1998 DODGE RAM 1500 Radio console

[x] Cancel search: Radio console

Page 596 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual ness connector. There should be continuity. If OK, go
to Step 4. If not OK, repair the open sensor return or
signal circuit as required.
(4) Remove the jumper wire from the ambient tem-
perature senso

Page 597 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual (1) Turn the Radio Frequency (RF) Detector ON. A
ªchirpº will sound and the green power LED will
light. If the green LED does not light, replace the
battery.
(2) Hold the RF detector within one inch

Page 746 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual 8W-10 POWER DISTRIBUTION
Component Page
A/C Compressor Clutch....................8W-10-17, 40
A/C Compressor Clutch Relay.................8W-10-17, 40
A/C-Heater Control....................8W-10-42, 4

Page 798 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual 8W-15 GROUND DISTRIBUTION
Component Page
A/C Compressor Clutch................ 8W-15-5, 8
A/C-Heater Control.................. 8W-15-9, 12
Adjustable Pedal Switch................ 8W-15-12
Airbag Contr

Page 1052 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual Component Page
Fuel Pump Module.................. 8W-80-66
Fuel Pump Motor (Diesel)............ 8W-80-66
Generator......................... 8W-80-67
Glove Box Lamp And Switch.......... 8W-80-67
Hands

Page 2349 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual (14) Remove the floor console, if equipped. (Refer
to 23 - BODY/INTERIOR/FLOOR CONSOLE -
REMOVAL)
(15) Remove the center bracket bolts. (Fig. 10)
(16) Disconnect the air bag control module electri-
ca

Page 2351 of 2627

DODGE RAM 1500 1998 2.G Workshop Manual (8) Install the left a-pillar trim. (Refer to 23 -
BODY/INTERIOR/A-PILLAR TRIM - INSTALLA-
TION)
(9) Position the left end cap and seat the attach-
ment clips fully.
(10) Install the right side mounti