1997 FORD F250 lights

72 %
*
[CF28000(FM)01/96]
High Beams
*
[CF28100(FM)01/96]
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
*
[CF28200(FM)01/96]
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
[CF28300(FM)04/96]
one third page art:0020074-B
Headlamp high beam switch and turn signal lever
%*
[CF28400(FM)01/96]
Flashing the Lights
*
[CF28500(FM)01/96]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
%
*
[CF28600(FM)01/96]
Windshield Wipers and Washer
*
[CF28700(FM)04/96]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[CF28800(FM)04/96]
Turn the knob on the end of the turn signal
lever toward the front of the vehicle. You can
turn it to either the LO or HI speed position.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

90
*
[CF65800(F )01/96]
Locking the doors with the remote entry
system
*
[CF66000(F )04/96]
To lock all the doors, press the LOCK control.
[CF66100(F )04/96]
If you would like a signal that the doors are
being locked, press the LOCK button again
within five seconds. The door will lock again,
the horn will beep, and the external lamps will
flash.
%*
[CF66200(F )01/96]
Remote entry personal alarm
*
[CF66300(F )01/96]
If you wish to activate the remote entry system
personal alarm, press the PANIC button. This
will honk the horn and flash the lights for
approximately 2 minutes 45 seconds. You can
turn it OFF by pressing the PANIC button again
from the same transmitter or by turning the
ignition to the ON or ACCESSORY position.
*
[CF66400(F )01/96]
When you use the remote entry UNLOCK or
PANIC buttons, the illuminated entry system
turns on the vehicle's interior lights for 25
seconds. You can turn these lights off with the
remote entry LOCK button or by turning the
ignition to the ON or ACCESSORY position.
*
[CF66500(F )01/96]
quarter page art:0060566-B
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

92
*
[CF67400(F )01/96]
quarter page art:0020790-A
Replacing the batteries
%*
[CF67500(F )01/96]
Replacing lost transmitters
*
[CF67600(F )01/96]
In the event a transmitter is lost, you should
take all your vehicle's transmitters to your
dealer to have the remote entry system
deprogrammed for the lost transmitter. This is
necessary to prevent further unauthorized use of
the lost transmitter.
*
[CF67700(F )01/96]
You can also purchase additional transmitters
(up to 4 transmitters can be used) from your
dealer. You will need to take all your
transmitters to the dealer so they can program
them to the remote entry system all at the same
time.
%*
[CF68000(F )01/96]
Illuminated Entry System (If equipped)
[CF68100(F )01/96]
This system will provide illumination of the
vehicle's interior courtesy lamps when either
outside front door handle is pulled or when the
Remote Entry System is used to unlock the door
or sound the Personal Alarm. The system will
automatically turn off after approximately 25
seconds or when the ignition is turned to the
START or ACCESSORY position.
[CF68200(F )04/96]
NOTE: The inside lights will not turn off if
you have turned them on with the
dimmer knob or if any door is open.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

93 % [CF68300(F )04/96]
Battery Saver (with Remote Entry Ð If
equipped)
[CF68400(F )04/96]
When the ignition is turned off, the vehicle will
turn off battery voltage to all of these lights after
45 minutes: glove box, engine compartment,
overhead console, mirror, courtesy and
interior (including cargo) lamps.
*
[CF68500(F )01/96]
This will prevent draining of the battery if these
lights have been left on inadvertently or if a
door is not completely closed. Battery voltage to
these lamps will be restored when the remote
entry transmitter is used, any door is opened, or
the ignition key is turned on again.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

138
[TO01000(FM)01/96]
Starting your vehicle
%*
[TO01100(FM)01/96]
Preparing to Start Your Vehicle
*
[TO01200(FM)02/96]
RWARNING
Do not start your vehicle in a closed
garage or in other enclosed areas. Exhaust
fumes can be toxic. Always open the
garage door before you start the engine.
*
[TO01300(FM)01/96]
Before you start your vehicle, do the following:
*
[TO01400(F )01/96]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[TO01600(FM)01/96]
2. Make sure the headlamps and other
accessories are turned off when starting.
*
[TO01700(F )01/96]
3.If you have an automatic transmission,
make sure that the gearshift lever is in P
(Park) and the parking brake is set before
you turn the key.
*
[TO01900(F )01/96]
4.If you have a manual transmission,make
sure that the parking brake is fully set, push
the clutch pedal to the floor, and put the
gearshift into Neutral before you turn the
key. (Remember, the starter will operate only
if the clutch pedal is pushed in all the way).
%*
[TO02000(F )01/96]
Testing the Warning Lights
*
[TO02100(F )02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
[TO02200(F )04/96]
If your Brake Warning Light does light up with
the key in the ON position, you may not have
fully released the parking brake or the brake
fluid may be low.
File:08lttof.ex
Update:Tue May 28 08:44:45 1996
ProCarManuals.com

166 [GF16050(F )04/96]NOTE: All transfer cases on F-350 4x4 trucks
are equipped with an opening for a
power take-off (PTO). If this opening
is used for a transfer case mounted
PTO, additional transfer case lubricant
is required. Refer to the Refill
Capacities section for lubricant fill
requirements. Vehicles equipped with
an E4OD automatic transmission and a
7.3L diesel engine will require exhaust
modification for PTO clearance. For
vehicles equipped with an E4OD
automatic transmission: If a transfer
case mounted PTO is operated with the
transfer case shift lever in neutral, a
Vehicle Speed Sensor Self-test error
may be set in the Powertrain Control
Module (PCM) causing the
transmission to function abnormally,
and the Transmission Control Indicator
Light (TCIL) may flash on and off
repeatedly. Normal transmission
function should return when the
transfer case has been engaged and the
vehicle is driven. If the TCIL continues
to flash or the transmission continues
to operate abnormally contact your
Ford dealer as soon as possible.
% [GF16100(F )04/96]
4x4 system indicator lights
[GF16150(F )04/96]
A 4x4 light and a LOW RANGE light are
located at the lower right of the instrument
cluster.
[GF16200(F )04/96]
q
2H position Ð Neither the 4X4 or the LOW
RANGE lights are lit.
[GF16250(F )04/96]
q
4H position Ð Only the 4x4 light is lit.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

167 [GF16300(F )04/96]
q
N position Ð Neither the 4x4 or LOW
RANGE lights are lit.
[GF16350(F )04/96]
q
4L position Ð Both the 4x4 and the LOW
RANGE lights are lit.
% [GF16400(F )04/96]
Lever Operated System With Automatic
Locking Hubs
*
[GF16450(F )01/96]
To shift from 2H to 4H:
[GF16500(F )04/96]
Stop the vehicle and move the transfer case shift
lever straight back to the 4H position, the
automatic locking hubs will engage when the
vehicle is driven. When the automatic locking
hubs are engaged, shifts between 2H and 4H
may take place at any speed.
[GF16550(F )04/96]
q
The automatic locking hubs may disengage in
2H if the vehicle's direction is momentarily
reversed, or the vehicle is allowed to roll
slightly in the opposite direction. If a
grinding noise occurs when shifting from 2H
to 4H while the vehicle is moving, one or
both of the automatic locking hubs have been
disengaged and the transfer case shift lever
should be switched back to the 2H position.
To shift back into 4H, stop the vehicle and
move the transfer case shift lever straight
back to the 4H position.
[GF16600(F )04/96]
q
When the vehicle is stopped while in 4H and
the vehicle's direction is reversed from the
previous direction, the automatic locking hubs
momentarily disengage and then re-engage.
The automatic locking hubs may click as they
automatically engage in the new direction.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com

169
case gets stuck in the N (neutral) position or is
difficult to shift into either 4H or 4L, it may be
necessary to let the vehicle roll slightly and/or
turn off the engine (particularly on vehicles
equipped with automatic transmissions).
[GF17050(F )04/96]
To shift into and out of N (neutral)
[GF17100(F )04/96]
To shift into N (neutral), stop the vehicle and
engage the parking brake. Place the automatic
transmission into NEUTRAL or depress the
clutch on manual transmission vehicles. From
either the 4H or 4L position, push the transfer
case shift knob down (toward the ground) and
at the same time move the transfer case shift
lever to the N (neutral) position. The N (neutral)
position should only be used for vehicle towing
or transfer case mounted PTO use (transfer case
PTO opening available on F-350 as an option).
[GF17200(F )04/96]
NOTE: Dash mounted four wheel drive
indicator lights are off when your
vehicle is in neutral.
[GF17250(F )04/96]
To shift from N (Neutral) to either 4H or 4L,
stop the vehicle and engage the parking brake.
Place the automatic transmission into NEUTRAL
or depress the clutch on manual transmission
vehicles. Push the transfer case knob down
(toward the ground) and at the same time move
the transfer case shift lever to the desired
position. If it is difficult to shift into either 4H or
4L, it may be necessary to let the vehicle roll
slightly and/or turn off the engine (particularly
on vehicles equipped with automatic
transmissions).
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com