1997 FORD PROBE stop start

150
*
[GF10400(ALL)08/95]
Upshifting
[GF10500(ALL)04/96]
For normal acceleration, you should upshift at
the following speeds:
[GF10600(ALL)01/96]
eight pica chart:0032089-A[GF10700(ALL)01/96]
For cruising, you should upshift at the following
speeds.
[GF10800(ALL)01/96]
eight pica chart:0032090-A%*
[GF10900(ALL)01/96]
Downshifting
*
[GF11000(ALL)03/96]
When you slow down or climb a steep hill,
always downshift before the engine starts to lose
power. Downshifting reduces the chance of
stalling and gives your vehicle better acceleration
to increase speed again.
*
[GF11100(ALL)01/96]
When you drive down steep hills, downshifting
helps you keep a safe speed and helps prevent
unnecessary wear on the brakes.
*
[GF11200(ALL)01/96]
When you come to a stop, do not downshift
through each gear. Disengage the clutch and use
the brake as necessary. Downshifting through
the gears decreases your vehicle's fuel economy.
File:09prgfp.ex
Update:Fri Jan 3 09:33:04 1997

156 [ER00700(ALL)01/96]
half page art:0032030-AHazard warning flasher switch
*
[ER00800(ALL)01/96]
If the Engine Cranks but Does
Not Start or Starting After a
Collision
*
[ER00850(ALL)01/96]
The Fuel Pump Shut-off Switch
*
[ER00900(ALL)05/96]
If the engine cranks but does not start or if you
have had a collision, the fuel pump shut-off
switch may have been triggered. The shut-off
switch is a device that stops the fuel pump
when your vehicle has been involved in a
substantial jolt.
*
[ER00910(ALL)03/96]
Once the shut-off switch is activated, you must
reset the switch by hand before you can start
your vehicle.
File:10prerp.ex
Update:Thu Jun 13 09:57:39 1996

225
*
[MC39910(ALL)03/96]
The driving modes required to reach the ready
condition consist of a minimum of 30 minutes of
city and highway driving as described below.
*
[MC39920(ALL)03/96]
q
20 minutes of driving in stop and go
city-type traffic with at least four idle periods.
*
[MC39930(ALL)03/96]
q
10 minutes of driving on an expressway or
highway
*
[MC39940(ALL)05/96]
Before completing the above driving modes, the
engine must be warmed up and at operating
temperature. Once started, the vehicle must not
be turned off during the above driving modes. If
the vehicle owner is unable to meet the I/M
requirements by using these driving patterns, an
authorized service center can perform a detailed
OBD II drive cycle as it would any other type of
repair work.
%
*
[MC42000(ALL)03/96]
Lights and Bulb Replacement
*
[MC42100(ALL)01/96]
It is a good idea to check the operation of the
following lights frequently:
*
[MC42200(ALL)01/96]
q
headlamps
*
[MC42400(ALL)01/96]
q
tail lamps
*
[MC42500(ALL)01/96]
q
brakelamps
*
[MC42600(ALL)01/96]
q
hazard flasher
*
[MC42700(ALL)01/96]
q
turn signals
*
[MC42800(ALL)01/96]
q
side markers
*
[MC42900(ALL)05/96]
q
license plate lamps
[MC43000(ALL)01/96]
q
fog lamps (GT model)
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996