1997 FORD ASPIRE oil

5 %
*
[II05850(ALL)01/96]
Federal Highway Administration
Regulation
*
[II05875(ALL)01/96]
Regulations such as those issued by the Federal
Highway Administration or issued pursuant to
the Occupational Safety and Health Act (OSHA),
and/or state and local laws and regulations may
require additional equipment for the way you
intend to use the vehicle. It is the responsibility
of the registered owner to determine the
applicability of such laws and regulations to
your intended use for the vehicle, and to
arrange for the installation of required
equipment. Your Ford dealer has information
about the availability of many items of
equipment which may be ordered for your
vehicle.
%
*
[II06000(ALL)01/96]
Breaking Your Vehicle In
*
[II06100(ALL)01/96]
Your new vehicle goes through an adjustment or
break-in period during the first 1,000 miles
(1,600 km) that you drive it. During the break-in
period, you need to pay careful attention to how
you drive your vehicle.
%*
[II06300(ALL)01/96]
q
Avoid sudden stops.Because your vehicle
has new brake linings, you should take these
steps:
*
[II06400(ALL)01/96]
Ð Watch traffic carefully so that you can
anticipate when to stop.
*
[II06500(ALL)01/96]
Ð Begin braking well in advance.
*
[II06600(ALL)01/96]
Ð Apply the brakes gradually.
*
[II06700(ALL)01/96]
The break-in period for new brake linings
lasts for 100 miles (160 km) of city driving or
1,000 miles (1,600 km) of highway driving.
%*
[II06800(ALL)03/96]
q
Use only the type of engine oil that Ford
recommends.SeeEngine oil recommendations
in the Index. Do not use special ªbreak-inº
oils.
File:02iciif.ex
Update:Tue Mar 4 08:50:54 1997

11 %
*
[IS03200(ALL)01/96]
Charging System Light
*
[IS03300(ALL)04/96]
This light indicates that your battery is not being
charged and that you need to have the electrical
system checked.
[IS03400(ALL)01/96]
one inch art:0030172-C
Charging system light
*
[IS03500(ALL)03/96]
This light illuminates every time you turn the
ignition to the ON or START position (engine
off). The light should go off when the engine
starts and the alternator begins to charge.
*
[IS03550(ALL)03/96]
If the light stays on or illuminates when the
engine is running, have the electrical system
checked as soon as possible.
%*
[IS03615(ALL)01/96]
Engine Oil Pressure Warning Light
[IS03715(ALL)04/96]
This light indicates low oil pressure, not low oil
level. However, if the engine's oil level is low, it
could affect the oil pressure. This light
illuminates every time the ignition key is turned
to ON or START, but it normally turns off when
the engine starts.
[IS03800(ALL)01/96]
one inch art:0030173-C
Engine oil pressure light
File:03icisf.ex
Update:Tue Mar 4 08:51:24 1997

12 [IS03900(ALL)04/96]If the light stays on or illuminates while the
engine is running:
*
[IS04000(ALL)03/96]
1. Pull off the road as soon as safely possible.
[IS04100(ALL)01/96]
2.Shut off the engine immediately.Continued
operation could cause severe engine damage.
[IS04200(ALL)01/96]
3. Check the engine oil level. Make sure the car
is on level ground.
[IS04300(ALL)01/96]
4. Add oil to the full mark on the dipstick
before you drive your car again. Do not
overfill. Do not operate the engine when the
oil light is on. For more information about
adding oil, seeEngine oil recommendationsin
the Index.
[IS04350(ALL)01/96]
WARNING
Do not rely on the oil light to tell you
when the oil is low. Have the oil checked
often. It is possible for damage to occur if
an engine is operated with a low oil level.
%*
[IS04500(ALL)03/96]
High Beam Light
*
[IS04600(ALL)03/96]
This light illuminates when the headlamps are
turned to high beam or when you flash the
lights. If your vehicle is equipped with daytime
running lights and you have your headlamps on
your high beam telltale will not illuminate when
you flash the lights.
*
[IS04700(ALL)01/96]
one inch art:0030174-A
High beam light
File:03icisf.ex
Update:Tue Mar 4 08:51:24 1997

139 %
*
[ER12275(ALL)02/96]
WARNING
Applying too much pressure on the ends
when lifting a battery could cause acid to
spill. Lift the battery with a carrier or
with your hands on the opposite corners.
%*
[ER12280(ALL)02/96]
WARNING
Batteries contain sulfuric acid which burns
skin, eyes, and clothing.
*
[ER12285(ALL)02/96]
If the acid touches someone's skin, eyes, or
clothing, immediately flush the area with water
for at least 15 minutes. If someone swallows the
acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or
vegetable oil. Call a doctor immediately.
*
[ER12290(ALL)01/96]
WARNING
Do not push-start your vehicle. You could
damage the catalytic converter. For further
information, seeJumper Cablesin the
Index.
*
[ER12295(ALL)02/96]
To avoid damaging your vehicle or your battery,
and to avoid injury to yourself, follow these
directions for preparing your vehicle to
jump-start and connecting the jumper cables in
the order they are given. If in doubt, call for
road service.
%*
[ER12300(ALL)02/96]
Preparing Your Vehicle
*
[ER12305(ALL)02/96]
1. Your vehicle has a 12-volt starting system, so
you need to use a 12-volt jumper system.
You will damage your starting motor,
ignition system, and other electrical parts if
you connect them to a 24-volt power supply
(either two 12-volt batteries in series or a
24-volt generator set).
File:10icerf.ex
Update:Tue Mar 4 08:55:59 1997

149
%*
[MC05000(ALL)01/96]
Engine Oil Recommendations
*
[MC05050(ALL)01/96]
We recommend using Motorcraft oil or an
equivalent oil meeting Ford Specification
WSS-M2C153-F and displaying the American
Petroleum Institute CERTIFICATION MARK on
the front of the container.
*
[MC05100(ALL)01/96]
one third page art:0060021-E
The API Certification Mark
*
[MC05200(ALL)01/96]
Neveruse:
*
[MC05300(ALL)01/96]
q
ªNon-Detergentº oils
*
[MC05350(ALL)02/96]
q
Oils labeled API SA, SB, SC, SD, SE, SF or SG
%*
[MC05400(ALL)01/96]
q
Additional engine oil additives, oil treatments
or engine treatments
%*
[MC05500(ALL)01/96]
Engine oils with anSAE 5W-30viscosity are
PREFERREDfor your vehicle. They provide the
best engine performance, fuel economy and
engine protection for all climates down to-15ÊF
(-25ÊC).
%*
[MC05600(ALL)03/96]
Synthetic engine oils which are CERTIFIED and
of the preferred viscosity may be used in your
engine. The engine oil and oil filter must still be
changed according to the maintenance schedule.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

150
*
[MC05650(ALL)05/96]
NOTE: Ford production and aftermarket
(Motorcraft) oil filters are designed for
added engine protection and long life.
If a replacement oil filter is used that
does not meet Ford material and design
specifications, startup engine noises or
knock may be experienced. It is
recommended you use the appropriate
ªMotorcraftº oil filter (or another brand
meeting Ford specifications) for your
engine application.
%*
[MC05700(ALL)01/96]
Checking and Adding Engine Oil
*
[MC05800(ALL)01/96]
Since the proper amount of engine oil is
important for safe engine operation, check the oil
using the dipstick each time you put fuel in
your vehicle. Remember the engine must be off,
the oil must be warm and the vehicle must be
parked on level ground.
%*
[MC05900(ALL)01/96]
Checking the engine oil level:
*
[MC06000(ALL)01/96]
1. Turn the engine off after it has warmed up
and allow a few minutes for the engine oil
to drain back into the oil pan.
[MC06100(ALL)01/96]
2. Set the parking brake fully and make sure
the gearshift is securely latched in P (Park)
or 1 (First).
*
[MC06200(ALL)01/96]
3. Open the hood. Protect yourself from engine
heat.
[MC06300(ALL)01/96]
4. Locate the dipstick (highlighted in yellow)
and carefully pull it out of the engine.
*
[MC06400(ALL)01/96]
5. Wipe the dipstick clean and put it back into
position, making sure it is fully seated.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

151 [MC06500(ALL)01/96]
quarter page art:0032227-B
Engine oil dipstick
[MC06600(ALL)01/96]
6. Carefully pull the dipstick out again. If the
oil level is at or below the ªLº line, add
engine oil as necessary. If the oil level is
beyond the letter ªFº, engine damage or
high oil consumption may occur and some
oil must be removed from the engine.
[MC06700(ALL)04/96]
NOTE: The distance between the L (low) and
F (full) marks on the dipstick
represents 1.06 qts (1.0 liter).
*
[MC06800(ALL)01/96]
7. Put the dipstick back in and make sure it is
fully seated.
*
[MC06900(ALL)01/96]
It may be necessary to add some oil between oil
changes. Make sure you use a CERTIFIED
engine oil of the preferred viscosity. Your
vehicle's warranty coverage may not apply if
engine damage is caused by the use of improper
engine oil.
*
[MC07000(ALL)09/96]
Add engine oil through the oil filler cap
highlighted in yellow. To add oil, remove the
filler cap and use a funnel to pour oil into the
opening. Be careful not to overfill the engine.
Recheck the oil level after you finish adding oil.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

152 %
*
[MC07100(ALL)01/96]
Changing the Engine Oil and the Oil Filter
*
[MC07200(ALL)01/96]
Change the engine oil and oil filterper the
following, whichever occurs first.
*
[MC07300(ALL)05/96]
one third page art:0060618-C
Oil change intervals
*
[MC07400(ALL)05/96]
Refer to theMaintenance Schedulebooklet for
additional information.
%*
[MC07500(ALL)05/96]
NOTE: Always dispose of used automotive
fluids in a responsible manner. Follow
your community's standards for
disposing of these types of fluids. Call
your local recycling center to find out
about recycling automotive fluids.
*
[MC07600(ALL)01/96]
WARNING
Continuous contact with USED motor oil
has caused cancer in laboratory mice.
*
[MC07700(ALL)01/96]
Protect your skin by washing with soap and
water.
%
*
[MC17282(ALL)05/96]
Brake Fluid
*
[MC17284(ALL)01/96]
Under normal circumstances, your vehicle
should not use up brake fluid rapidly. However,
expect the level of the brake fluid to slowly fall
as you put more mileage on your vehicle and
the brake pads wear.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997