Page 260 of 419
Turn the nut holding the jack counterclockwise and remove
it. Then remove
the jack and wrench. The tools you'll
be using include the
jack (A), extension
and protectodguide
(B) and wheel wrench (C).
5-26
ProCarManuals.com
Page 261 of 419
If there is a wheel cover,
loosen the plastic nut caps
with the wheel wrench.
They won’t come off. Then, using the flat end
of the
wheel wrench, pry along the
edge of the cover until it
comes off. Be careful; the
edges may be sharp. Don’t
try to remove the cover with
your bare hands.
Removing the Flat Tire and Installing the
Spare Tire
If your vehicle has wheel nut caps, remove them using
the wheel wrench.
1. Using the wheel wrench, loosen all the wheel nuts.
Don’t remove them yet.
2. Turn the jack handle clockwise to raise the jack lift
head
a few inches.
5-27
ProCarManuals.com
Page 263 of 419
& CAUTION:
- -
Raising your vehicle with the jack i
positioned can damage the vehicle and even make
the vehicle fall. To help avoid personal injury and
vehicle damage, be sure
to fit the jack lift head into
the proper location before raising the vehicle.
3. Raise the vehicle by turning the jack handle
clockwise. Raise the vehicle far enough off the
ground for the spare tire to fit under the vehicle.
Remove all wheel nuts and take off the flat tire.
4. Remove any rust or dirt
from the wheel bolts,
mounting surfaces
and
spare wheel.
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after a time. The wheel could come
off and cause an accident. When you change a
wheel, remove any rust or dirt from the places
where the wheel attaches to the vehicle.
In an
CAUTION: (Continued)
5-29
ProCarManuals.com
Page 264 of 419
CAUTION: (Continued)
emergency, you can use a cloth
or a paper towel
to
do this; but be sure to use a scraper or wire
brush later, if you need to, to get all the rust or
dirt off.
I
Never use oil or grease on studs or nuts. If you
do, the nuts might come loose. Your wheel could
fall
off, causing a serious accident.
5. Replace the wheel nuts
with the rounded end
of the nuts toward the
wheel. Tighten each nut
by hand until the wheel
is held against the hub.
6. Lower the vehicle by turning the jack handle
counterclockwise. Lower the jack completely.
ProCarManuals.com
Page 267 of 419
Storing the Spare Tire and Tools
1
I
Storing a jack, a tire or ‘other equipment in the
passenger compartment
of the vehicle could
cause injury. In a sudden stop or collision, loose
equipmen.t could strike someone. Store all these in the proper place.
The compact spare is for temporary use only. Replace
the compact spare tire with a full-size tire as soon as you
can. See “Compact Spare Tire” in the Index. See the
storage instructions label to replace your compact spare
into your trunk properly.
Be sure to calibrate your check tire pressure system after
you replace your compact
spare tire with a full-sized
one. See “Check Tire Pressure Light” in the Index.
I
1. Retainer
2. Cover
3. Retainer
(Full Size
Spare)
4. Tire
5. Nut
6. Jack
7. Wrench
8. Lock Nut Tool
9. Foam
10. Bolt Screw
11. Extension and
Protector/Guide
5-33
ProCarManuals.com
Page 276 of 419
The cap is behind a hinged door on the left side of
vour vehicle.
While refueling, hang the
cap inside the fuel door.
To take off the cap, turn it slowly to the left
(counterclockwise).
If you get gasoline on yourself and then
something ignites
it, you could be badly burned.
Gasoline can spray out on you
if you open the
fuel filler cap too quickly. This spray can happen
if your tank is nearly full, and is more likely in
hot weather. Open the fuel filler cap
slowly and
wait for any
“hiss” noise to stop. Then unscrew
the cap all the way.
~ ~~
Be careful not to spill gasoline. Clean gasoline from
painted surfaces
as soon as possible. See “Cleaning the
Outside of Your Pontiac” in the Index.
6-6
ProCarManuals.com
Page 277 of 419
When you put the cap back on, turn it to the right
(clockwise) until you hear at least three clicks. Make
sure you fully install the cap.
NOTICE:
If you need a new cap, be sure to get the right
type. Your dealer can get one for you.
If you get
the wrong type, it may not
fit or have proper
venting, and your fuel tank and emissions system
might be damaged.
Checking Things Under the Hood
A CAUTION:
An electric fan under the hood can start up and
injure you even when the engine is not running.
Keep hands, clothing and tools
away from any
underhood electric fan.
Things that burn can get on hot engine parts and
start
a fire. These include liquids like gasoline,
oil, coolant, brake fluid, windshield washer and
other fluids, and plastic
or rubber. You or others
could
be burned. Be careful not to drop or spill
things that will burn onto
a hot engine.
6-7
ProCarManuals.com
Page 309 of 419
5. Rotate the lamp socket ring 1/4 turn counterclockwise
to remove it from the headlamp assembly.
6. Pull the lamp from the socket.
6-39
ProCarManuals.com