1997 FORD E SERIES air condition

in the ON position and the engine
is off.
Transmission control indicator
light (TCIL)
The Transmission Control Indicator
Light (TCIL), which is located on
the gearshift lever, may flash
steadily if a malfunction is
detected. If the TCIL is flashing,
contact your Ford dealer as soon
as possible. If this condition
persists, damage to the
transmission could occur.
The word ªOFFº located on the
end of the gearshift lever is the
transmission control indicator light
(TCIL).
Safety belt
Illuminates when the ignition is
switched on to remind you to
fasten your safety belts. For more
information, refer toUsing the
safety restraints properlyin the
Seating and safety restraints
chapter.
Charging system
Briefly illuminates when the
ignition is turned on and the
engine is off. The light also
illuminates when the battery is not
charging properly, requiring
electrical system service.
Air bag readiness
Briefly illuminates when the
ignition is turned on. If the light
fails to illuminate, continues to
OVERDRIVE OFF
eco_trans_control_light
com_safety_belt.01
com_charging_system.01
com_air_bag.01
Instrumentation
9

²the headlamp system is in the
OFF or park lamp position
Audio System
For information on the audio
system, refer to theAudio Guide.
Power point electrical outlet
The power point is a power source
for the operation of electrical
accessories.
Do not use the cigarette lighter in
place of the power point.
CLIMATE CONTROLS
Your vehicle has one of the
following climate control systems:
²Manual heating system
²Manual heating and air
conditioning system
In addition your vehicle may also
be equipped with a auxiliary heater
and air conditioning system.
In some modes, the systems
function similarly; in modes where
the systems do not functioneco_audio_system
eco_power_point eco_climate_controls
Controls and features
17

Temperature
Turn the temperature control to
the desired mix of warm and cool
air (left for cooler and right for
warmer).
Controlling airflow
Turn the mode control to the
desired airflow position.
Using MAX A/C mode (if
equipped)
The MAX A/C mode recirculates
the air and directs it to flow
through the instrument panel
vents. The MAX A/C mode can be
used for air conditioning or
heating. This mode is noisier, but
more economical than A/C mode.
The MAX A/C mode only functions
if the outside temperature is above
10ÉC (50ÉF).
Select the OFF position for all
climate control functions to cease.
The outside inlet door will close
and the fan is shut off.
ARM COOL COOL
MAX
A C/
VENT
NORM
A C
/
OFF
FLR
MIX
eco_climate_airflow
eco_climate_max_acControls and features
19

Drive with the climate control
system on (either in heating or
A/C mode) to reduce humidity in
your vehicle.
Select MAX A/C for airflow
through these vents:
Using NORM A/C mode (if
equipped)
The NORM A/C mode directs
outside conditioned air to flow
through the instrument panel
vents. The NORM A/C mode can
be used for heating, ventilating or
air conditioning. The NORM A/C
mode only functions if the outside
temperature is above 10ÉC (50ÉF).
Select NORM A/C for air to flow
through these vents:
Using the vent mode
Select the VENT mode for air to
flow through these vents:
Using the floor mode
Select the FLOOR mode for air to
flow through these vents:
eco_climate_ac
eco_climate_panel_air
eco_climate_floor_air
eco_climate_def-flr_air
Controls and features
20

Using the mix mode
The MIX mode directs outside air
to flow through the floor vents and
windshield defroster vents. The air
conditioning will function to
dehumidify the windows provided
the outside temperature is above
10ÉC (50ÉF).
Select the MIX mode for air to flow
through these vents:
Using themode
In addition to defogging and
demisting, in defrost mode your
vehicle has the capability to demist
the front side windows. The air
conditioning will function to
dehumidify the windows provided
the outside temperature is above
10ÉC (50ÉF).
Select the
mode for air to flow
through these vents:
AUXILIARY HEATER AND AIR
CONDITIONER (IF EQUIPPED)
If your vehicle is equipped with a
factory installed auxiliary unit, the
front control panel will include
eco_climate_def_air
eco_climate_control_auxiliary
Controls and features
21

²one or more impact and safing
sensors,
²a readiness light and tone,
²driver and front passenger
safety belt buckle pretensioners
²and the electrical wiring which
connects the components.
The diagnostic module monitors its
own internal circuits and the
supplemental air bag electrical
system readiness (including the
impact sensors), the system wiring,
the air bag system readiness light,
the air bag back up power and the
air bag ignitors.
Determining if the system is
operational
The SRS uses a readiness light in
the instrument cluster or a tone to
indicate the condition of the
system. Refer to theAir bag
readinesssection in the
Instrumentationchapter. Routine
maintenance of the air bag is not
required.
A difficulty with the system is
indicated by one or more of the
following:
²The readiness light will either
flash or stay lit.
²The readiness light will not
illuminate immediately after
ignition is turned on.
²A group of five beeps will be
heard. The tone pattern will
repeat periodically until the
problem and light are repaired.
com_determing_operational.01
Seating and safety restraints
57

²the sound of the exhaust system
changes
²the vehicle has been damaged in
a collision
Important ventilating
information
If the engine is idling while the
vehicle is stopped in a closed area
for long periods of time, open the
windows at least 2.5 cm (1 in).
Adjust the heating or air
conditioning (if equipped) to bring
in fresh air.
Improve vehicle ventilation by
keeping all air inlet vents clear of
snow, leaves and other debris.
MAX
A C/
VENT
NORM
A C
/
OFF
FLR
MIX
eco_ventilation_info
Starting
79

hilly country or on hot days.
Speed control may shut off if you
are towing on very long, steep
grades.
When towing a trailer
If towing a trailer and your vehicle
is not equipped with the Ford
trailer tow package, an auxiliary
transmission fluid cooler is
recommended.
²Use D (Drive) rather than
D(Overdrive) while towing up
or down steep hills. This will
eliminate excessive downshifting
and upshifting for optimum fuel
economy and transmission
cooling.
²Anticipate stops and brake
gradually.
²Allow more room for stopping
with a trailer attached.
²Practice turning, stopping and
backing in an area before
starting on a trip to get the feel
of the vehicle/trailer
combination.
²When turning, drive slightly
beyond the normal turning point
so the trailer wheels will clear
curbs and other obstacles.
²When stopped in traffic for long
periods of time in hot weather,
place the gearshift in P (Park)
to increase idle speed. This aids
engine cooling and air
conditioner efficiency.
²Vehicles with trailers should not
be parked on a grade. If you
eco_when_towing
Driving
97