1998 Lexus ES300 reverse light

BE003±4
Note: When the cruise control is being used, even if you downshift the transmissio\
n by turning off the overdrive switch, engine braking will
not be applied because the cruise control is not cancelled. For the operat\
ion to decrease the vehicle speed, see page 146.
Parking, engine starting and key
removal position
Reverse position
Neutral position
Normal driving position
Position for engine braking
Position for stronger engine braking
than that in º2º position
With the brake pedal depressed, shift
while holding the lock release button
in. (The ignition switch must be in
ºONº position.)
Shift while holding the lock release
button
Overdrive switch
ºOFFº position
(Shifting into
overdrive not
possible)
ºO/D OFFº indicator
light on the instrument
cluster
For selecting either a three±speed or
four±speed transmission
ºONº position
(Shifting into
overdrive possible)
Lock release button (To prevent misshifting)
BASIC OPERATION ± QUICK REFERENCE
3
3. AUTOMATIC TRANSMISSION

IN CASE OF AN EMERGENCY165
JUMP STARTING PROCEDURE
1. If the booster battery is installed in another vehicle, make sure the vehi\
cles
are not touching. Turn off all unnecessary lights and accessories.
2. If required, remove all the vent plugs from the booster battery. Lay a cloth
over the open vents on the booster battery. (This helps reduce the explosion
hazard, personal injuries and burns.)
3. If the engine in the vehicle with the booster battery is not running, st\
art it
and let it run for about 5 minutes. During jump starting, run the engine a\
t about
2000 rpm with the accelerator pedal lightly depressed.
4. Locate
positive (+) and negative (±) terminals of each battery. Connect the
jumper cables in the exact order (
1
2 3 4) shown in the illustration.
1
Connect a positive (red) jumper cable clamp to the positive (+) terminal
of the discharged battery.
2Connect the clamp at the other end of the positive (red) cable to the
positive (+) terminal of the booster battery.
3Connect a negative (black) cable clamp to the negative (±) terminal of
the booster battery.
4Connect the clamp at the other end of the negative (black) cable to a
solid, stationary, unpainted metallic point (e.g. cylinder head) away
from the battery. Do not connect it to or near any part that moves when
the engine is cranked.
CAUTION
When making the connections, to avoid serious injury, do not
lean over the battery or accidentally let the jumper cables or
clamps touch anything except the correct battery terminals or
the ground.
5. Start your engine in the normal way. After starting, run it at about 2000 rpm
for several minutes with the accelerator pedal lightly depressed. 6. Carefully disconnect the cables in the exact reverse order: the negative
cable and then the positive cable.
7. Carefully dispose of the battery cover cloths which may now contain
sulfuric acid.
8. If removed, replace all the battery vent plugs.
If the cause of your battery discharging is not apparent (for example, lights left
on), you should have it checked.