Page 95 of 426
2. Move the shift lever into ?ARK (B) as follows:
8 Pull the iever toward you.
Move the lever up as far as it will go.
3. Move the ignition key to LOCK.
4. Remove the key and take it with you. If YOU can
leave
your vehicie with the ignition key in your
hand, your vehicle is in PARK (P).
ProCarManuals.com
Page 97 of 426
k;zgaA 'T:..:&pa: & LnP :V3;.,,t (.$ dL Bb* pFq- {p :.A AA &L \'& J
Your vehicle has a brake-transaxle shift interlock. You
have to fully apply your regular brake before you can
shift
from PARK (P) when the ignition is in RUN. See
"Automatic Transaxle" in the Index.
If you cannot shift out of PARK (PI, ease pressure on
the shift lever -- push the shift 'lever all the way into
PARK (PI as you maintain brake application. Then
move the shift lever into the gear
YOU want.
If you ever hold the brake pedal down but still can't
shift out of PARK (P), try this:
1.
2.
3.
4.
5.
Turn the key to OW. Open and close the driver's
door to turn
off the retained accessory power feature.
Apply
and hold the brake until the end of Step 4.
Shift to NEUTRAL (N).
Start the vehicle and then shift to the drive gear
you want.
Have the vehicle fixed as soon as you can. CAUTION:
Things that can burn could touch hot exhaust
parts under your vehicle and ignite. Don't park
over papers, leaves,
dry grass or other things that
can burn.
.. . .. 3 32 drn-2
ProCarManuals.com
Page 114 of 426
This feature will only be activated when the security
feedback feature
is programmed to be in Modes 1,3 or 5
on the trmsmitter. Modes 0, 2 and 4 do not respond with
exterior lights Washing when uirlocking the vehicle so
perimeter lighting will nct be active.
This feature can be programmed
on or off for
each transmitter.
To turn the feature off:
1. Press and hold LOCK on the door lock switch QII the
door throughout this procedure. All doors will lock.
2. Press the instant dam button on the transmitter to
enter tihe programming mode. Perimeter lighting
remains
on at this time and the ~QIX will chirp
two times.
3. Press the instant alam button on fhe key transmitter
again. Perizneter lighting is disabled and the horn
wiEI chirp one time.
4. Release the door lock switch. The perimeter iighting
Pressing the UNLOCKbutton repeatedly may caw the
To turn the feature on:
feature is now off.
back-up lamps to turn on.
I.
2.
3.
4.
Press and hold LOCK on the door lock switch on the
door throughout this procedure. A11 doors will Bock.
Press the
instant alm button on the key transmieter
to enter the programming mode. Perimeter lighting
remains off at this time and the horn will chirp
one time.
Press the instant
alm button 0n the transmitter
again. Perimeter lighting is now enabled
and the
horn will chirp two times.
Release
the door lock switch. The perimeter lighting
feature
is ~QW on.
Perimeter iighting can also be activated through the
optional Driver Infomation Center
(DHC). See
“Personal Choice Features” or “Driver Infomation
Center” in the Index.
ProCarManuals.com
Page 141 of 426
This part describes the warning lights and gages that
may be
on your vehicle. The pictures will help YOU
locate them.
Warning lights
and gages can signal that something is
wrong before it becomes serious enough to cause an
expensive repair
or replacement. Paying attention to
your warning lights and gages coukl also save you or
others from injury.
Warning lights come on when there may be or is a
problem with one
of your vehicle’s hn~tions. As YOU
will see in the details 010. the next few pages, some
warning lights come on briefly when
you start the
engine
just to let you know they’re working. If you are
familiar with
tis section, YOU should not be alarmed
when this happens.
Cages can indicate when there may
be or is a problem
with of your vehicle’s functions. Often gages
and
warning lights work together to let you how when
there’s a problem
with your vehicle. When one
of the
warning lights comes QII and stays on
when you are driving, or when one of the gages shows
there may be a problem, check the section that tells you
what
to do about it. Please follow this manual’s advice.
Waiting to
d~ repairs can be costly -- and even
dangerous.
So please get to how your warning lights
and gages. They’re a big help.
Your vehicle may also have a driver information system
that works along with the warning lights and gages. See
“Driver Information System”
in the Index.
d Bel$ pj&&n(jgp Light
When eke key is turned to RUN or START, a chime will
come on
for about eight seconds to remind people to
fasten their safety belts, unless the driver’s safety belt is
already buckled.
The safety belt light will
also come on md stay on
for about 20 seconds, then it
will
flash for about
55 seconds. If the driver’s
belt is already buckled,
neither the chime nor the
light will come on.
ProCarManuals.com
Page 142 of 426
There is an air bag readiness light on the instrument
panel, which shows AIR
BAG. The system checks the
air bag’s electrical system for rna’rfunctions. The light
tells you
if there is an electrical problem. The system
check includes the air
bag sensors, the air bag modules,
the
wiring and the crash sensing and diagnostic module.
For more infomation on the air bag system, see “Air
Bag” in the Index.
This light will come on
when y~u start your engine,
and it will flash for a few
seconds.
Then the Eight
should go out. This means
the system is ready.
I€ the air bag readiness light stays on after you start the
engine or comes QIT when you are driving, your air bag
system may
not work p~operly. Have your vehicle
serviced right away.
The air bag readiness light should flash for a few
seconds when you
turn the ignition key to RUN. If the
light doesn’t come
on then, have it fixed so it will be
ready
to wm you if there is a problem.
VOLT
“‘en you turn the hey to
RUN, this light will come
on briefly, to show the
battery charging systeE
is
working.
When the light goes off and stays off, the charging
system
is working.
Hf the light stays on, a chime will sound indicating you
need service, and you should take your vehicle to the
dealer at once. To save your battery until yo3 get there,
turn off a%B accessories and turn off glow climate
control system.
When a luge number of electrical accessories me
operating ir, the vehicle and the engine is left at an idle
for aa extended period, the engine may idle at a higher
RPM than noma1 to ensure the battery does not mn
down. This may occur when several of the following are
on: parking lamps, high-beam headlamps, rear window
defogger, heated seats and engine cooling fans, etc. It
may take longer for the rear window defogger to dear
the glass, and the heated seats may not feel as warn
as normal.
ProCarManuals.com
Page 143 of 426
This light should come on
whera YOU turn the key to
RUN. If it doesn’t come ora
then, have it fixed so Et will
be ready to warn you if
there‘s 2 problem.
ProCarManuals.com
Page 144 of 426
With the anti-lock brake
system, the
Iight(s) will
come on when you start
your engine and may stay
on for several seconds.
1 That’s BzorfnaI.
The anti-lock brake system warning light should come
on briefly when YOU turn the ignition key to RUN. If the
light doesn’t come on then, have it fixed SO it will be
ready
to wm you if there is a problem.
OFF
This warnirag light should
come on briefly 2s you start
the engine. If the warning
iight doesn’t corne on then,
have it fixed so it will be
ready
to warn you if there’s
a problem.
If it stays on, or comes on when you’re driving, there
may be a problem with your traction control system and
your vehicle may need service. When this warning light
is on, the system will not limit wheel spin. Adjust your
The traction control system wming light may come on
for the foIlowing reasons:
dr;ivi3g accordingly.
If yos turn the system off by pressing the button
located on the end of the shift lever, the warning
light will come on and stay on. To turn the system
back on, press the button again. The warning light
should go off. (See “Traction Control System” in the
Index
for more kf~m;ation.)
ProCarManuals.com
Page 146 of 426
NOTICE:
If you keep driving your vehicle with this light
on, after a whiie, your emission controls rnay not
work as well, your fuel economy may not be as
good and your engine may not PUR as smoothly.
This could lead to costly repairs that may not be
covered by pur warranty.
This jight should corne on, as a check to show YOU it is
working, when the ignition is
on and the engine is not
running. If the light doesn’t come on, have it repaired.
This light will also come QII during ;I malfunction in one
of ~WO ways:
8 Light Flashing -- A misfire condition has been
detected.
A misfire increases vehicle emissions and
may damage the emission controi system on your
vehicle. Dealer or qualified service center diagnosis
and service rnay be required.
@ Eight On Steady -- An emission control system
malfunction
has been detected on your vehicle.
Dealer
or qualified service center diagnosis and
service
may be required.
-.- 8:. f. ,fie ~ 2s F‘fp&-!&g --
The following may prevent more serious damage to
your vehicle:
Reducing vehicle speed.
Avoiding hard accelerations.
e Avoiding steep uphill grades.
If YOU are towing a trailer, reduce the amount of
cargo being hauled as soon as it is possible.
If the light stops flashing and remains on steady, see “If
the Light Is On Steady” following.
Sf the light continues to flash, when it is safe to do so,
stop the vehicle. Find a safe place to park your vehicle.
Turn the key off, wait at least IO seconds and restart the
engine.
If the light remains on steady, see “If the Light
Is On Steady” following. If the light is still flashing,
follow the previous steps,
and drive the vehcle to your
dealer or qualified service center €or service.
ProCarManuals.com
