1998 CHEVROLET CAMARO boot

Downloaded from www.Manualslib.com manuals search engine 3. Make sure there is
nothing or anyone on
or around the top. Push
and hold down or the
down arrow on the
convertible top switch.
Installing the Boot Cover
After lowering the convertible top, you’ll want to install
the boot cover. The three-piece boot cover
is stored in a
bag in the hatch
4. The switch is next to your cigarette lighter. The top
will automatically lower into the storage area.
1. Open the hatch and remove the two side covers
from the storage bag.
2. Install the two side covers by engaging the tab
into the front seatbelt cover. Lower the covers
onto the vehicle.
2-67

Downloaded from www.Manualslib.com manuals search engine 3. Install the middle section of the cover by sliding the
tabs into the slots
on the right side cover. Lower the
cover and engage the latch.
4. Close the hatch.
Raising Your Convertible Top
1. It is recommended that you park on a level surface.
Set the parking brake firmly. If
you have an
automatic transmission, shift into
PARK (P). If
you have a manual transmission, shift into
RUN or RAP must be on. Then lower both sun
visors and lower both windows at least three inches
(8 cm). If the boot cover is in place, it must be
removed first.
I REVERSE (R). The ignition must be in ACC,
I
~ 1 NOTICE:
It is not recommended that you raise or lower the
top while the vehicle
is moving.
2-68

Downloaded from www.Manualslib.com manuals search engine 2. Open the hatch. Remove the middle piece of the cover
by pushing in on the latch and lifting up on the cover.
3. Remove the two side pieces of the boot cover
by lifting the rear cover and sliding them out of
their slots.
2-69