1997 NISSAN PATHFINDER radio antenna

3 Heater, air conditioner and audio system
Center and side vent ............................................. 3-2
Heater and air conditioner ....................................... 3-3
Semiautomatic air conditioner ................................. 3-7
Radio .................................................................... 3-15
Power antenna (If so equipped) ............................ 3-26
Manual antenna ................................................... 3-27
CB radio or car phone ......................................... 3-27
Z01.2.1/R50-DX

To turn the radio on, turn the ignition key to
ªACCº or ªONº. If you listen to the radio with
the engine not running, turn the key to the
ªACCº position.
Radio reception is affected by station signal
strength, distance from radio transmitter, build-
ings, bridges, mountains, and other external
influences. Intermittent changes in reception
quality normally are caused by these external
influences.
AM-FM RADIO WITH COMPACT
DISC PLAYER
The electronic tuning radio has an FM Diver-
sity reception system, which employs two an-
tennas. One is a rod type antenna; the other is
an antenna printed on the window. This sys-
tem automatically switches to the antenna
which is receiving less noise.
Radio operation
Pushthe FM/AM button to listen to the radio
and tune in the desired station.
Pushing the FM/AM button while the com-pact disc is playing will turn off the com-
pact disc player and turn on the radio.
Turnthe ON.VOL knob to adjust the volume.
Clock set (Adjustment)
Depressing the ªCLOCKº and the ªº but-
tons together will set hours. Depressing the
ªCLOCKº and ª
º buttons together will set
minutes.
Clock operation
By pressing the ªCLOCKº button, you can
alternate the clock and the radio/cassette tape
options in the display.
SAA0247
RADIO
3-15
Z01.2.1/R50-DX

AM-FM RADIO WITH CASSETTE
PLAYER AND COMPACT DISC
PLAYER (Bose audio system)
Head unit
The radio has an FM Diversity reception sys-
tem, which employs two antennas. One is a
rod type antenna; the other is an antenna
printed on the window. This system automati-
cally switches to the antenna which is receiv-
ing less noise.
The tape deck employs a permalloy head
which allows for improved reproduction of high
frequency ranges. Noise is also greatly re-
duced by the combined use of the Dolby NR
(noise reduction) system. The auto loudness
circuit enhances the low frequency range au-
tomatically in both radio reception and tape
playback.
Power button
Turn the ignition key to ªACCº or ªONº, and
then push the POWER/VOLUME control knob
while the system is off to call up the mode
(radio, tape or CD) which was playing imme-
diately before the system was turned off.
When no CD or tape is loaded, the radio will
come on. While the system is on, pushing the
POWER/VOLUME control knob turns the sys-
tem off.
SAA0187
3-20
Z01.2.1/R50-DX

PROG (program) button
When this button is pushed while the compact
disc is being played, the play pattern will
change as follows:
ALL: All the programs will be played repeat-
edly in sequence.
1: Only one program (the one being played
when the PROG button is pushed) will be
repeated.
RANDOM: Programs will be played at ran-
dom, not following the sequence on the com-
pact disc. The same program may be re-
peated twice.
(no mark): All the programs will be played in
sequence and stop when the last program is
finished.
I
When the compact disc is ejected, the
play pattern will automatically change
to ALL.
CD EJECT button
When the CD EJECT button is pushed with the
compact disc loaded, the compact disc will be
ejected.
When this button is pushed while the compact
disc is being played, the compact disc will
come out and the system will turn off.If the compact disc comes out and is not
removed, it will be pulled back into the slot
to protect it.
CD (DISC) indicator light
This light comes on when the compact disc is
loaded.
IDuring cold weather or rainy days,
the player may malfunction due to the
humidity. If this occurs, remove the
CD and dehumidify or ventilate the
player completely.
IThe player may skip while driving on
rough roads.
IThe CD player sometimes cannot
function when the compartment tem-
perature is extremely high. Decrease
the temperature before use.
IDo not expose the CD to direct
sunlight.
The antenna will automatically extend when
the radio is turned on, and retract when
switched off. If the radio is left on, the antenna
will retract and extend with the ignition key
ªOFF-ONº operation.
IBefore turning the radio on, make
sure that there is no one near the
antenna outlet and there is enough
space for it to extend.
ITo prevent damage, be sure that an-
tenna is fully retracted before the
vehicle enters an automated car
wash.
IDirt and other foreign matter on the
power antenna rod may interrupt its
operation. Clean the rod periodically
with a damp cloth. This type of clean-
ing is especially important during the
winter seasons in areas where road
salt and other chemicals may be
spread on road surfaces and
splashed onto the antenna rod.
POWER ANTENNA (If so
equipped)
3-26
Z01.2.1/R50-DX

The antenna cannot be shortened but can be
removed.
Turn its root counterclockwise to remove the
antenna.
Be sure to remove the antenna before
washing the vehicle in an automatic car
washing machine, or the antenna may
be damaged.
When installing large capacity wireless equip-
ment or a car phone in your NISSAN, be sure
to observe the following as it may adversely
affect the Multiport fuel injection system and
other electronic parts depending on its instal-
lation location.
IKeep the antenna as far as possible
away from the Electric Control Mod-
ule.
IAlso keep the antenna wire more than
8 inches (20 cm) away from the Elec-
tro Injection harness. Do not route
the antenna wire next to any harness.
IAdjust the antenna standing-wave ra-
tio as recommended by the manufac-
turer.
IConnect the ground wire from the
radio chassis to the body.
IFor details, consult a NISSAN dealer.
SAA0164
MANUAL ANTENNA CB RADIO OR CAR PHONE
3-27
Z01.2.1/R50-DX

IDo not use a wax containing any abrasives,
cutting compounds or cleaners that may
damage the vehicle finish.
IIf the surface does not polish easily, use a
ªroad tarº remover and wax again.
Machine compounding or aggressive pol-
ishing on a base coat/clear coat paint finish
may dull the finish or leave swirl marks.
Only apply black wax or black shoe polish to
the black urethane or polypropylene bumper.
Removing spots
Remove tar and oil spots, industrial dust, in-
sects and tree sap as quickly as possible from
the surface of the paint to avoid lasting dam-
age or staining. Special cleaning products are
available at your NISSAN dealer or any auto-
motive accessories store.
Underbody
In areas where road salt is used in winter, it is
necessary to clean the underbody regularly in
order to prevent dirt and salt from building up
and causing corrosion on the underbody and
suspension. Before the winter period and
again in the spring, the underseal must be
checked and, if necessary, re-treated.
Cleaning glass
Use glass cleaner to remove smoke and dust
film from the glass surfaces. It is normal for
glass to be coated with a film after the vehicle
is parked in the hot sun. Glass cleaner and a
soft cloth will easily remove this film.
IWhen cleaning the inside of the win-
dow, do not use any sharp-edged
tools or abrasive cleaners or
chlorine-based disinfectant cleaners.
IThese may damage the radio antenna
elements or rear window defroster.
Cleaning aluminum alloy wheels
Wash regularly, especially during winter
months in areas where road salt is used. Salt
could discolor the wheel if not removed.
Chrome parts
Clean all chrome parts regularly with a non-
abrasive chrome polish to maintain the finish.
Cleaning interior
Occasionally remove loose dust from the inte-
rior trim, plastic parts and seats using a
vacuum cleaner or soft brush. Wipe the vinyl
and leather surfaces with a clean, soft cloth
dampened in mild soap solution, then wipe
clean with a dry soft cloth. Before using any
fabric protector, read the manufacturer's rec-
ommendations. Some fabric protectors con-
tains chemicals that stain or bleach the seat
material.
6-3
Z01.2.1/R50-DX

Lock
Anti-lock brake system .............................. 4-25
Back door locks ........................................... 2-8
Child safety rear door lock .......................... 2-3
Door locks ................................................... 2-2
Fuel filler lid lock ....................................... 2-10
Glove box lock........................................... 2-10
Power door lock .......................................... 2-3
Rear window locks ...................................... 2-8
Luggage (See ªvehicle loading informationº)
Luggage board and box ................................. 1-26
Luggage hooks ............................................... 2-45
Luggage net .................................................... 2-44
Luggage rack .................................................. 2-46
M
Maintenance
Explanation of maintenance items ............ 8-10
General maintenance .................................. 8-2
Periodic maintenance .................................. 8-5
Readiness for inspection/maintenance (I/M)
test ............................................................. 9-22
Seat belt maintenance .............................. 2-34
Manual antenna .............................................. 3-27
Meters and gauges ........................................... 1-3
Mirror
Inside mirror .............................................. 2-44
Outside mirror control................................ 2-42
Outside heated defroster
(If so equipped) ......................................... 1-18
Outside mirrors .......................................... 2-43
Vanity mirror light ...................................... 1-30Multi-remote control system (If so equipped) ... 2-4
O
Oil
Changing engine oil .................................... 7-8
Changing oil filter ........................................ 7-9
Checking engine oil level ............................ 7-7
Engine oil..................................................... 7-7
Engine oil and oil filter
recommendation .......................................... 9-6
On-pavement and off-road driving precautions .. 4-
4
Operating the transmitter ................................ 1-33
Outside mirror control ..................................... 2-42
Outside heated defroster (If so
equipped) ........................................................ 1-18
Outside mirrors ............................................... 2-43
Overheat
If your vehicle overheats ............................. 5-9
P
Parking ............................................................ 4-23
Parking brake ................................... 4-13, 7-18
Periodic maintenance ....................................... 8-5
Power
Power antenna (If so equipped)................ 3-26
Power door lock .......................................... 2-3
Power socket ............................................. 1-22
Power steering fluid................................... 7-11
Power steering system .............................. 4-24
Power support seat ................................... 2-14
Power window ........................................... 1-27Precautions ....................................................... 7-2
Driving safety precautions ......................... 4-21
On-pavement and off-road driving
precautions .................................................. 4-4
Precautions on seat belt usage ................ 2-27
Precautions when starting and driving ........ 4-2
Programming problem diagnosis .................... 1-33
Programming the HomeLink
transmitter ....................................................... 1-32
Protecting against corrosion ............................. 6-5
Push starting ..................................................... 5-9
R
Radio............................................................... 3-15
AM-FM radio with cassette player and compact
disc player (Bose audio system) ............... 3-20
AM-FM radio with compact disc
player ......................................................... 3-15
CB radio or car phone............................... 3-27
Radio operation ......................................... 3-22
Readiness for inspection/maintenance (I/M) test
(For U.S.A.)..................................................... 9-21
Rear seats ...................................................... 2-16
Rear window defroster switch......................... 1-18
Rear window locks ............................................ 2-8
Rear window wiper and washer switch .......... 1-17
Recommended SAE viscosity number ............. 9-8
Refrigerant recommendation ............................ 9-9
Reporting safety defects (For U.S.A.) ............ 9-20
10-3
Z01.2.1/R50-DX