or repair. Call a Lexus dealer, Roadside Assistance or
Customer Service Assistance. (See ”Foreword”.)
NOTICE
Do not pull or pushstart the vehicle. It may damage the
vehicle or cause a collision when the engine starts. Also the
threeway catalytic converter may overheat and become a fire
hazard.
If the engine turns over at its normal speed but will not start
1. The engine may be flooded because of repeated cranking. See
”(b) Starting a flooded engine” for further instructions.
2. If the engine still will not start, it needs adjustment or repair. Call
a Lexus dealer, Roadside Assistance or Customer Service
Assistance. (See ”Foreword”.)

IN CASE OF AN EMERGENCY
196
CAUTION
When making the connections, to avoid serious injury, do not
lean over the battery or accidentally let the jumper cables or
clamps touch anything except the correct battery terminals or
the ground.
5. Start your engine in the normal way. After starting, run it at about
2000 rpm for several minutes with the accelerator pedal lightly
depressed.
6. Carefully disconnect the cables in the exact reverse order: the
negative cable and then the positive cable.
7. Carefully dispose of the battery cover cloths which may now
contain sulfuric acid.
8. If removed, replace all the battery vent plugs.
If the cause of your battery discharging is not apparent (for example,
lights left on), you should have it checked.
IF YOUR VEHICLE OVERHEATS
If your engine coolant temperature gauge indicates overheating,
if you experience a loss of power, or if you hear a loud knocking
or pinging noise, the engine has probably overheated.
When the engine overheats
Pull safely off the road, stop the vehicle and turn on your emergency
flashers. Put the transmission in ”P” and apply the parking brake.
A: If steam is coming from your engine:
Turn off the engine. Leave the hood closed until there is no sign of
steam or coolant. Your engine could have been seriously damaged
already. Call your Lexus dealer for assistance.
CAUTION
To help avoid personal injury, keep the hood closed until there
is no steam. Escaping steam or coolant is sign of very high
pressure.

IN CASE OF AN EMERGENCY
197 B: If no steam is coming from your engine:
Leave the engine running and turn off the air conditioning. Check
the following.
Is the cooling fan operating?
Is the coolant in the acceptable range?
Is the engine drive belt O.K.?
CAUTION
When the engine is running, keep hands and clothing away
from the moving fan and engine drive belt.
Do not attempt to remove the radiator cap when the engine
and radiator are hot. Serious injury could result from
scalding hot fluid and steam blown out under pressure.
If the cooling fan is not operating or the coolant is not in the
acceptable range, turn off the engine and call your Lexus dealer.
If both conditions are O.K., after the engine coolant temperature has
cooled to normal, continue driving your vehicle.
If the engine coolant temperature does not cool down, or your
vehicle overheats again, have it checked as soon as possible by your
Lexus dealer.
IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line. Move
cautiously off the road to a safe place well away from the traffic.
Avoid stopping on the center divider of a highway. Park on a level
spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission in ”P”.
4. Have everyone get out of the vehicle on the side away from
traffic.
5. Read the following instructions thoroughly.
NOTICE
For vehicles equipped with the height control switch, be sure to
turn the ignition switch off before jacking. If this is not done, the
vehicle height adjustment function will operate, which may
cause body damage.
CAUTION
When jacking, be sure to observe the following to reduce the
possibility of personal injury:
Follow jacking instructions.
Do not start or run the engine while your vehicle is
supported by the jack.

IN CASE OF AN EMERGENCY
198Stop the vehicle on a level firm ground, firmly set the
parking brake and put the transmission in ”P”. Block the
wheel diagonally opposite to the one being changed if
necessary.
Make sure to set the jack properly in the jack point. Raising
the vehicle with jack improperly positioned will damage
the vehicle or may allow the vehicle to fall off the jack and
cause personal injury.
Never get under the vehicle when the vehicle is supported
by the jack alone.
Use the jack only for lifting your vehicle during wheel
changing.
Do not raise the vehicle with someone in the vehicle.
When raising the vehicle, do not put an object on or under
the jack.
Raise the vehicle only high enough to remove and change
the tire.
NOTICE
Do not continue driving with a deflated tire. Driving even a short
distance can damage a tire beyond repair.
40L003-1
1
Tool box 2
Jack 3
Spare tire 4
Jack handle
1. Get the tool, jack and spare tire.
To prepare yourself for an emergency, you should familiarize
yourself with the use of the jack and each tool, and their storage
locations.

IN CASE OF AN EMERGENCY
208
(c) Towing with a sling type truck
40L0231
NOTICE
Do not tow with a sling type truck, either from the front or rear.
This may cause body damage.
(d) Emergency towing
40L0311
If towing is necessary, we recommend you to have it done by your
Lexus dealer or a commercial tow truck service.
If towing service is not available in an emergency, your vehicle
may be temporarily towed by a cable or chain secured to the
emergency towing eyelet. Use extreme caution when towing the
vehicle.
A driver must be in the vehicle to steer it and operate the brakes.
Towing in this manner may be done only on hardsurfaced roads for
a short distance and at low speeds. Also, the wheels, axles, drive
train, steering and brakes must all be in good condition.

IN CASE OF AN EMERGENCY
209
CAUTION
Use extreme caution when towing the vehicle. Avoid sudden
starts or erratic driving maneuvers which would place
excessive stress on the emergency towing eyelet and towing
cable or chain. The eyelet and towing cable or chain may
break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in towing
vehicles. Securely fasten the cable or chain to the towing eyelet
provided.
Before towing, release the parking brake and put the transmission in
”N”. The ignition key must be in ”ACC” (engine off) or ”ON”
(engine running).
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work so steering and braking will be much
harder than usual.
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION
SELECTOR LEVER
40L025-3
If you cannot shift the selector lever, use the shift lock override
button as follows:
1
Turn the ignition key to ”LOCK” or ”ACC”. Make sure the
parking brake is applied. Pry up the cover with a flatbladed
screwdriver or equivalent.

IN CASE OF AN EMERGENCY
210
40L026-3
2
Insert your finger, the screwdriver or equivalent into the hole
to push down the shift lock override button. You can shift the
selector lever while pushing the button.
For your safety, keep the brake pedal depressed.
Be sure to have the system checked by your Lexus dealer as soon as
possible.
IF YOU LOSE YOUR KEYS OR
LOCK YOURSELF OUT
Many Lexus dealers can make a new key if you can give them the
key number. Since your vehicle is equipped with the engine
immobiliser system, the dealer will also need your master key.
See the suggestion given in ”Keys” on page 8.
If your keys are locked in the vehicle and you cannot get a duplicate,
many Lexus dealers can still open the door for you, using their
special tools. If you must break a window to get in, we suggest
breaking the smallest side window because it is the least expensive
to replace. Be extremely cautious to avoid cuts from the glass.
Even if you lose only one key, contact your Lexus dealer to make a
new key. If you lose all your master keys, you cannot make new
keys; the whole system must be replaced.

MAINTENANCE
215 Tire rotation
Rotate the tires every 12000 km (7500 miles). See page 242 for
additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid after the
vehicle has been parked for a while. If you smell fuel fumes or notice
any leak, have the cause found and corrected immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate smoothly and all
latches lock securely. Make sure the engine hood secondary latch
secures the hood when the primary latch is released.
Vehicle interior
Items listed below should be checked regularly, e.g. while
performing periodic services, cleaning the vehicle, etc.
Lights
Make sure the headlights, stop lights, tail lights, turn signal lights,
and other lights are working. Check headlight aim.
Service reminder indicators and warning buzzers
Check that all service reminder indicators and warning buzzers
function properly.Steering wheel
Check that it has the specified freeplay. Be alert for changes in
steering condition, such as hard steering, excessive freeplay or
strange noise.
Seats
Check that all front seat controls such as seat adjusters, seatback
recliner, etc. operate smoothly. Check that the head restraints move
up and down smoothly and that the locks hold securely in any latched
position.
Seat belts
Check that the seat belt system such as buckles, retractors and
anchors operate properly and smoothly. Make sure the belt webbing
is not cut, frayed, worn or damaged.
Accelerator pedal
Check the pedal for smooth operation and uneven pedal effort or
catching.
Brake pedal
Check the pedal for smooth operation and the proper clearance and
freeplay. Check the brake booster function.
Brakes
At a safe place, check that the brakes do not pull to one side when
applied.