198
3. Loosen the retainer screws
NOTICE
Never attempt to loosen the headlight aim adjusting screws.
4. Take out the beam unit together with the retainer, unplugging the
connector.
To disconnect the wire connector, com-
press the lock releases. If the connector is tight, wiggle it.5. Install a new beam unit with the single protrusion on the glass face
upward, plugging the connector.
Put the retainer on the unit and
tighten the screws. Install the radia-
tor grille and parking light units.
When aiming adjustment is necessary,
contact your Toyota dealer.
199
1. Open the hood. Unplug the con-nector. Remove the rubber cover.
If the connector is tight, wiggle it.2. Release the bulb retaining spring and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install a bulb, align the tabs of the bulb with the cutouts of the mounting hole.3. Install the rubber cover with the TOPº mark upward and snuggle
on the boss. Then inset the connec-
tor.
Make sure the rubber cover fits snugly on
the connector and the headlight body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
ÐHeadlight bulbs
