1997 FORD ASPIRE child lock

53
%*
[CF40900(ALL)02/96]
Doors
[CF41800(ALL)04/96]
Childproof Locks for the Rear Doors
(If equipped)
[CF41900(ALL)01/96]
In addition to standard locks, your vehicle has
childproof locks for the rear doors. If you set
these locks, the rear doors cannot be opened
from the inside of the vehicle. The doors can still
be opened from the outside when the lock knobs
are raised.
[CF42000(ALL)01/96]
half page art:0032223-A
Child lock levers for the rear doors
*
[CF42100(ALL)01/96]
To set the childproof lock on each rear door,
open the rear door.
*
[CF42200(ALL)01/96]
Find the lever at the black label with the word
LOCKED in white letters. Move the lever up.
*
[CF42300(ALL)04/96]
To release the childproof lock, open the rear
door from the outside and move the lever down.
File:05iccff.ex
Update:Tue Mar 4 08:52:57 1997

57
Seating and Safety
Restraints
%*
[SS00250(ALL)05/96]
Seats
*
[SS00255(ALL)05/96]
WARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
*
[SS00260(ALL)02/96]
WARNING
Always drive and ride with your seatback
upright and the lap belt snug and low
across the hips.
*
[SS00265(ALL)02/96]
WARNING
Children should always ride with the
seatback in the fully upright position.
*
[SS00270(ALL)01/96]
Adjusting the Seats
*
[SS00275(ALL)01/96]
In the front seats, you can move the whole seat
forward or backward or tilt the back of the seat
forward or backward.
*
[SS00280(ALL)08/95]
To move the seat forward or backward:
[SS00285(ALL)01/96]
1. Make sure nothing is placed under the front
seats. Such items may interfere with the seat
lock mechanism.
[SS00290(ALL)01/96]
2. Find the seat slide adjustment lever located
on the outside of the seat.
[SS00295(ALL)01/96]
3. Pull the lever up and hold it.
[SS00300(ALL)01/96]
4. Slide the seat to the position you desire.
[SS00305(ALL)01/96]
5. Release the lever and make sure the seat has
locked in place.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

64
*
[SS02200(ALL)05/96]
WARNING
Each seating position in your vehicle has a
specific safety belt assembly which is
made up of one buckle and one tongue
that are designed to be used as a pair. 1)
Use the shoulder belt on the outside
shoulder only. Never wear the shoulder
belt under the arm. 2) Never swing it
around your neck over the inside
shoulder. 3) Never use a single belt for
more than one person.
*
[SS02400(ALL)01/96]
WARNING
Never drive or ride with a twisted or
jammed safety belt. If you cannot untwist
or unjam the safety belt, see the nearest
qualified technician immediately.
*
[SS02800(ALL)02/96]
WARNING
Children should always ride with the
seatback in the fully upright position.
*
[SS02825(ALL)02/96]
WARNING
Never let a passenger hold a child on his
or her lap while the vehicle is moving.
The passenger cannot protect the child
from injury in a collision.
*
[SS02850(ALL)02/96]
WARNING
Lock the doors of your vehicle before
driving to lessen the risk of the door
coming open in a collision.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

67 %
*
[SS09370(ALL)02/96]
Automatic locking mode
*
[SS09380(ALL)01/96]
In this operating mode, the shoulder belt
retractor will be automatically locked and will
remain locked when the combination
lap/shoulder safety belt is buckled, and does not
allow the occupant freedom of movement. This
mode provides the following:
*
[SS09390(ALL)01/96]
q
A tight lap/shoulder belt on the occupant.
*
[SS09400(ALL)01/96]
q
Child safety seat installation.
*
[SS09410(ALL)05/96]
WARNING
Rear-facing child seats or infant carriers
should never be placed in the front seats.
*
[SS09420(ALL)01/96]
This modemust be usedwhen installing a child
safety seat on the front passenger seat and rear
outboard seats where dual locking retractors are
provided.
*
[SS09430(ALL)01/96]
To switch the retractor from the emergency
locking mode to the automatic locking mode,
perform the following steps:
*
[SS09440(ALL)02/96]
1. Buckle the lap/shoulder combination belt.
*
[SS09450(ALL)01/96]
2. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted and, when allowed to retract, a
clicking sound is heard. At this time, the belt
retractor is in the automatic locking mode
(child restraint mode).
*
[SS09460(ALL)02/96]
3. A clicking sound will continue to be heard
as the belt is allowed to retract. This
indicates that the retractor is in the
automatic locking mode.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

68
*
[SS09470(ALL)02/96]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
%*
[SS09475(ALL)02/96]
Safety Belt Extension Assembly
*
[SS09478(ALL)01/96]
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
*
[SS09482(ALL)02/96]
WARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
%
*
[SS09484(ALL)03/96]
Safety Belt Maintenance
*
[SS09486(ALL)02/96]
Check the safety belt systems periodically to
make sure that they work properly and are not
damaged.
%*
[SS09488(ALL)05/96]
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if equipped), shoulder belt height
adjusters (if equipped), child safety seat tether
bracket assemblies (if equipped), and attaching
hardware, should be inspected after any
collision. Ford recommends that all safety belt
assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

77
*
[SS15700(ALL)01/96]
WARNING
Safety belts and seats can become hot in a
vehicle that has been closed up in sunny
weather; they could burn a small child.
Check seat covers and buckles before you
place a child anywhere near them.
*
[SS15800(ALL)03/96]
WARNING
Do not leave children, unreliable adults,
or pets unattended in your vehicle.
%*
[SS16500(ALL)01/96]
Safety Seats for Children
*
[SS16600(ALL)01/96]
Use a safety seat that is recommended for the
size and weight of the child. Always follow the
safety seat manufacturer's instructions when
installing and using the safety seat.
*
[SS16620(ALL)01/96]
Ford recommends the use of a child safety seat
having a top tether strap. Install the child safety
seat in a seating position which is capable of
providing a tether anchorage. For more
information on top tether straps seeAttaching
Safety Seats With Tether Strapsin this chapter.
*
[SS16640(ALL)05/96]
When installing a child safety seat, be sure to
use the correct safety belt buckle for that seating
position, and make sure the tongue is securely
fastened in the buckle. For a shoulder/lap belt
combination with a sliding tongue, make sure
the retractor is in the automatic locking mode.
*
[SS16649(ALL)03/96]
Your vehicle is equipped with a right front
passenger air bag. Air bags deploy with great
force, faster than the blink of an eye. Front
passengers, especially children and small adults,
must never sit on the front edge of the seat,
stand near the glove compartment of the
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

79
*
[SS16940(ALL)05/96]
WARNING
Always keep the buckle release button
pointing upward and away from the child
seat, with the tongue between the child
seat and the release button as shown in
the following illustration.
[SS16960(ALL)01/96]
half page art:0032255-B
Safety belt buckle placement for child seats
[SS16980(ALL)01/96]
Using the Dual Locking Mode Retractor
When Installing a Child Safety Seat
*
[SS17000(ALL)02/96]
Your vehicle is equipped with a dual locking
mode retractor on the shoulder belt portion of
the front passenger seat and both rear seats. The
automatic locking modemust be usedwhen
installing a child seat or infant carrier in the
front passenger seat or rear seats.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997

83
*
[SS17225(ALL)01/96]
4. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted and a click is heard. At this time,
the retractor is in the automatic locking
mode (child seat restraint mode). See
Figure 4.
[SS17275(ALL)01/96]
half page art:0032271-A
Setting the retractor to automatic locking mode
*
[SS17280(ALL)02/96]
5. Allow the belt to retract. Pull up on the
shoulder webbing. A clicking sound will be
heard as the belt retracts. This indicates the
retractor is in the automatic locking mode.
Push down on the child seat while you pull
up on the belt to remove any slack in the
belt. See Figures 5 and 6.
File:06icssf.ex
Update:Tue Mar 4 08:54:10 1997