1997 Mercury Villager wiring

150
*
[SS13350(ALL)05/96]
RWARNING
The air bag will inflate only once. The system is
designed to function on a one-time-only basis. If the air
bag is inflated, THE AIR BAG WILL NOT FUNCTION
AGAIN AND MUST BE REPLACED IMMEDIATELY. If
the air bag is not replaced, this will increase the risk of
injury in a subsequent collision.
*
[SS13360(ALL)05/96]
The Air Bag Supplemental Restraint System consists of:
*
[SS13370(ALL)05/96]
n
driver and passenger air bag modules (which include the
inflators and air bags),
*
[SS13380(ALL)05/96]
n
one or more impact and safing sensors,
*
[SS13390(ALL)05/96]
n
a system diagnostic module,
*
[SS13400(ALL)05/96]
n
a readiness light and tone,
*
[SS13410(ALL)05/96]
n
and the electrical wiring which connects the components.
*
[SS13420(ALL)05/96]
The diagnostic module monitors its own circuits, the air bag
electrical system, the air bag readiness light, the air bag power
and the air bag inflators.
File:06vxssn.ex
Update:Thu Jun 6 10:54:22 1996

Driving
237
*
[GF19200(ALL)01/96]
Do not use single clamp bumper hitches or hitches that attach
to the axle.
*
[GF19300(ALL)01/96]
Whenever a trailer hitch and hardware are removed, make sure
all mounting holes in the underbody are properly sealed to
prevent exhaust fumes from entering the vehicle.
*
[GF19400(ALL)01/96]
Safety chains
*
[GF19500(ALL)01/96]
Always use safety chains between your vehicle and trailer.
Cross chains under the trailer tongue and allow slack for
turning corners. Connect safety chains to the vehicle frame or
hook retainers.Never attach chains to the bumper.
%*
[GF19600(ALL)01/96]
Trailer Brakes
*
[GF19700(ALL)01/96]
Separate trailer brakes are required on most trailers weighing
over 1,500 lbs. (680 kg).
*
[GF19800(ALL)05/96]
RWARNING
Do not connect a trailer's hydraulic brake system directly
to your vehicle's brake system. Your vehicle may not
have enough braking power and your chances of having
a collision greatly increase.
%*
[GF19900(ALL)01/96]
Trailer Lamps
*
[GF20000(ALL)01/96]
Make sure your trailer lamps conform to federal and local
regulations.
*
[GF20100(ALL)01/96]
Class I Trailer Tow electrical wiring provides two circuits (right
hand and left hand) to operate trailer stop/turn tail lamps. Each
stop/turn circuit will operate one combination stop/turn light
bulb (# 1157, 3157, 2357, or 3357) on the trailer. Never add more
than one trailer light bulb to one circuit.
File:09vxgfn.ex
Update:Thu May 30 09:54:10 1996

238
*
[GF20200(ALL)01/96]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
[GF20210(ALL)01/96]
Trailer Tow Module (If equipped)
[GF20220(ALL)01/96]
The trailer tow module on your vehicle (if equipped) allows
turn/stop lamp control on a trailer being towed by your
vehicle.
[GF20230(ALL)01/96]
The trailer tow package includes:
[GF20240(ALL)01/96]
n
trail or tow module which draws power from the vehicle
stop lamp fuse
[GF20250(ALL)01/96]
n
one SAE J1239 specified connector
[GF20260(ALL)01/96]
n
one extension harness within the rear bumper
[GF20270(ALL)01/96]
If you need further assistance in wiring a trailer to your vehicle,
contact your Ford or Lincoln-Mercury dealer.
%*
[GF20300(ALL)05/96]
Driving While You Tow
*
[GF20400(ALL)05/96]
Be especially careful when driving while you tow a trailer.
Never drive faster than 45 mph (70 km/h) when you tow in
hilly country on hot days. Also, anticipate stops so that you can
brake gradually.
*
[GF20500(ALL)01/96]
If you use the speed control while you are towing on very long,
steep grades, the speed control may shut off automatically.
*
[GF20600(ALL)01/96]
When descending a steep grade with a trailer, operate in Drive
rather than Overdrive. If additional braking is needed, shift into
2 (Second) or 1 (First) gear.
File:09vxgfn.ex
Update:Thu May 30 09:54:10 1996