1997 TOYOTA CAMRY wheel

mm (in.)
Part 8Dimensions and weight
211
SPECIFICATIONS
Dimensions and weight
Engine
Fuel
Service specifications
Tires
FusesP195/70R 14 tire
Overall length 4783 (188.3)
Overall width 1780 (70.1)
Overall height 1416 (55.7)*


Wheelbase 2670 (105.1)
Front tread 1547 (61.0)
Rear tread 1520 (59.8)P205/65R 15 tire
4783 (188.3)
1780 (70.1)
1419 (55.9)*


2670 (105.1)
1547 (61.0)
1520 (59.8)
Vehicle capacity weight
(occupants + luggage)
kg(lb): 410 (900)
*1: Unladen vehicle
ProCarManuals.com

214
Differential
Fluid capacity, L (qt., Imp. qt.):
5S-FE engine 1.6 (1.7, 1.4)
1MZ-FE engine 0.85 (0.9, 0.7)
Fluid type:
Automatic transmission fluid D-II or
DEXRON
[III (DEXRON[II)
BRAKES
Minimum pedal clearance when de-
pressed with the pressure of 490 N (50
kgf, 110 lbf) with the engine running, mm
(in.):
70 (2.8)
Pedal freeplay, mm (in.):
1'6 (0.04'0.24)
Pad wear limit, mm (in.):
1.0 (0.04)
Lining wear limit, mm (in.):
1.0 (0.04)
Parking brake adjustment when pulled
with the force of 196 N (20 kgf, 44 lbf):
6'9 clicks
Fluid type:
SAE J1703 or FMVSS No. 116 DOT 3STEERING
Wheel freeplay:
Less than 30 mm (1.2 in.)
Power steering fluid type:
Automatic transmission fluid DEX-
RON
[II or III
ProCarManuals.com

215
Normal drivingkPa (kgf/cm2 or bar, psi)
For all loads including full rated loadsFor reduced loads (1 to 4passengers)For all loads including full rated loadsFor reduced loads (1 to 4 passengers)
Tire sizeFrontRearFrontRearWheel size
P195/70R14 90S210(2 1 30)210 (2.1, 30)210 (2.1, 30)210 (2.1, 30)14 x 5.5JJP195/70R14 90S210 (2.1, 30)210 (2.1, 30)210 (2.1, 30)210 (2.1, 30)14 x 5.5JJ
P205/65R15 92S215/70R 16 99220 (2 2 32)200 (2 0 29)200 (2 0 29)15 x 6JJP205/65R15 92S215/70R 16 99220 (2.2, 32)200 (2.0, 29)200 (2.0, 29)15 x 6JJ
Trailer towingkPa (kgf/cm2
or bar, psi)
Tire size
FrontRear
P195/70R14 90S210 (2.1, 30)210 (2.1, 30)
P205/65R15 92H220 (2.2, 32)220 (2.2, 32)
When driving under the above vehicle load conditions at sustained high speeds abve 160 km/h (100 mph), in countries where such
speeds are permitted by-law, inflate the front and rear tires to 240 kPa (2.4 kgf/cm2
or bar, 35 psi) provided that it does not exceed
the maxium cold tire pressure molded on the tire sidewall.
Wheel nut torque, NVm (kgfm, ftVlbf):
104 (10.5, 77)
Tires
ProCarManuals.com

220
This information has been prepared in ac-
cordance with regulations issued by the
National Highway Traffic Safety Adminis-
tration of the U.S. Department of Trans-
portation. It provides the purchasers and/
or prospective purchasers of Toyota
vehicles with information on uniform tire
quality grading.
Your Toyota dealer will help answer any
questions you may have as you read this
information.
DOT quality gradesÐAll passenger
vehicle tires must conform to Federal
Safety Requirements in addition to
these grades. These quality grades are
molded on the sidewall.
TreadwearÐThe treadwear grade is a
comparative rating based on the wear
rate of the tire when tested under con-
trolled conditions on a specified govern-
ment test course. For example, a tire
graded 150 would wear one and a half
(1-1/2) times as well on the government
course as a tire graded 100. The relative
performance of tires depends upon the
actual conditions of their use, however,
and may depart significantly from the
norm due to variations in driving habits,
service practices and differences in road
characteristics and climate.Traction A, B, CÐThe traction grades,
from highest to lowest, are A, B, and C,
and they represent the tire's ability to stop
on wet pavement as measured under
controlled conditions on specified govern-
ment test surfaces of asphalt and con-
crete. A tire marked C may have poor trac-
tion performance.
Warning: The traction grade assigned to
this tire is based on braking (straight
ahead) traction tests and does not include
cornering (turning) traction.
Temperature A, B, CÐThe temperature
grades are A (the highest), B, and C, rep-
resenting the tire's resistance to the gen-
eration of heat and its ability to dissipate
heat when tested under controlled condi-
tions on a specific indoor laboratory test
wheel. Sustained high temperature can
cause the material of the tire life, and ex-
cessive temperature can lead to sudden
tire failure. The grade C corresponds to a
level of performance which all passenger
car tires must meet under the Federal Mo-
tor Vehicle Safety Standard No. 109.
Grades B and A represent higher levels of
performance on the laboratory test wheel
than the minimum required by law.Warning: The temperature grades for this
tire are established for a tire that is proper-
ly inflated and not overloaded. Excessive
speed, underinflation, or excessive load-
ing, wither separately or in combination,
can cause heat buildup and possible tire
failure.
Uniform tire quality grading
ProCarManuals.com