Page 92 of 402

Downloaded from www.Manualslib.com manuals search engine Mode 1: Zero Delay and Shock Sensor Disabled (The
alarm will sound immediately if the driver’s
door is
opened with your key and the shock sensor will not be
available to measure sharp blows
to your vehicle).
Mode
2: Eight-Second Delay and Shock Sensor
Disabled (The alarm will sound eight seconds after the
driver’s door
is opened with your key and the shock
sensor will not be available to measure
sharp blows
to your vehicle).
Mode
3: Zero Delay and Shock Sensor Enabled (The
alarm will sound immediately after the driver’s door is
opened with your key and the shock sensor will be available to measure
sharp blows to your vehicle).
Mode
4: Eight-Second Delay and Shock Sensor
Enabled (The alarm will sound eight seconds after the
driver’s door is opened with your key and the shock
sensor will be available
to measure sharp blows to
your vehicle).
Leaving Programming Mode
When programming is done, turn the ignition switch to
OFF and replace the RADIO fuse.
New Vehicle “Break-In”
NOTICE:
Your vehicle doesn’t need an elaborate
“break-in.” But it will perform better in the long
run if
you follow these guidelines:
Keep your speed at 55 mph (88 kmh) or
less for the first
500 miles (805 km).
Don’t drive at any one speed -- fast or
slow -- for the first 500 miles (805 km).
Don’t make full-throttle starts.
200 miles (322 km) or so. During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every
time
you get new brake linings.
See “Towing
a Trailer” in the Index for
more information.
Avoid making hard stops for the first
Don’t tow a trailer during break-in.
2-24
Page 119 of 402

Downloaded from www.Manualslib.com manuals search engine Daytime Running Lamps
Daytime Running Lamps (DRL) can make it easier
for others to see the front of your vehicle during the
day. DRL can be helpful
in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel
automatically turns the headlamps
on, so be sure
it isn’t covered.
The
DRL system will make your front turn signal
lamps come on when:
The ignition is on,
0 The headlamp switch is off and
0 The parking brake is released.
When
the DRL are on, only your front turn signal lamps
will be on. The taillamps, sidemarker and other lamps
won’t be on. Your instrument panel won’t be lit up
either. When you
use your turn signals, the front turn
signal and the taillamp of the desired side will flash.
When it’s dark enough outside, your front turn signal
lamps will go out and your headlamps will come on.
The other lamps will also come on. When it’s
bright enough outside, the regular lamps will
go
off, and your front turn signal lamps will come on.
As with any vehicle, you should turn on the regular
headlamp system
when you need it.
Fog Lamps (If Equipped)
Use your fog lamps for
better vision in foggy or
misty conditions. Your
parking lamps must be on or
your fog lamps won’t work.
#D To turn the fog lamps on, push the fog lamp switch.
Push the the switch again to
turn the fog lamps off. A light
on the switch will come on when the fog lamps are on.
Fog lamps will go
off whenever your high-beam
headlamps come on. When the high-beam headlamps
go off, the fog lamps will come on again.
2-51
Page 229 of 402
Downloaded from www.Manualslib.com manuals search engine Attach a separate safety chain around outboard end of
each lower control arm.
I NOTICE: I
Take care not to damage the brake pipes and
brake lines hoses or the
ABS sensor and wiring. 1
NOTICE:
Do not tow with sling-type equipment or
fascidfog lamp damage will occur. Use wheel-lift
or car-carrier equipment. Additional ramping
may be required for car-carrier equipment. Use
safety chains and wheel straps. Use the T-slots for
car-carrier securing. Towing a vehicle over rough
surfaces could damage
a vehicle. Damage can
occur from vehicle
to ground or vehicle to
wheel-lift equipment contact.
To help avoid
damage, install
a towing dolly and raise vehicle
until adequate clearance is obtained between the
ground and/or wheel-lift equipment.
Page 323 of 402

Downloaded from www.Manualslib.com manuals search engine Fuse
TAIL LPS
HVAC
PWR ACCY
COURTESY GAUGES
AIR BAG
CIG/ACCY
Usage
Daytime Running Lamps (DRL)
Module, Headlamp Switch
HVAC Selector Switch, Rear
Defogger SwitcWTimer
Park Lamp Relay, Hatch Release
Relay, Power Mirror Switch,
Radio, Shock Sensor, Instrument
Cluster
Body Control Module (BCM)
Body Control Module (BCM),
Brake Switch Assembly (BTSI),
Instrument Cluster, Daytime
Running Lamps (DRL) Module,
Auxiliary Accessory Wire
Air Bag System, Dual
Pole
Arming Sensor
Cigarette Lighter, Data Link
Connector (DLC), Auxiliary
Accessory Wire
Fuse
DEFOGEEATS
WIPEWASH
WINDOWS
IP DIMMER
RADIO
Usage
Rear Defogger Switch/Timer,
Power Seats
Wiper Motor Assembly,
Wipermasher Switch
Power Windows Switch (RH, LH),
Express Down Module,
Convertible Top Switch
Door Illumination Lamp
(LH,
RH), Headlamp Switch, Fog
Lamp Switch, Instrument Cluster,
HVAC Control Assembly, PRNDL
Illumination Lamp, Ashtray
Lamp, Radio, Steering Wheel
Controls-Radio, Rear Window
Defogger Switch/Timer, Traction
Control (ASR) Second Gear Start Switch
Body Control Module (BCM),
Radio, Amplifier, Steering Wheel
Controls-Radio
6-65
Page 326 of 402
Downloaded from www.Manualslib.com manuals search engine Fuse
ENG SEN
STRTR
ABS IGN PCM IGN
ENG CTRL
Usage
Mass Air Flow, Heated Oxygen
Sensor, Skip Shift Solenoid
(V8
Only), Reverse Lockout Solenoid,
Brake Switch
Powertrain Control Module and
Clutch Pedal Switch
Anti-Lock Brake System Module
Powertrain Control Module
Ignition Module (V6 Only),
Automatic Transmission and
Charcoal Canister Purge Solenoid
A/C CRUISE Air Conditioning Compressor Relay,
Cruise Control Switches and Module
ENG CTRL Engine Controls, Fuel Pump, PCM,
A.I.R. and Cooling Fans
Fuse
I/P- 1
IGN
UP- 2
Relay
AIR SOL
AIR PUMP
A/C COMP
FUEL PUMP STARTER
IGN
Usage
HVAC Blower Control and Relay
Ignition Switch, Relay and Starter
Enable Relay
Instrument Panel Fuse Center
6-68