Downloaded from www.Manualslib.com manuals search engine Removing and Installing Engine10
Edition 11.96
The two rear jacking points are located at the rear of both side members at the level of the marking on the sill.
- Remove noise insulation panel -arrow-.
- Open cap of coolant expansion tank.
- Place drip tray (e.g. V.A.G 1306) below the
engine.
- Turn drain plug -arrow- at the radiator to the
left; fit auxiliary hose onto connection if ne-
cessary.
Downloaded from www.Manualslib.com manuals search engine
17Lubrication System
Edition 08.96
Testing oil pressure and oil pressure switch
Special tools, testers and aids required
Oil pressure tester (e.g. V.A.G 1342)
Diode test lamp (e.g. V.A.G 1527)
Adapter cable set (e.g. V.A.G 1594)
Current flow diagram
Operation of dynamic oil pressure warning system
Testing warning lamp After ignition on („terminal 15 on“) and engine not running, the oil pressure warning lamp flashes (not on models with Auto Check System).
Warning criteria
Engine not running and oil pressure switch closed.
Coolant temperature greater than 60 °C, engine speed greater than 1500 rpm and oil pressure switch open.
At an engine speed of more than 5000 rpm an active oil warning is not cancelled, irrespective of the position of the oil pressure switch.
If the voltage supply of the control unit is o.k. (terminal 15) and the oil pressure switch is open for longer than 0.5 seconds at engine speeds of more than 1500 rpm, this is stored. If this condition occurs three times during „terminal 15 on“, the warning becomes or remains active even at engine speeds of less than 1300 rpm.
Test conditions
Engine oil level o.k.; inspect page 17-10
Oil pressure warning lamp (K3) should come on when ignition switched on.
The o.k. readout on vehicles with Auto Check System should come on (select symbol)
Engine oil temperature at least 80 °C (radiatorfan should have cut in once)
