1998 CHEVROLET TRACKER engine

Downloaded from www.Manualslib.com manuals search engine L
Be sure to:
Fit the side and rear part of the window into the
frame before completely zipping the window.
Push the inner lip of the canvas top all the way in
while zipping. After completing installation, make sure that the front
and bottom ends are securely hooked and the rear top
end of the window is under the canvas top.
2-46

Downloaded from www.Manualslib.com manuals search engine Lowering and Raising the Canvas Top
1. Remove the side windows of the canvas top as
shown previously.
2. Open the rear window and hang it down inside the
luggage compartment.
I I
I II
4. Unfasten the snaps that secure the canvas top to the
roof piece. The snaps are located on either side
of the
dome lamp.
I and push both sides of
the lock buttons on the
front
latches.
5. Lower the sun visors
3. Unfasten the snaps on the driver’s and passenger’s
sides of the roof side tension belts, located above the
doors
on the outside of the vehicle, underneath the
canvas top.
2-47

Downloaded from www.Manualslib.com manuals search engine 6. Unhook the latches.
7. Pull back the swing arm, unfasten the five snaps that
secure the canvas
to the swing arm and remove the
canvas from
the swing arm.
8. Return the swing arm forward and hook it securely
with the latches.
2-48

Downloaded from www.Manualslib.com manuals search engine 9.
10.
11.
Pull the tension belts located above the door frame
out through their rings.
Lay the front half
of the canvas top onto the
rear
half of the top. Then, fold it forward so it is
in “half.”
Put the rear bottom corners of the canvas top into
the luggage compartment.
12. Lower the top bows.
Make sure that the lower top
bow rests on the
rubber support without pinching any part
of the
canvas top.
2-49

Downloaded from www.Manualslib.com manuals search engine 13. Lower the folded canvas behind the rear
seatback(s). Make sure that the rear seat belts
around the shoulder anchor are clear from the
folded top.
14. Fasten the upper top
bow with the belt on
the driver’s side seat
belt shoulder anchor
bracket.
Reverse the steps to raise
your canvas top.
After raising the canvas top, make sure that the canvas
extension is located outside the roof rail.
2-50

Downloaded from www.Manualslib.com manuals search engine Removing and Installing the Canvas Top
1. Complete the steps listed previously for lowering the
canvas top.
2. Detach the rear bottom corners of the canvas top.
3. Unfasten
fastener. the Velcro@
4. Unsnap the canvas top to remove
it all the way.
See “Preparing Your Canvas
Top for Storage” in this
section for the correct storage procedure.
2-51

Downloaded from www.Manualslib.com manuals search engine Preparing the Canvas Top for Storage
2. Fold the side windows onto the top.
1. Lay the canvas top with the inside facing up on a
clean, dry, flat surface.
2-52

Downloaded from www.Manualslib.com manuals search engine 3. Fold the front part of the canvas top over the windows.
4. Lay the rear window on top of the folded canvas top.
5. Roll the canvas top around the rear window.
6. Store in a clean, dry location.
2-53