1997 FORD WINDSTAR child restraint

Seating and Safety Restraints
197
[SS25600(ALL)12/95]8.
Pull the shoulder belts out to ensure that the crotch safety
belt buckle and chest clip are securely fastened. Refer to
Figure 7.
[SS25700(ALL)12/95]
17-1/2 pica
art:0050142-B
Figure 7: Checking for securely latched buckle and chest clip
[SS25800(ALL)12/95]9.
Pull left shoulder belt fully out to put the retractor into the
lock mode. Allow belts to retract and fit snugly. The purpose
of the lock mode is to prevent the child from getting out of
the seat while the vehicle is in operation and to hold a
sleeping child in position. The belts will lock automatically
during a collision or hard braking.
File:06wnsss.ex
Update:Thu Jul 18 11:00:49 1996

Seatingan dSafet yRestraints
199
WARNING
If safet ybelt sar e no tproperl ywor nan dadjuste das
WARNING
Childre nshoul dalway srid ewit htheseatbac kin the

Seatingan dSafet yRestraints
201
WARNING
Whe nusin gforward-facin gchil dseat smov ethe
WARNING
If yo udo no tproperl ysecur eth esafet yseat ,th echild
WARNING
Carefull yfollo wallof th emanufacturer' sinstructions
WARNING
Alway skee pthebuckl ereleas ebutto npointin gupward

Seating and Safety Restraints
205
[SS30200(ALL)12/95]4.
Insert the belt into the proper buckle for that seating position
until you hear and feel the latch engage. See Figure 3. Make
sure the tongue is latched securely to buckle by pulling on
the tongue.
[SS30300(ALL)12/95]
17-1/2 pica
art:0050278-A
Buckling the belt
*
[SS30400(ALL)12/95]5.
Grasp the shoulder portion of the belt and pull downward
until all of the belt is extracted and a click is heard. At this
time, the retractor is in the automatic locking mode (child
restraint mode). See Figure 4.
[SS30500(ALL)12/95]
NOTE: The dual-locking mode retractor must be in the
automatic locking mode to properly restrain a child
seat.
File:06wnsss.ex
Update:Thu Jul 18 11:00:49 1996

Seating and Safety Restraints
209
[SS31000(ALL)12/95]7.
Before placing the child into the child seat, forcibly tilt the
seat from side to side and in forward directions to make
sure that the seat is securely held in place. See Figure 7.
[SS31100(ALL)12/95]
17-1/2 pica
art:0050282-A
Checking that the seat is secure
File:06wnsss.ex
Update:Thu Jul 18 11:00:49 1996

Seating and Safety Restraints
211
*
[SS31600(ALL)05/96]
Installing a Child Safety Seat at the Center Seating
Position with Locking Adjustable Lap Belt
*
[SS31700(ALL)01/96]1.
Lengthen the lap belt. To lengthen the belt, hold the tongue
so that its bottom is perpendicular to the direction of
webbing while sliding the tongue up the webbing.
*
[SS31800(ALL)01/96]2.
Place the child safety seat in the center seating position.
*
[SS31900(ALL)01/96]3.
Route the tongue and webbing through the child seat
according to the child seat manufacturer's instructions.
*
[SS32000(ALL)01/96]4.
Insert the belt tongue into the proper buckle for the center
seating position until you hear a snap and feel it latch. Make
sure the tongue is securely fastened to the buckle by pulling
on tongue.
*
[SS32100(ALL)01/96]5.
Push down on the child seat while pulling on the loose end
of the lap belt webbing to tighten the belt.
[SS32200(ALL)12/95]6.
Before placing the child into the child seat, forcibly tilt the
child seat from side to side and in forward directions to
ensure that the seat is held securely in place. If the child seat
moves excessively, repeat steps 5 through 6 or properly
install the child seat in a different seating position.
%*
[SS32300(ALL)04/96]
Attaching Safety Seats With Tether Straps
*
[SS32400(ALL)04/96]
Some manufacturers make safety seats that include a tether
strap that goes over the back of the vehicle seat and attaches to
an anchoring point. Other manufacturers offer the tether strap
as an accessory. Contact the manufacturer of your child safety
seat for information about ordering a tether strap.
[SS32500(ALL)12/95]
You can attach a tether strap to the front passenger or second
row seats by using the built-in tether anchors provided on the
back of the seats as described below.
[SS32600(ALL)12/95]
Follow the child seat manufacturer's instructions to attach the
tether strap to the tether anchor.
File:06wnsss.ex
Update:Thu Jul 18 11:00:49 1996

Seating and Safety Restraints
215
[SS33400(ALL)12/95]
17-1/2 pica
art:0050184-A
Figure 3: Tether anchor location Ð second row bench seat (without built-in
child safety seat)
File:06wnsss.ex
Update:Thu Jul 18 11:00:49 1996

Index
367
A
ABS warning light (see Anti-lock brake system)...... 12
Accessory position on the ignition............ 100
Additives, engine oil.................. 286
Air bag supplemental restraint system
and child safety seats..............181, 200
description...................180, 182
disposal...................... 186
driver air bag..................180, 182
indicator light..................... 17
operation...................... 182
passenger air bag.................. 182
proper seating................... 181
service and information labels............ 182
tone generator................... 186
wearing safety belts................. 180
Air cleaner filter, location............... 283
Air conditioning, manual heating and
air conditioning system.............. 83
Alarm, activating remote personal............ 141
Alcohol, in fuel.................... 314
Aluminum wheels................... 265
Antenna, radio (see Electronic sound system)...... 41,99
Antifreeze (see Engine coolant)............. 292
Anti-lock brake system (ABS)
description..................... 223
noise........................ 223
see also Brake.................... 223
warning light..................... 12
Anti-theft lug nuts and key............... 266
Anti-theft system
arming the system.................. 145
description..................... 144
disarming an untriggered system........... 146
disarming a triggered system............. 146
File:wnixs.ex
Update:Thu Aug 1 08:57:39 1996