INTERIOR EQUIPMENT43
OVERHEAD CONSOLE BOX
Garage door opener box
The box is designed to store a garage door opener transmitter.
14E041
1. Open the cover of the overhead console box.
2. Remove the Velcro loop.
3. Remove the paper strip covering the adhesive on back side of loop.
4. Adhere loop to back side of the transmitter near center.
14E042
Please note if transmitter has wire clip for sun visor, this clip must be removed
prior to adhesion of Velcro.
14E043
5. Place the transmitter, with Velcro loop facing inside of the box, into
overhead console box. Make sure the transmitter button is located above
button pins.
14E044±1
6. Remove spacers from the cover. Place largest spacer on the pin that would
be below the transmitter button when the cover is closed. Close the cover\
.
