1997 LINCOLN MARK VIII mirror controls

78The button that controls the rear window
defroster and heated outside rearview mirrorsBefore using the defroster, clear away any snow
that is on the rear window and outside rearview
mirrors. With the engine running, push the
defroster button.
After approximately 10 minutes, the defroster will
turn off. If the window or mirrors are still not clear,
turn the defroster on again.The defroster will turn off when the ignition key is
turned to the OFF or START position.
The heating elements are bonded to the inside of
the rear window. Do not use sharp objects to
scrape the inside of the rear window or use
abrasive cleaners to clean it. Doing so could damage
the heating elements.
The Interior and Exterior LightsDaytime Running Light System(Canadian vehicles only)The Daytime Running Light (DRL) system is
designed to turn the low beam headlamps on when
all of the following conditions are met:q
The headlamp system is in the OFF position,
and
q
The vehicle is running, and
q
The vehicle has a fully released parking brake.
File:05fncf8.ex
Update:Thu Jun 27 10:02:20 1996

124When you use the remote entry UNLOCK, TRUNK
or PANIC buttons, the illuminated entry system
turns on the interior lights for 25 seconds. You can
turn these lights off with the LOCK button or by
turning the ignition to the RUN position.Memory Seat/Mirrors/Steering Column
FeatureYour vehicle allows the remote keyless entry system
to control the Memory Seat/Mirrors/Steering
Column feature. With this feature, each of the first
two transmitters programmed will recall a different
seat position.
Pressing the transmitter UNLOCK button once will
unlock the driver's door and move the seat to its
corresponding memory seat/mirrors position, just as
if you had pressed the memory button in the
vehicle.When your dealer programs new transmitters, the
order of programming controls seat recall as follows:
q
First Transmitter Programmed Ð Recall
Seat/Mirrors/Steering Column Position #1
q
Second Transmitter Programmed Ð Recall
Seat/Mirrors/Steering Column Position #2
q
Third Transmitter Programmed Ð NO
Recall/Memory Seat/Mirrors/Steering Column
(allows only three positions)
You may change seat/mirrors positions at any time.
Once programmed, Transmitter #1 will always
move the seat/mirrors/steering column to position
#1.
The feature is turned on at the factory for your
convenience. You can deactivate the system by
using the OFF button or switching the key fob
switch to OFF.
File:05fncf8.ex
Update:Thu Jun 27 10:02:20 1996

299
Climate control system
air conditioning........... 69
electronic automatic temperature
control.............. 69
heating............... 69
Clock................. 82
Clutch
fluid reservoir............ 225
specifications............ 265
Combination lap and shoulder belts.... 138
Console, description.......... 115
Controls, mirrors............ 99
Convenience kit in cargo area...... 202
Coolant (see Engine coolant)....... 228
checking and adding......... 228
preparing for storage......... 267
refill capacities............ 264specifications............ 265
temperature gauge.......... 17
warnings.............. 228
Cooling fan.............. 217
Crankcase emission filter........ 263
Cruise control indicator light....... 13
Customer Assistance Centre,
Ford of Canada............ 276
D
Daytime running light system...... 78
Defects, reporting............ 269
Dipstick................ 223
automatic transmission fluid...... 234
engine oil.............. 223
power steering fluid......... 233
Disabled vehicle (see Towing)...... 213
Dispute Settlement Board........ 272
Doors................. 106
lubricant specifications........ 265
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996