1997 Mercury Villager warning light

150
*
[SS13350(ALL)05/96]
RWARNING
The air bag will inflate only once. The system is
designed to function on a one-time-only basis. If the air
bag is inflated, THE AIR BAG WILL NOT FUNCTION
AGAIN AND MUST BE REPLACED IMMEDIATELY. If
the air bag is not replaced, this will increase the risk of
injury in a subsequent collision.
*
[SS13360(ALL)05/96]
The Air Bag Supplemental Restraint System consists of:
*
[SS13370(ALL)05/96]
n
driver and passenger air bag modules (which include the
inflators and air bags),
*
[SS13380(ALL)05/96]
n
one or more impact and safing sensors,
*
[SS13390(ALL)05/96]
n
a system diagnostic module,
*
[SS13400(ALL)05/96]
n
a readiness light and tone,
*
[SS13410(ALL)05/96]
n
and the electrical wiring which connects the components.
*
[SS13420(ALL)05/96]
The diagnostic module monitors its own circuits, the air bag
electrical system, the air bag readiness light, the air bag power
and the air bag inflators.
File:06vxssn.ex
Update:Thu Jun 6 10:54:22 1996

190
[RR04500(ALL)01/93]
If you decide to move the three-passenger bench seat forward to
the second row position, passengers riding in the seat will use
the second row safety belts.
[RR04600(ALL)04/95]
Installing the Two-Passenger Bench Seat
[RR04700(ALL)01/93]
To replace the bench seat in its original position:
[RR04800(ALL)07/95]1.
Make sure the area around the floor anchor positions is free
from obstruction.
[RR04900(ALL)01/93]2.
With the seatback folded down, two people should lift the
seat into the vehicle.
[RR05000(ALL)01/93]3.
Place the seat slightly behind the floor anchor positions and
catch the rear leg anchors into each anchor position.
[RR05100(ALL)01/93]4.
Press down on the front of the seat to secure the front legs
to the two floor latch locks. Place the seatback in the upright
position.
[RR05200(ALL)01/93]5.
Try to move the seat to be sure that it is securely fastened.
[RR05300(ALL)05/96]6.
Always reattach the tongue into the auxiliary buckle
mounted to the sliding door side of the seat.
[RR05400(ALL)01/93]
Labels have been provided on the side of the seat to remind
you of important safety precautions.
[RR05700(ALL)01/93]7.
Replace any floor mats that were removed.
[RR05800(ALL)01/93]
RWARNING
Keep foreign objects out of the floor anchors. Objects in
the floor anchors could prevent front and rear seat legs
from engaging properly.
File:07vxrrn.ex
Update:Thu May 30 09:53:21 1996

196
[RR08000(ALL)01/93]
Installing the Removable Bucket Seats
[RR08100(ALL)01/93]
To position the bucket seats back in their original positions:
[RR08200(ALL)07/95]1.
Make sure the area around the floor anchor positions is free
from obstruction.
[RR08300(ALL)01/93]2.
With the seatback folded down, two people should lift the
seat into the vehicle.
[RR08400(ALL)01/93]3.
Place the seat slightly behind the floor anchor positions and
catch the rear leg anchors into each anchor position.
[RR08500(ALL)01/93]4.
Press down on the front of the seat to secure the front legs
to the two floor latch locks. Place the seatback in the upright
position.
[RR08600(ALL)01/93]5.
Try to move the seat to be sure that it is securely fastened.
[RR08650(ALL)06/95]6.
Replace any floor mats that were removed.
[RR08700(ALL)01/93]
Labels have been provided on the side of the seats to remind
you of important safety precautions.
[RR09000(ALL)01/93]
RWARNING
Keep foreign objects out of the floor anchors. Objects in
the floor anchors could prevent front and rear seat legs
from engaging properly.
[RR09100(ALL)01/93]
RWARNING
Before sitting in the removable seats, make sure that the
seat legs are securely attached by the floor anchors.
File:07vxrrn.ex
Update:Thu May 30 09:53:21 1996

211
Starting
%*
[TO04600(ALL)01/96]
Fuel-Injected Engines
*
[TO04700(ALL)01/96]
When starting a fuel-injected engine,the most important thing
to remember is to avoid pressing down on the accelerator
before or during starting. Only use the accelerator when you
have problems getting your vehicle started. SeeStarting Your
Enginein this chapter for details about when to use the
accelerator while you start your vehicle.
*
[TO04750(ALL)01/96]
Starting Your Vehicle
%*
[TO04800(ALL)01/96]
Preparing to Start Your Vehicle
*
[TO04900(ALL)02/96]
RWARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open
the garage door before you start the engine.
*
[TO04950(ALL)01/96]
Before you start your vehicle, always:
*
[TO05000(ALL)01/96]1.
Make sure you and all your passengers buckle your safety
belts. SeeSafety beltsin the Index for more details.
*
[TO05100(ALL)01/96]2.
Make sure the headlamps and other accessories are turned
off when starting.
*
[TO05200(ALL)01/96]3.
Make sure that the gearshift is in P (Park) and the parking
brake is set before you turn the key.
[TO05400(ALL)03/96]4.
Test the warning lights on the instrument cluster to make
sure they work. Refer to theInstrumentationchapter.
%*
[TO05700(ALL)01/96]
Starting Your Engine
*
[TO05800(ALL)01/96]
To start your engine:
*
[TO05900(ALL)01/96]1.
Follow the steps underPreparing to Start Your Vehicleat the
beginning of this section.
*
[TO06000(ALL)01/96]2.
Keep your foot on the brake pedal and turn the ignition key
to ON.
File:08vxton.ex
Update:Thu May 30 09:53:35 1996

Starting
213
*
[TO07370(ALL)12/95]
NOTE: Your vehicle has an interlock that prevents you from
shifting out of P (Park) unless your foot is on the
brake pedal.
%*
[TO07500(ALL)01/96]
If the engine does not start after two attempts:
*
[TO07600(ALL)01/96]1.
Turn the ignition key to the OFF position.
*
[TO07700(ALL)01/96]2.
Press the accelerator all the way to the floor and hold it.
*
[TO07800(ALL)01/96]3.
Turn the ignition key to the START position.
*
[TO07900(ALL)01/96]4.
Release the ignition key when the engine starts.
*
[TO08000(ALL)03/96]5.
Release the accelerator gradually as the engine speeds up.
*
[TO08100(ALL)05/96]
If the engine still does not start, the fuel pump shut-off switch
may have been activated. For directions on how to reset the
switch seeFuel Pump Shut-Off Switchin the index.
%*
[TO08200(ALL)01/96]
A computer system controls the engine's idle speed. When you
start your vehicle, the engine's idle speed normally runs high.
These faster engine speeds will make your vehicle coast slightly
faster than its normal idle speed. It should, however, slow down
after a short time. If it does not, have the idle speed checked.
*
[TO08290(ALL)01/96]
If the engine idle speed does not slow down automatically, do
not allow your vehicle to idle for more than 10 minutes. Have
the vehicle checked.
*
[TO08300(ALL)01/96]
RWARNING
Extended idling at high engine speeds can produce very
high temperatures in the engine and exhaust system,
creating the risk of fire or other damage.
File:08vxton.ex
Update:Thu May 30 09:53:35 1996

216
*
[TO09065(ALL)01/96]5.
Check under the vehicle again for leaking fuel. If you see or
smell fuel, do not start your vehicle again. If there is no fuel,
you can try to start your vehicle again.
*
[TO09070(ALL)03/96]6.
Check all vehicle warning lights before driving your vehicle.
*
[TO09100(ALL)12/95]
Guarding Against Exhaust Fumes
*
[TO09200(ALL)01/96]
Carbon monoxide, although colorless and odorless, is present in
exhaust fumes. Take precautions to avoid its dangerous effects.
*
[TO09300(ALL)02/96]
RWARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open
the garage door before you start the engine.
*
[TO09400(ALL)01/96]
RWARNING
If you ever smell exhaust fumes of any kind inside your
vehicle, have your dealer inspect and fix your vehicle
immediately. Do not drive if you smell exhaust fumes.
These fumes are harmful and could kill you.
*
[TO09500(ALL)01/96]
Have the exhaust and body ventilation systems checked by a
qualified technician whenever:
*
[TO09600(ALL)01/96]
n
your vehicle is raised for service
*
[TO09700(ALL)01/96]
n
the sound of the exhaust system changes
*
[TO09800(ALL)01/96]
n
your vehicle has been damaged in an accident
*
[TO09900(ALL)01/96]
Improve your ventilation by keeping all air intake vents clear of
snow, leaves, and other objects.
*
[TO10000(ALL)01/96]
If the engine is idling while you are stopped in an open area
for long periods of time, open the windows at least one inch
(2.5 cm). Also, adjust the heating or air conditioning system to
bring in outside air.
File:08vxton.ex
Update:Thu May 30 09:53:35 1996

219
Driving
%*
[GF06200(ALL)05/96]
Brakes
*
[GF06300(ALL)01/96]
When the foot (service) brake pedal is depressed, the
high-mount brake lamp should illuminate.
*
[GF06400(ALL)01/96]
Front Disc Brakes
*
[GF06500(ALL)01/96]
The front disc brakes are self-adjusting. They do not require
service other than periodic lubrication of the caliper slide rails
and inspection for pad wear.
*
[GF06600(ALL)03/96]
Rear Drum Brakes
*
[GF06700(ALL)01/96]
The rear drum brakes are self-adjusting. Automatic adjustment
occurs through normal use of the brakes.
*
[GF06800(ALL)05/96]
Four-Wheel Anti-lock Brakes (If Equipped)
*
[GF06900(ALL)01/96]
The Anti-lock Brake System (ABS) prevents wheels from
completely locking up by automatically releasing and
re-applying the brakes. During ABS braking, slight brake pedal
pulsations may be felt on the driver's foot. These pulsations
represent the rapid cycling of the ABS valves. The pedal
pulsations are considered normal ABS operation, and will stop
when normal braking is resumed or when the vehicle comes to
a stop.
%*
[GF07000(ALL)01/96]
During ABS activation, a mechanical noise may be heard as the
ABS system cycles. This is normal ABS operation.
*
[GF07100(ALL)01/96]
The ABS system has self-check capabilities. The system turns on
the ABS warning light each time you start the engine. After the
engine is started and the ABS warning light turns off, the
system performs another test the first time the vehicle reaches
4 mph (6 km/h). A mechanical noise may be heard as the ABS
system performs a self test. This is a normal part of the self test
feature. If a malfunction is found during this check, the ABS
warning light will come on.
File:09vxgfn.ex
Update:Thu May 30 09:54:10 1996

220
*
[GF07200(ALL)01/96]
You should always be careful when braking, even if your
vehicle has the ABS system. Heavy braking on roads with loose
surfaces such as snow or gravel, or roads with severe pavement
irregularities could also cause you to lose control of your
vehicle.
*
[GF07300(ALL)03/96]
RWARNING
If the anti-lock brake system warning light remains on or
comes on while driving, have the braking system checked
by a qualified service technician as soon as possible.
*
[GF07310(ALL)03/96]
NOTE: If a fault occurs in the anti-lock system, and the brake
warning light is not lit, the anti-lock system is
disabled but normal brake function remains
operational.
[GF07350(ALL)01/96]
Ford Motor Company has not found any negative effects of
mobile radio transmitting equipment installed on vehicles with
the ABS system providing that the radio is installed according
to the radio manufacturer's instructions. However, if you have
had a mobile radio transmitter installed and the check ABS light
comes on (at any time other than immediately after turning the
key to the ON position) have your mobile radio dealer inspect
the installation. Also, if the ABS system is activated other than
during maximum braking, have your mobile radio installation
checked.
%*
[GF07400(ALL)03/96]
If Brakes Do Not Grip Well or Pedal is ªLowº
*
[GF07500(ALL)01/96]
If the brake pedal seems ªlowº it may indicate the need for a
brake system inspection and/or service. Apply your parking
brake several times. If the condition has not improved, you
should have your brakes checked as soon as possible.
%*
[GF07600(ALL)01/96]
Occasional brake squeal during light to moderate stops does not
affect the function of the brake system and is normal. However,
if the squeal becomes very loud or if it becomes more frequent,
return the vehicle to your dealer for inspection.
File:09vxgfn.ex
Update:Thu May 30 09:54:10 1996