1998 BMW CONVERTIBLE headlamp

13 1
At a glanceControlsCar careRepairsTechnicalDataIndex
Washing your carRight from the start, you can wash your
new BMW either by hand or in an auto-
matic car wash. BMW Convertible: For
instructions on cleaning and care of the
convertible top, refer to page 136 ff.
To prevent spots, avoid washing when
the hood is still warm, or immediately
after and during exposure to strong
sunlight.
When using an automatic car wash,
ensure that
dno damage occurs to vehicles with
add-on body elements (e.g., spoilers,
telephone aerials). Consult the car
wash operator if necessary
dthe vehicle is cleaned with minimum
brush pressure, and that ample water
is available for washing and rinsing.
Loosen and remove stubborn dirt and
dead insects before washing the car.
a
Always maintain an adequate dis-
tance between the spray source and the
vehicle's surface when using spray
wands and high-pressure washers. In-
adequate distance and excessive pres-
sure can damage or weaken the finish,
making it more susceptible to subse-
quent attack. In addition, moisture could
penetrate to vehicle components, lead-
ing to long-term damage.c
Parts of the car which are inaccessible
to the automatic washer - such as door
sills, door and hood edges, etc. -
should be cleaned by hand.
b
Please observe the following
when cleaning the headlamp covers:
dDo not clean by wiping with a dry
cloth (scratches). Never use abra-
sives or strong solvents to clean the
covers.
dRemove dirt and contamination (such
as insects) by soaking with BMW Car
Shampoo and then rinsing with
plenty of water.
dAlways use a de-icer spray to remove
accumulated ice and snow Ð Never
use a scraper!cIn the winter months, it is especially
important to ensure that the car is
washed on a regular basis. Large quan-
tities of dirt and road salt are difficult to
remove, and they also cause damage to
the vehicle.
a
After washing, the brakes may be
wet and thus less effective! Apply the
brakes briefly to dry them.c
Caring for your car

13 2
Exterior finishTo provide effective corrosion protec-
tion, multilayer paintwork is applied at
the factory. Cataphoretic immersion
priming techniques are supplemented
using special body-cavity protectants,
with the application of specially-devel-
oped and extensively tested materials.
The entire underbody is sprayed with a
flexible PVC layer before final compre-
hensive application of a wax-based
protectant.
Regular maintenance makes an impor-
tant contribution to maintaining the
safety and value of your vehicle.
Increasing awareness of the effects of
harmful environmental factors on vehi-
cle finishes have led paint and vehicle
manufacturers to initiate ongoing pro-
grams designed to further improve the
durability of their finishes. Despite the
high quality of the resulting products,
local and regional factors can still have
a negative effect on your car's paint-
work. These should guide you in deter-
mining the frequency and extent of your
efforts to maintain the vehicle finish.
Depending upon material and type of
impact (perforation of paint layer), phys-
ical stresses from sand, road salt,
gravel, etc. can cause corrosion to start extending beneath the finish, starting at
the point of impact.
Road dirt, tar spots, dead insects, ani-
mal droppings (strong alkali effect) and
tree excretions (resins and pollen) all
contain substances capable of causing
damage when allowed to remain on
your car's finish for any period of time
(spots, etching, flaking, separation in
the top coat).
In industrial areas, deposits from ßy ash,
lime, oily soot, sulphur dioxide in pre-
cipitation (acid rain) and other environ-
mental pollutants will damage the car's
surface (usually limited to the external
horizontal surfaces) unless adequate
protection is provided.
In coastal regions, high levels of atmo-
spheric salt and humidity promote cor-
rosion.
In tropical zones, temperatures of over
100 5F (approx. 406) in the shade pre-
vail, in addition to heavy ultraviolet radi-
ation and high humidity. Under those
circumstances, light-colored paints
reach temperatures of up to 175 5F
(approx. 806) and dark paints up to
250 5F (approx. 1206).
Caring for the vehicle finishAs a precaution against damage result-
ing from exposure to aggressive sub-
stances, we recommend that you wash
the car weekly when it is used in an
area with high levels of air pollution or
aggressive natural substances (tree
resin, pollen).
Remove particularly aggressive sub-
stances immediately in order to prevent
changes to, and discoloration of, the
paint. Such substances are e.g., gaso-
line spilled during refueling, oil, grease,
brake fluid and bird droppings.
Any contamination remaining on the
surface of the vehicle will be especially
conspicuous after washing. Use clean-
ing fluid or alcohol with a clean cloth or
cotton pad to remove. You can use tar
remover to remove any spots on the fin-
ish of the vehicle, but should never
apply it or any other aggressive
cleanser to lenses or headlamp covers.
These areas should then be waxed to
maintain protection.b
A full range of car-care products is
available from your BMW Retailer.c
Caring for your car

14 1
At a glanceControlsCar careRepairsTechnicalDataIndex
The lamps and bulbs on your car play a
vital role in ensuring road safety, a fact
which you should always bear in mind
in caring for them. Carefully observe the
following instructions during bulb
replacement, referring any procedures
with which you are not familiar to your
BMW Retailer.b
Never touch the bulb glass of a
new lamp with your bare hands. Use a
clean cloth, paper napkin, etc. or hold
the bulb by its metallic base.c
A replacement bulb set is available from
your BMW Retailer.
a
To prevent short circuits, always
switch off all electrical systems and
components, or disconnect the negative
terminal of the battery, before working
on them.
To prevent injuries and damage, always
observe any instructions provided by
the bulb manufacturer.c
Low and high beamsLow beam: HB4, 55 watts
High beam: HB3, 65 wattsa
Each bulb is pressurized; always
wear gloves and eye protection! Failure
to observe this precaution could lead to
injury if the bulb is accidentally dam-
aged during replacement.c
dTurn the bulb holder to the left and
remove.
dReplace the bulb.
Parking lamp 5 watt bulb
dPress in the upper tab of the bulb
holder to release and remove.
dPull out the bulb holder.
dPull off the bulb and replace.b
Please observe the following
when cleaning the headlamp covers:
dDo not rub them dry and do not apply
scouring or caustic cleaning agents.
dRemove dirt and contamination (such
as insects) by soaking with BMW Car
Shampoo and then rinsing with
plenty of water.
dAlways use a de-icer spray to remove
accumulated ice and snow Ð Never
use a scraper!c
360us089
Bulb replacement

16 6
Quarts (Liter) Notes
Fuel tank
of which reserve approx. 17 gal. (62)
approx. 2 gal. (8)Fuel specification: Page 24
Windshield washer system
with headlamp washer systemapprox. 2.6 (2.5)
approx. 5.3 (5.0)For details: Page 124
Cooling system including
heater circuit6.9 (6.5) - 318i, 318is
11.1 (10.5) - 323i, 323is, 328i, 328isFor details: Page 88
Engine oil and filter change 5.2 (5.0) - 318i, 318is
6.9 (6.5) - 323i, 323is, 328i, 328isApproved HD oil
Specifications: Page 126
Shift, Automatic- and final drive ÐLifetime fluid, no fluid change required.
Capacities

175
At a glanceControls Car careRepairsTechnicalDataIndex
Note: This index does not correspond to the original manual in all details
AAdd coolant 127
Adding oil 125
Adjusting washer
nozzles 124
Antifreeze, use 127BBackup lamp,
replace bulb 143
Battery,
charging 150
Battery change,
master key 145
radio remote control 145
Battery,
add distilled water 149
discharged 153
Brake fluid, add 128
Brake lamps,
replace bulb 143
Brakes, defects 105CCheck air pressure 24
Check Control 70
Check engine oil level 124
Coolant, add 127DDefrost windshields 91
Difficult steering 129Door, emergency
actuation 32
EElectrical fault
Sliding/tilt sunroof 152
Fuel filler door 152
Emergency actuation,
Door 32
Sliding/tilt sunroof 152
Fuel filler door 152
External starts 153FFailure messages 70
Failure of an
electrical device 151
Fault displays 70
First aid 21
Fittings, tow-starting and
towing 154
Flat tire 146
Foglamps,
replace bulb 142
Footwell lamp,
replace bulb 145GGlove compartment lamp,
replace bulb 145
HHazard warning system 21
Hazard warning triangle 21
Headlamp cover, care 141
Help in case of a
breakdown 153
High beam headlamps,
replace lamps 141IIndicator lamps 19
Inflation pressure 24
Interior lamps,
replace bulbs 144KKey, battery change 145LLicense plate lamp,
replace bulb 144
Low beam headlamps,
replace lamps 141
Luggage compartment lid,
emergency actuation 32
Luggage compartment
lamps, replace bulb 145MMaintenance 63OOnboard tool kit 140
PParking lamp,
replace bulb 141
Power steering,
add oil 128
Pressure, tires 24
Protective glazing,
care 131RRear foglamps,
replace bulb 142
Remove mist on
windshields 91
Replace bulbs 141
Replace fuses 151SSliding/tilt sunroof,
close in case of power
supply interruption 152
Snow chains 105
Starting difficulties 102, 153
Starting with a discharged
battery 153TTaillamp 143
Taillamp,
replace bulb 143
Tire change 146
Tire damage 111
Tools 140
Owner service procedures from A to Z