1998 FORD TAURUS tire pressure

DRIVING THROUGH WATER
Do not drive quickly through standing water,
especially if the depth is unknown. Traction or brake
capability may be limited and if the ignition system
gets wet, your engine may stall. Water may also
enter your engine's air intake and severely damage
your engine.
If driving through deep or standing water is
unavoidable, proceed very slowly. Never drive
through water that is higher than the bottom of the
hubs (truck)/wheel rims (car).
Once through the water, always try the brakes. Wet
brakes do not stop the vehicle as effectively as dry
brakes. Drying can be improved by moving your
vehicle slowly while applying light pressure on the
brake pedal.
TRAILER TOWING
Your vehicle is classified as a light duty towing
vehicle. The amount of weight you can safely tow
depends on the type of engine you have in your
vehicle. Your vehicle does not come from the factory
fully equipped to tow. No towing packages are
available through Ford or Mercury/Lincoln dealers.
Do not tow a trailer until your vehicle has been
driven at least 800 km (500 miles). If towing with a
station wagon, inflate the rear tires to 35 psi.
Towing a trailer places an additional load on your
vehicle's engine, transaxle, brakes, tires and
suspension. Inspect these components carefully after
towing.
The amount of weight that you can tow depends on
the type of engine in your vehicle. See the following
charts:
Driving
103

Removing the anti-theft lug nut
1. Insert the key over the locking lug nut. Make sure
you hold the key square to the lug nut. If you hold
the key at an angle, you could damage the key and
the lug nut.
2. Place the lug nut wrench over the lug nut key and
apply pressure on the key with the wrench.
3. Turn the wrench in a counterclockwise direction
to remove the lug nut.
Reinstalling the anti-theft lug nut
1. Insert the key over the locking lug nut.
2. Place the lug nut wrench over the lug nut key and
apply pressure on the key with the wrench.
3. Install the lug nut.
Tire change procedure
1. Park on a level surface, activate hazard flashers
and set parking brake.
When one of the front wheels is off the
ground, the transaxle alone will not prevent
the vehicle from moving or slipping off the jack,
even if the vehicle is in P (Park).
To prevent the vehicle from moving when
you change a tire, be sure the parking brake
is set, then block (in both directions) the wheel
that is diagonally opposite (other side and end of
the vehicle) to the tire being changed.
Roadside emergencies
119

Temperature A B C
The temperature grades are A (the highest), B, and
C, representing the tire's resistance to the
generation of heat and its ability to dissipate heat
when tested under controlled conditions on a
specified indoor laboratory test wheel. Sustained
high temperature can cause the material of the tire
to degenerate and reduce tire life, and excessive
temperature can lead to sudden tire failure. The
grade C corresponds to a level of performance which
all passenger car tires must meet under the Federal
Motor Vehicle Safety Standard No. 109. Grades B
and A represent higher levels of performance on the
laboratory test wheel than the minimum required by
law.
The temperature grade for this tire is
established for a tire that is properly inflated
and not overloaded. Excessive speed,
underinflation, or excessive loading, either
separately or in combination, can cause heat
buildup and possible tire failure.
SERVICING YOUR TIRES
Checking the tire pressure
²Use an accurate tire pressure gauge.
²Check the tire pressure when tires are cold, after
the vehicle has been parked for at least one hour
or has been driven less than 5 km (3 miles).
²Adjust tire pressure to recommended
specifications found on the tire pressure label
inside the glove compartment door.
Maintenance and care
152

IDENTIFYING YOUR VEHICLE
Safety compliance label
The National Highway
Traffic Safety
Administration
Regulations require
that a Safety
Compliance
Certification Label be
affixed to a vehicle and
prescribe where the
Safety Compliance
Certification Label may
be located. The Safety Compliance Certification
Label is located on the front door latch pillar on the
driver's side.
Vehicle identification number
The vehicle
identification number
is attached to a metal
tag and is located on
the driver side
instrument panel.
Engine number
The engine number (the last eight numbers of the
vehicle identification number) is stamped on the
engine block, transmission, frame and transfer case
(if equipped).
MFD. BY FORD MOTOR CO. IN U.S.A.
EXT PNT: XXXXXX XXXXXX RC: XX DSO: XXXX F0000
BAR INT TR TP/PS R AXLE TR SPR T0000
X XX XXX X XX X XXXX
UTC
ÑFOHT-15294A10-GA
MAXIMUM LOAD=OCCUPANTS + LUGGAGE=XXXKG/XXXXLB
OCCUPANTS: X TOTAL X FR X 2ND X RR OCCUPANTS LUGGAGE
XX XXXKG/XXXXLB
TIRE: XXXX/XXXXX XXX X XXXKG/XXXXLB
PRESSURE (FR) XXX kPa/33 PSI COLD
PRESSURE (RR) XXX kPa/33 PSI COLD
TRAILER TOWING - SEE OWNER GUIDE
DATE: XXXXX GVWR:XXXXX LB/ XXXXX KG
VIN: XXXXXXXXXXXXXXXXX TYPE: XXXXXXXXXXXXXXX FGAWR: XXXXXX/XXXXXXX RGAWR: XXXXXXX/XXXXXXXTHIS VEHICLE CONFORMS TO ALL APPLICABLE FEDERAL
MOTOR VEHICLE SAFETY STANDARDS IN EFFECT ON THE
DATE OF MANUFACTURE SHOWN ABOVE.
XXXXXXXXXXXXXXXXXAIR BAG
Capacities and specifications
184

Panic alarm feature,
remote entry
system ........................ 45
Parking brake ............ 92
Power distribution box
(see Fuses) ............. 113
Power door locks ...... 37
Power steering .......... 93
fluid, checking and
adding ............. 141,142
Relays ............... 110,116
Remote entry
system ........................ 44
illuminated entry .... 45
locking/unlocking
doors ........................ 44
replacement/additional
transmitters ............. 46
replacing the
batteries .................. 46
Safety restraints ........ 63
cleaning the safety
belts .................. 66,175
extension
assembly .................. 65
for children ... 72,73,74
lap belt .................... 62
warning light and
chime ............. 11,65,66
Seat belts (see Safety
restraints) ... 58,59,60,61
Seats .......................... 55
child safety seats .... 75
cleaning ... 173,174,175
Servicing your
vehicle ...................... 128
Spark plugs,
specifications ........... 176
Specification chart,
lubricants ................. 179
Speed control ............ 29
Speedometer ............. 13Starting your
vehicle .............. 85,86,87
jump
starting .... 122,123,125
Steering wheel
tilting ....................... 34
Tachometer ............... 13
Tires .................. 150,152
changing ................ 119
checking the
pressure ................. 152
replacing ................ 153
rotating .................. 153
snow tires
and chains ............. 154
treadwear .............. 151
Towing
wrecker .................. 127
Transaxle
fluid,
refill capacities ...... 177
Transmission ........... 142
fluid, checking
and adding
(automatic) .......... 142,
143,144
Trip odometer ........... 15
Trunk
remote release
lever ......................... 40
Vehicle dimensions . 181
Vehicle Identification
Number (VIN) ......... 184
Vehicle loading ........ 101
Ventilating your
vehicle ........................ 89
Warning chimes ........... 6
Washer fluid ............ 137
Wheels
anti-theft
lug nuts .......... 118,119
Windows ............... 36,37
Index
188

Recommended
fuel-3.0L V6 enginesUnleaded fuel only - 87
octane
Recommended
fuel-3.4L SHO V8
engineUnleaded fuel only - 91
octane
Fuel tank capacity 60.6L (16 gallons)
Engine oil capacity
(including filter
change)-3.0L V6
Vulcan engine4.25L (4.5 quarts). Use
Motorcraft 5W30 Super
Premium Motor Oil, Ford
specification
WSS-M2C153-G.
Engine oil capacity
(including filter
change)-3.0L V6
Duratec engine5.2L (5.5 quarts). Use
Motorcraft 5W30 Super
Premium Motor Oil, Ford
specification
WSS-M2C153-G.
Engine oil capacity
(including filter
change)-3.4L V8 SHO
engine6.1L (6.5 quarts). Use
Motorcraft 5W30 Super
Premium Motor Oil, Ford
specification
WSS-M2C153-G.
Tire size and pressure Refer to Safety
Certification Label on
driver's door panel. Inflate
temporary spare to 60 psi.
Hood release Pull handle under the left
side of the instrument
panel.
Coolant capacity (3.0L
V6 Vulcan engine)
111.0L (11.6 quarts)
Coolant capacity (3.0L
V6 Duratec and 3.4L
V8 SHO engine)
1
10.0L (10.6 quarts)
Recommended
fuel-3.0L V6 enginesUnleaded fuel only - 87
octane
Recommended
fuel-3.0L V6 enginesUnleaded fuel only - 87
octane
Power steering fluid
capacity-3.0L V6
Vulcan engineKeep in FULL range
ondipstick.
Filling station information
191