1997 FORD RANGER ignition

68
*
[CF02550(R)01/96]
Operating tips
*
[CF02600(R)03/96]
The following tips will help you to get the most satisfaction
from your air conditioning (if equipped) and heater system.
[CF02650(R)01/96]
n
In humid weather, selectVbefore starting your engine.
This will help to prevent windshield fogging. After a few
minutes of operation, you may select another function.
[CF02700(R)01/96]
n
To prevent humidity buildup inside your vehicle, always
drive with the air conditioner or heater system turned on.
*
[CF02750(R)01/96]
n
Do not put objects under the front seats that interfere with
the flow of air to the back seat area.
[CF02800(R)01/96]
n
Remove any snow, ice, or leaves from the air intake area of
your air conditioner and heater system that could block the
air intake. The intake area is located at the bottom of the
windshield.
*
[CF02900(R)01/96]
Heater Controls (Heater-Only Vehicles)
[CF02950(R)01/96]
The control for your heater system is located at the center of the
instrument panel below the radio. The heater will operate only
when the ignition key is turned to the ON position. Your heater
will heat and/or ventilate your vehicle interior depending on
the function position and temperature you select. The function
selector control knob allows you to select heating or ventilation
and determine where the air will be directed. The temperature
control knob setting determines the temperature of the air that
flows into the vehicle.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

Controls and Features
73
*
[CF20300(R)01/96]
Clock Controls on Electronic Radios
[CF20400(R)02/96]
The electronic radios have a built-in clock. For complete
operating instructions, refer to theAudio Sectionin this Owner
Guide.
*
[CF20405(R)05/96]
The controls on the steering column and wheel are designed to
give you easy access to the controls while you are driving.
*
[CF20410(R)01/96]
Ignition
%*
[CF20420(R)01/96]
Understanding the Positions of the Ignition
[CF20430(R)01/96]
7-1/2 pica art:0021143-A
The positions of the key in the ignition lock cylinder.
%*
[CF20440(R)04/96]
ACCESSORY allows some of your vehicle's electrical accessories
such as the radio and the windshield wipers to operate while
the engine is not running.
*
[CF20442(R)03/96]
In order to turn the key from the ON or OFF position to the
ACCESSORY position, you must push the key release button if
your vehicle's manual transmission gearshift is mounted on the
floor.
*
[CF20444(R)01/96]
LOCK locks the steering wheel and gearshift lever.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

74
*
[CF20450(R)01/96]
RWARNING
LOCK position does not lock the gearshift on
floor-mounted manual transaxle gearshifts. If the parking
brake is not set and the gearshift is moved out of gear,
your vehicle may move unexpectedly and injure someone.
*
[CF20470(R)05/96]
RWARNING
Do not leave the vehicle unattended with the transfer
case in the N (Neutral) position. Always set the parking
brake fully and turn off the ignition when leaving the
vehicle.
*
[CF20480(R)01/96]
LOCK is the only position that allows you to remove the key.
The LOCK feature helps to protect your vehicle from theft.
*
[CF20482(R)01/96]
If your key is stuck in the LOCK position and will not turn,
move your steering wheel left or right until the key turns freely.
*
[CF20484(R)01/96]
OFF allows you to shut off the engine and all accessories
without locking the steering wheel or the automatic
transmission gearshift lever.
*
[CF20486(R)01/96]
ON allows you to test your vehicle's warning lights (except the
brake system warning light) to make sure they work before you
start the engine. The key returns to the ON position once the
engine is started and remains in this position while the engine
runs.
*
[CF20490(R)01/96]
START cranks the engine. Release the key once the engine starts
so that you do not damage the starter. The key should return to
ON when you release it. The START position also allows you to
test the brake warning light.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

76
*
[CF23200(R)08/95]
High Beams and Flashing the Lamps
[CF23500(R)01/96]
7-1/2 pica art:0090130-A
Headlamp high beam switch and turn signal lever on steering column
%*
[CF24400(R)01/96]
Windshield Wipers and Washer
*
[CF24500(R)04/96]
To turn on the windshield wipers, the ignition key must be
turned to the ON or ACC position.
[CF24900(R)01/96]
10-1/2 pica
art:0020084-D
Interval wiper on turn signal lever
*
[CF25000(R)08/95]
To set the interval wipers, rotate the knob at the end of the turn
signal lever toward or away from the instrument panel to the
interval operation you desire.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

80
[CF27500(R)01/96]
7-1/2 pica art:0020091-F
The speed control switches
%*
[CF27800(R)05/96]
To Turn Speed Control Off
*
[CF27820(R)05/96]
n
Press OFF,
*
[CF27840(R)05/96]
n
Turn off the vehicle ignition.
*
[CF27860(R)05/96]
Once speed control is switched off, the previously programmed
set speed will be erased.
*
[CF27880(R)05/96]
To Turn Speed Control On
*
[CF27900(R)05/96]
n
Press ON
*
[CF27920(R)05/96]
To Set a Speed
[CF27940(R)05/96]
Press SET ACCEL. For speed control to operate, the speed
control must be ON and the vehicle speed must be greater than
30 mph (48 km/h). The SPEED CONT light will illuminate in
the instrument cluster when a speed is set/engaged.
*
[CF27960(R)05/96]
If you drive up or down a steep hill, your vehicle speed may
vary slower or faster than the set speed. This is normal.
*
[CF27980(R)05/96]
Speed control cannot reduce the vehicle speed if it increases
above the set speed on a downhill. If your vehicle speed is
faster than the set speed while driving downhill in
j
(Overdrive), you may want to shift to the next lower gear to
reduce your vehicle's speed.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

84
*
[CF39200(R)01/96]
RWARNING
Do not drive your vehicle with the tailgate open unless
there is a load holding it in place.
%*
[CF39300(R)01/96]
Power Door Locks (If equipped)
[CF39500(R)05/96]
The power door lock switches are located in the front doors. To
lock all doors push the switch marked L. To unlock all doors
push the switch marked U.
*
[CF39600(R)01/96]
The manual door locks will override the power door lock
controls.
[CF39700(R)01/96]
7-1/2 pica art:0020204-F
Power door lock controls
%*
[CF46500(R)04/96]
Windows
%*
[CF47800(R)01/96]
Using the Power Windows (If equipped)
[CF47900(R)01/96]
Each door has a power control that opens and closes the
window on that door. The driver's door has a master control
switch that operates all door windows. You must place the
ignition switch in the ON or ACC position to use your power
window controls.
*
[CF48300(R)01/96]
RWARNING
Do not let children play with the power windows.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

Controls and Features
93
*
[CF80000(R)05/96]
Remote Entry System (If equipped)
[CF80010(R)01/96]
If your vehicle has the remote entry system, you can lock or
unlock the vehicle doors without using a key. The remote also
has a personal alarm feature. The buttons for the system are
located on the hand held transmitter that came with your
vehicle.
[CF80016(R)01/96]
The system will work with up to four transmitters. Your vehicle
came with one transmitter. Additional transmitters can be
ordered from your dealer.
*
[CF80018(R)01/96]
The remote entry features only operate with the ignition in the
OFF position.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997

94
[CF80020(R)05/96]
7-1/2 pica art:0090226-A
The remote entry transmitter
%*
[CF80080(R)05/96]
Unlocking the doors with the remote entry system
*
[CF80082(R)04/96]
To unlock the driver's door, press the UNLOCK control.
[CF80086(R)05/96]
To unlock the other door, press the UNLOCK control a second
time, within five seconds after the first UNLOCK.
*
[CF80100(R)05/96]
Locking the doors with the remote entry system
[CF80110(R)05/96]
To lock both doors, press the LOCK control. This will also arm
the factory installed Anti-Theft system.
[CF80114(R)05/96]
If you would like a signal that the doors are being locked, press
the LOCK control again within five seconds. If all doors are
completely closed, the doors will lock again, the horn will chirp,
and the parking lamps will flash. If a door is open or ajar, the
horn will give two short chirps warning you that a door is
open.
%*
[CF80200(R)05/96]
Remote entry personal alarm
[CF80210(R)05/96]
If you wish to activate the remote entry system personal alarm,
press the PANIC control. This will honk the horn and flash the
lights for approximately 2 minutes 45 seconds. You can turn it
off by pressing the PANIC control again from the transmitter or
by turning the ignition to the ON or ACCESSORY position.
File:05uncfr.ex
Update:Thu Mar 20 08:51:14 1997