The KANGOO Workshop Repair Manual has been prepared by specialists in repair methods
and diagnostics.
The document covers the methods and the diagnostic operations needed in order to obtain
high quality repairs for this vehicle.
However, if a removal - refitting operation involves no particular features, difficulties or
special tools, the method is not described in this manual, being considered very simple for
a vehicle repair specialist.
The labour times are the result of time and motion studies carried out in our workshops,
even though certain methods have not been described in the Workshop Repair Manual.
UNITS OF MEASUREMENT
• All dimensions are expressed in millimetres (mm) unless otherwise indicated.
• Tightening torques are expressed in decaNewton.metres (
daN.m).
• Pressure are given in
bars (reminder: 1 bar = 100 000 Pa).
• Electrical resistance values are in Ohms (Ω).
• Voltages are expressed in Volts (
V).
TOLERANCES
Tightening torques given without a tolerance must be accurate to within:
• In
degrees : ± 3°.
• In
daN.m : ± 10 %.
VALUES AND SETTINGS
Tyres and wheels
07
Vehicle Wheel rim TyresCold inflation pressure
(in bars) (1)
Front Rear
FC0X
KC0X5 B 13
5 B 13
5.5 J 14165/70 R 13 C 88/86
165/70 R 13 83 (2)
165/70 R 142.8
2.6
2.43.6
2.9
3.0
(1) Fully laden and motorway use.
Tightening torque of wheel nuts : 9 daN.m
Rim run-out: 1.2 mm
(2) Reinforced tyre.
07-14
