1998 Lexus LS400 weight

DRIVING TIPS
185
Hitches
If you wish to install a trailer hitch, your Lexus dealer should be
consulted.
Use only a hitch which is recommended by the hitch
manufacturer and conforms to the total trailer weight
requirement.
Follow the directions supplied by the hitch manufacturer.
Lubricate the hitch ball with a light coat of grease.
Lexus recommends removing the trailer hitch whenever you are
not towing a trailer to reduce the possibility of additional damage
caused by the hitch if your vehicle is struck from behind. After
removing the hitch, seal any mounting holes in the vehicle body
to prevent entry of pollutants such as exhaust fumes, dirt, water,
etc.
NOTICE
Install the trailer hitch using only the position recommended
by your Lexus dealer. Do not install the trailer hitch on the
bumper; this may cause body damage.
Do not use axlemounted hitches as they can cause damage
to the axle housing, wheel bearings, wheels or tires.
Brakes and safety chains
Lexus recommends trailers with brakes that conform to any
applicable federal and state/provincial regulations.
A safety chain must always be used between the towing
vehicle and the trailer. Leave sufficient slack in the chain for
turns. The chain should cross under the trailer tongue to
prevent the tongue from dropping to the ground in case it
becomes damaged or separated. For correct safety chain
procedures, follow the hitch or trailer manufacturer’s
recommendations.
CAUTION
If the total trailer weight exceeds 450 kg (1000 lb.), trailer
brakes are required.
Never tap into your vehicle’s hydraulic system as it will
lower its braking effectiveness.
Never tow a trailer without using a safety chain securely
attached to both the trailer and the vehicle. If damage
occurs to the coupling unit or hitch ball, there is possible
danger of the trailer wandering over into another lane.

DRIVING TIPS
186
Tires
Ensure that your vehicle’s tires are properly inflated. Adjust the
tire pressure to the recommended cold tire pressure indicated
below:
Tire pressure, kPa (kgf/cm
2 or bar, psi)
Front 220 (2.2, 32)
Rear 220 (2.2, 32)
The trailer tires should be inflated to the pressure recommended
by the trailer manufacturer in respect to the total trailer weight.
Trailer lights
Trailer lights must comply with federal, state/provincial and local
regulations. See your local recreational vehicle dealer or rental
agency for the correct type of wiring and relays for your trailer.
Check for correct operation of the turn signals and stop lights
each time you hitch up. Direct splicing may damage your
vehicle’s electrical system and cause a malfunction of your lights.
Breakin schedule
Lexus recommends that you do not tow a trailer with a new
vehicle or a vehicle with any new power train component (engine,
transmission, differential, wheel bearing, etc.) for the first 800 km
(500 miles) of driving.
Maintenance
If you tow a trailer, your vehicle will require more frequent
maintenance due to the additional load. For this information,
please refer to the scheduled maintenance information in the
”Owner ’s Manual Supplement/ Maintenance Schedule”.
Retighten all fixing bolts of the towing ball and bracket after
approximately 1000 km (600 miles) of trailer driving.
Pretowing safety check
Check that your vehicle remains level when a loaded or unloaded
trailer is hitched. Do not drive if the vehicle has an abnormal
noseup or nosedown condition, and check for improper tongue
load, overload, worn suspension or other possible causes.
Make sure the trailer cargo is securely loaded so that it cannot
shift.
Check that your rear view mirrors conform to any federal,
state/provincial or local regulation. If they do not, install required
rear view mirrors appropriate for towing purposes.

DRIVING TIPS
189
HOW TO SAVE FUEL AND MAKE
YOUR VEHICLE LAST LONGER
Getting more kilometer/mileage from a liter/gallon of fuel is easy
just take it easy. It will help make your vehicle last longer, too. Here
are some specific tips on how to save money on both fuel and repairs:
Keep your tires inflated at the correct pressure. Check the
pressure every two weeks, or at least once a month.
Underinflation causes tire wear and wastes fuel.
Do not carry unneeded weight in your vehicle. Excess weight
puts a heavier load on the engine, causing greater fuel
consumption.
Avoid lengthy warmup idling. Once the engine is running
smoothly, begin driving but gently. Remember, however, that
on cold winter days this may take a little longer.
Accelerate slowly and smoothly. Avoid jackrabbit starts.
Avoid long engine idling. If you have a long wait and you are
not in traffic, it is better to turn off the engine and start again later.
Avoid engine overrevving. Use a gear position suitable for the
road on which you are traveling.
Avoid continuous speeding up and slowing down.
Stopandgo driving wastes fuel.Avoid unnecessary stopping and braking. Maintain a steady
pace. Try to time the traffic signals so you only need to stop as
little as possible or take advantage of through streets to avoid
traffic lights. Keep a proper distance from other vehicles to avoid
sudden braking. This will also reduce wear on your brakes.
Avoid heavy traffic or traffic jams whenever possible.
Do not rest your foot on the brake pedal. This causes needless
wear, overheating and poor fuel economy.
Maintain a moderate speed on highways. The faster you drive,
the greater the fuel consumption. By reducing your speed, you
will cut down on fuel consumption.
Keep the front wheels in proper alignment. Avoid hitting the
curb and slow down on rough roads. Improper alignment not only
causes faster tire wear but also puts an extra load on the engine,
which, in turn, wastes fuel.
Keep the bottom of your vehicle free from mud, etc. This not
only lessens weight but also helps prevent corrosion.
Keep your vehicle tunedup and in top shape. A dirty air
cleaner, improper valve clearance, dirty plugs, dirty oil and
grease, brakes not adjusted, etc. all lower engine performance and
contribute to poor fuel economy. For longer life of all parts and
lower operating costs, keep all maintenance work on schedule,
and if you often drive under severe conditions, see that your
vehicle receives more frequent maintenance. (For scheduled
maintenance information, please refer to the separate ”Owner’s
Manual Supplement/Maintenance Schedule”.)
CAUTION

CHASSIS
238 STEERING
Freeplay
Power steering fluid
Less than 30 mm (1.2 in.)
Automatic transmission fluid DEXRONII or III
TIRES AND WHEELS
Tire size
Tire inflation pressure
Recommended cold tire inflation pressure
Vehicle load up to four occupants
Vehicle loaded up to vehicle capacity weight
Wheel size
Wheel nut torque
P225/60R16 97V
Front 200 kPa (2.0 kgf/cm
2
or bar, 29 psi)
Rear 200 kPa (2.0 kgf/cm2 or bar, 29 psi)
Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
For sustained high speeds above 160 km/h (100 mph), in
countries where such speeds are permitted by law, add 80 kPa (0.9
kgf/cm
2, 0.8 bar, 12 psi) to the front tires and rear tires, but never
exceed the maximum cold tire pressure molded on the tire
sidewall.
16 x 7 JJ
103 N·m (10.5 kgf·m, 76 ft·lbf.)

CHASSIS
241
CAUTION
The reservoir may be hot so be careful not to burn yourself.
NOTICE
Avoid overfilling, or the power steering could be damaged.
When adding the power steering fluid, avoid spilling it. The
generator under the power steering reservoir could be
damaged if fluid is spilled on it.
CHECKING TIRE PRESSURE
63L004-1
The recommended cold tire pressures, tire size and the vehicle
capacity weight are given on the label inside the glovebox lid.
You should check the tire pressures every two weeks, or at least once
a month. And don’t forget the spare! The pressure for the spare tire
should be 220 kPa (2.2 kgf/cm
2 or bar, 32 psi). Incorrect tire pressure
can reduce tire life and make your vehicle less safe to drive.
Low tire pressure results in excessive wear, poor handling, reduced
fuel economy, and the possibility of blowouts from overheated tires.
Also, low tire pressure can cause poor sealing of the tire bead. If the
tire pressure is excessively low, there is the possibility of wheel
deformation and/or tire separation. So keep your tire pressures at the
proper level. If a tire needs frequent refilling, have it checked by
your Lexus dealer.

CHASSIS
242High tire pressure produces a harsh ride, handling problems,
excessive wear at the center of the tire tread, and a greater possibility
of tire damage from road hazards.
The following instructions for checking tire pressure should be
observed:
The pressure should be checked only when the tires are cold.
If your vehicle has been parked for at least 3 hours and has not
been driven for more than 1.5 km or 1 mile since, you will get an
accurate cold tire pressure reading.
Always use a tire pressure gauge. The appearance of the tire can
be misleading. Besides, tire pressures that are even just a few
pounds off can degrade handling and ride.
Do not bleed or reduce tire pressure after driving. It is normal
for the tire pressure to be higher after driving.
Never exceed the vehicle capacity weight. The passengers and
luggage weight should be located so that the vehicle is balanced.
Be sure to reinstall the tire valve caps. Without the valve caps,
dirt or moisture could get into the valve core and cause air
leakage. If the caps have been lost, have new ones put on as soon
as possible.
ROTATING TIRES
63L007-2
To equalize tire wear and help extend tire life, Lexus
recommends that you rotate your tires approximately every
12000 km (7500 miles). However, the most appropriate timing
for tire rotation may vary according to your driving habits and
road surface conditions.
The wheel assemblies must be rotated as illustrated above. If the
optional chromeplated wheels are mounted, rotate them as pattern
A. For the standard wheels, use pattern B.
When rotating tires, check for uneven wear and damage. Abnormal
wear is usually caused by incorrect tire pressure, improper wheel
alignment, outof balance wheels, or severe braking.
Before storing radial, snow or studded tires, mark the direction of
rotation and be sure to install them in the same direction when using
them again. Tires should be stored in a cool dry place.

CHASSIS
247
REPLACING WHEELS
When to replace your wheels
If you have wheel damage such as bending, cracks or heavy
corrosion, the wheel should be replaced.
If you fail to replace damaged wheels, a tire may slip off a wheel or
they may cause loss of handling control.
Replacement with used wheels is not recommended as they may
have been subjected to rough treatment or high mileage and could
fail without warning. Also, bent wheels which have been
straightened may have hidden structural damage and therefore
should not be used. Never use an inner tube in a leaking wheel which
is designed for a tubeless tire.
Wheel selection
When replacing wheels, care should be taken to ensure that they
are equivalent to those removed in load capacity, diameter, rim
width, and offset.
Correct replacement wheels are available at your Lexus dealer.
A wheel of a different size or type may adversely affect handling,
wheel and bearing life, brake cooling, speedometer/odometer
calibration, stopping ability, headlight aim, bumper height, vehicle
ground clearance, and tire or snow chain clearance to the body and
chassis.
ALUMINUM WHEEL
PRECAUTIONS
After driving your vehicle the first 1600 km (1000 miles), check
that the wheel nuts are tight.
If you have rotated, repaired, or changed your tires, check that the
wheel nuts are still tight after driving 1600 km (1000 miles).
When using tire chains, be careful not to damage the aluminum
wheels.
Use only the Lexus wheel nuts and wrench designed for your
aluminum wheels.
When balancing your wheels, use only Lexus balance weights or
equivalent and a plastic or rubber hammer.
As with any wheel, periodically check your aluminum wheels for
damage. If damaged, replace immediately.
SUSPENSION AND CHASSIS
CAUTION
Do not modify the suspension/chassis with lift kits, spacers,
springs, etc. It can cause dangerous handling characteristics,
resulting in loss of control.

BODY
269
SPECIFICATIONS
DIMENSIONS AND WEIGHT
Overall length
Overall width
Overall height
Wheelbase
Tread Front
Rear
Vehicle capacity weight (occupants + luggage)
4995 mm (196.7 in.)
1830 mm (72.0 in.)
1435 mm (56.4 in.)*
2850 mm (112.2 in.)
1575 mm (62.0 in.)
1575 mm (62.0 in.)
410 kg (900 lb.)
*: Unladen vehicle
FUEL TANK
Capacity
85 L (22.5 gal., 18.7 lmp.gal.)