ENGINE AND PERIPHERALS
En
gine repair10
PREPARATION OF THE GUDGEON PINS
Check that the gudgeon pins are able to slide
freely in the corresponding new pistons.
Use centring device
C13 and mounting tools
A13
or
A13-01 for the shouldered gudgeon pins.
Mount the gudgeon pin (E) on the mounting tool
(A), tighten the centring device (C)
until contact is
made, then slacken b
y a quarter turn.
76716R PREPARATION OF THE CONNECTING RODS
Visually check:
- the condition of the connecting rod (twisting -
straightness),
- the bearing surface between the shells and the
connecting rod bodies (if necessary, remove
any burrs with a grinding wheel to obtain a co
r-
rect bearing surface).
Use a
1500 W heating plate.
Put the little ends on the heating plate.
Ensure that the whole surface of the little end is in
contact with the plate.
Put a piece of self-pickling tin solder with a mel-
ting point of about
250
° onto each little end at (a)
to act as a temperature check.
Heat the little end until the piece of self-pickling
solder melts.
DI1038
12367R
10-39
Page 1 of 1 E_Series_41
04.08.2003 http://jester.com.ua/renault/motors/e/E_Series/css/E_Series_41.htm
