1998 Lexus ES300 Power steering

STARTING AND DRIVING
148
BRAKE SYSTEM
The tandem master cylinder brake system is a hydraulic system with two
separate sub±systems. If either sub±system should fail, the other will still
work. However, the pedal will be harder to press, and your stopping distance
will be longer. Also, the brake system warning light may come on.
CAUTION
Do not drive your vehicle with only a single brake system.
Have your brakes fixed immediately.
Brake booster
The brake booster uses engine vacuum to power±assist the brakes. If the
engine should quit while you are driving, you can bring the vehicle to a stop
with normal pedal pressure. There is enough reserve vacuum for one or t\
wo
stops but no more!
CAUTION
Do not pump the brake pedal if the engine stalls. Each push
on the pedal uses up your vacuum reserve.
 Even if the power assist is completely lost, the brakes will
still work. But you will have to push the pedal hard ± much
harder than normal. And your braking distance will be
longer.
Anti±lock brake system
The anti±lock brake system is designed to automatically help prevent
lock±up of the wheels during a sudden brake or braking on slippery road
surfaces. This assists in providing directional stability and steering
performance of the vehicle under these circumstances.
The anti±lock brake system becomes operative after the vehicle has
accelerated to a speed in excess of approximately 10 km/h (6 mph). It stops
operating when the vehicle decelerates to a speed below approximately 5
km/h (3 mph).
You may hear a sound in the engine compartment for a few seconds when the
engine is started or just after the vehicle is started. This means that the
anti±lock brake system is in the self±check mode, and does not indicate a
malfunction.
Effective way to press the ABS brake pedal: When the anti±lock brake
system function is in action, you may feel the brake pedal pulsating and hear
a noise. In this situation, to let the anti±lock brake system work f\
or you, just
hold the brake pedal down more firmly. Do not pump the brake. This will
result in reduced braking performance.
The brake pedal pulsation caused by the anti±lock brake system may indic\
ate
hazardous road surface conditions. Although the anti±lock brake system
assists in providing vehicle control, it is still important to drive with all due
care, because the anti±lock brake system cannot overcome the laws of physic\
s
that act on your vehicle:
 Braking capability is dependent on tire friction with the road surface.

DRIVING TIPS
160

Keep your vehicle tuned±up and in top shape. A dirty air cleaner,
improper valve clearance, dirty plugs, dirty oil and grease, brakes not
adjusted, etc. all lower engine performance and contribute to poor fuel
economy. For longer life of all parts and lower operating costs, keep all
maintenance work on schedule, and if you often drive under severe
conditions, see that your vehicle receives more frequent maintenance. (For
scheduled maintenance information, please refer to the separate ºOwner's
Manual Supplement/Maintenance Scheduleº.)
CAUTION
Never turn off the engine to coast down hills. Your power
steering and brake booster will not function without the
engine running. Also, the emission control system operates
properly only when the engine is running.

IN CASE OF AN EMERGENCY
162
IF YOUR ENGINE STALLS WHILEDRIVING
If your engine stalls while driving . . . .
1. Reduce your speed gradually, keeping a straight line. Move cautiously off
the road to a safe place.
2. Turn on your emergency flashers.
3. Try starting the engine again.
If the engine will not start, see ºIf your vehicle will not startº\
.
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work, so steering and braking will be much
harder than usual.
IF YOUR VEHICLE WILL NOT START
(a) Simple checks
Before making these checks, make sure you have followed the correct starting
procedure instructions in ºHow to start the engineº on page 136 and that you
have sufficient fuel. Since your vehicle is equipped with the engine
immobiliser system, also check whether the other keys will start the engine.
If they work, your key may be broken. Have the key checked at your Lexu\
s
dealer. If none of your keys work, the system is possibly broken. Call your
Lexus dealer. See ºKeysº on page 7.
If the engine is not turning over or is turning over too slowly ±
1. Check that the battery terminals are tight and clean.
2. If the battery terminals are O.K., switch on the interior light.
3. If the light is out, dim or goes out when the starter is cranked, the ba\
ttery
is discharged. You may try jump starting. See º(c) Jump startingº for further
instruction.
If the light is O.K., but the engine still will not start, it needs adju\
stment or
repair. Call a Lexus dealer, Roadside Assistance or Customer Service
Assistance. (See ºForewordº.)

IN CASE OF AN EMERGENCY
176
(d) Emergency towing
40E021
If towing is necessary, we recommend you to have it done by your Lexus
dealer or a commercial tow truck service.
If towing service is not available in an emergency, your vehicle may be
temporarily towed by a cable or chain secured to the emergency towing
eyelet. Use extreme caution when towing the vehicle.
A driver must be in the vehicle to steer it and operate the brakes.
Towing in this manner may be done only on hard±surfaced roads for a sh\
ort
distance and at low speeds. Also, the wheels, axles, drive train, steering and
brakes must all be in good condition.
CAUTION
Use extreme caution when towing the vehicle. Avoid sudden
starts or erratic driving maneuvers which would place
excessive stress on the emergency towing eyelet and towing
cable or chain. The eyelet and towing cable or chain may
break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in towing vehicles.\
Securely fasten the cable or chain to the towing eyelet provided.
Before towing, release the parking brake and put the transmission in ºNº. The
ignition key must be in ºACCº (engine off) or ºONº (engine running).
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work so steering and braking will be much
harder than usual.

MAINTENANCE
184
Power steering fluid level
Check the level through the reservoir. The level should be in the ºHOTº or
ºCOLDº range depending on the fluid temperature. See page 206 for
additional information.
Exhaust system
Look for cracks, holes and loose supports. If you notice any change in the
sound of the exhaust or smell exhaust fumes, have the cause located and
corrected immediately. (See engine exhaust cautions in Section 3±1.)
DOES YOUR VEHICLE NEED
REPAIRING?
Be on the alert for changes in performance and sounds, and visual tip±o\
ffs that
indicate service is needed. Some important clues are:

Engine missing, stumbling, or pinging

Appreciable loss of power

Strange engine noises

A fluid leak under the vehicle (However, water dripping from the air
conditioning after use is normal.)

Change in exhaust sound (This may indicate a dangerous carbon monoxide
leak. Drive with the windows open and have the exhaust system checked
immediately.)

Flat±looking tires, excessive tire squeal when cornering, uneven tire wear

Vehicle pulls to one side when driving straight on a level road

Strange noises related to suspension movement

Loss of brake effectiveness, spongy feeling brake pedal, pedal almost
touches floors, vehicle pulls to one side when braking

Engine coolant temperature continually higher than normal
If you notice any of these clues, take your vehicle to your Lexus dealer a\
s soon
as possible. It probably needs adjustment or repair.
CAUTION
Do not continue driving with the vehicle unchecked. It could
result in serious vehicle damage and possibly personal injury.

61E004±6
INTRODUCTION187
ENGINE COMPARTMENT OVERVIEW
1 Engine oil filler cap
2 Brake fluid reservoir
3 Fuse box (U.S.A. and Canada)
4 Battery
5 Fuse box (Canada and California only)
6 Engine oil level dipstick
7 Fuse box (U.S.A. and Canada)
8 Washer fluid tank
9 Engine coolant reservoir
10 Power steering fluid reservoir

INTRODUCTION
188
DO±IT±YOURSELF SERVICEPRECAUTIONS
If you perform maintenance yourself, be sure to follow the correct
procedure given in this Section.
You should be aware that improper or incomplete servicing may result in
operating problems.
Performing do±it±yourself maintenance during the warranty period may
affect your warranty coverage. Read the separate Lexus Warranty statement
for details and suggestions.
This Section gives instructions only for those items that are relatively eas\
y for
an owner to perform. As explained in Section 5, there are still a number \
of
items that must be performed by a qualified technician with special tools.
For information on tools and parts for do±it±yourself maintenance, se\
e ºParts
and toolsº.
Utmost care should be taken when working on your vehicle to prevent
accidental injury. Here are a few precautions that you should be especially
careful to observe:
CAUTION

When the engine is running, keep hands, clothing, and tools
away from the moving fan and engine drive belt.
(Removing rings, watches, and ties is advisable.)

Right after driving, the engine compartment ± the engine,
radiator, exhaust manifold and power steering fluid
reservoir, etc. ± will be hot. So be car eful not to touch them.
Oil and other fluids may also be hot.

Do not smoke, cause sparks or allow open flames near fuel
or the battery. Their fumes are flammable.

Be extremely cautious when working on the battery. It
contains poisonous and corrosive sulfuric acid.

Do not get under your vehicle with just the body jack
supporting it. Always use automotive jack stands or other
solid supports.

Use eye protection whenever you work on or under your
vehicle where you may be exposed to flying or falling
material, fluid spray, etc.

INTRODUCTION
190
Checking brake fluid
Parts (if level is low):

FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:

Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):

Automatic transmission fluid DEXRON
II or III
Tools:

Rag or paper towel

Funnel (only for adding fluid)
Checking battery condition
Non±maintenance batteries
Tools:

Warm water

Baking soda

Grease

Conventional wrench (for terminal clamp bolts)
Maintenance type batteries
Parts (if level is low):

Distilled water
Tools:

Warm water

Baking soda

Grease

Conventional wrench (for terminal clamp bolts)

Coin (for vent plugs)

Funnel (only for adding distilled water)